Question about 2003 Chevrolet Avalanche

1 Answer

Do I have to take out the door panel to replace door speakers?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that gotĀ 5 achievements.

    Master:

    An expert who has achieved Level 3.

    Sergeant:

    An expert that hasĀ over 500 points.

  • Master
  • 461 Answers

If you want it dont rite .or you can mopunt it outside of the door panel if you like

Posted on Mar 13, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace rear door speakers for 1997 GMC jimmy


I think your GMC have in-door rear speakers.!!
  • Look for screws in door panel or around the speaker vents.
  • If you are sure that the speaker cant be removed without opening the door panel then read this below.
  • Mostly seen near areas like door lever(inside), power window switch set, bottom and each sides of the whole panel.
  • If its manual window, then look for a circle clip in between the winding window lever and the door panel. Plunge screw driver between them a make a gap then look.
  • Assure that all clips or screws which obstacles the removal of the panel.
  • Simply pull the panel from sides towards you
  • If its completely open, then locate the speaker and unscrew it.
  • Check the connection wires for quality
  • Mostly its good to scratch the leads of the wire to remove copper oxide layer
  • Take the new speaker, check the holes on the door matching the speaker's
  • If needed, drill hole for screw and be sure that the new speaker is not more than 15cm diameter.
  • Connect the leads, fix the speakers.
  • Check the sound clarity with your car audio on.
  • If everything is perfect.. go on , fix the door panels
  • Mainly sure with the side clips of the panel, do not bent or break them.
  • Check for any balance parts or screws.
  • Screw everything back as normal.
  • You just installed a new speaker....
  • pls rate it!!

Sep 23, 2011 | 1997 GMC Jimmy

1 Answer

Replace front speakers


You would have to open the door panel to replace front speakers. Look for any screws around the door handle. look at the whole door panel for any screws so that you may remove the panel in order to reach the speakers. once the panel is free from any visible screws, use a door panel remover ($5-10) and use it to pry off the panel, use it around the door panel push-in connectors, and don't use extreme force, may break connectors. once the connectors around the whole panel are removed. make sure your window is down before the whole procedure. then pick up the panel from the bottom (push up), then the panel should be off the door, if you want to change the speakers, you don't need to take any of the wiring to the window/door lock. simply remove the cover if any over the stock speakers, usually some screws. once the cover/screws are off. the speaker should come off. You will see two wires off the speakers (the red(positive) the black(negative)), once the stock speaker is removed, simply attatch the new speaker to the wires. make sure the negative and positive from the car DO NOT TOUCH, you WILL short circuit and blow a fuse, maybe worse, and it's not worth the time fixing. hope this helps, good luck.

Jun 12, 2011 | 2004 Volkswagen Beetle

1 Answer

Need instructions to replace the passenger side mirror and the driver side tail light on a 1999 Ford Taurus 4-door sedan. Thank you, Gary S.


Section 01-09: Mirrors, Rear View 1999 Taurus/Sable Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 06/25/1998 Mirror, Power-Outside Rear View Removal
  1. Disconnect battery ground cable (14301).
  1. Remove front door trim panel (23942). Refer to Section 01-05.
  1. Remove radio speaker grille from cover assembly by squeezing or pinching between thumb and index finger.
  1. Remove two screws from cover assembly.
  1. Disconnect outside rearview mirror wiring connector (C515-LH; C615-RH). Remove wiring guides as necessary.
  1. Remove three outside rear view mirror retaining nuts. Remove outside rear view mirror (17682) while guiding wiring and connector through hole in door.


an0786b.gif


Item Part Number Description 1 17682 Outside Rear View Mirror 2 N621906-S36 Nut (3 Req'd) 3 F8DB-17D699-
AAW Cover Assembly Rear Substrate-LH 3 F8DB-17D698-
AAW Cover Assembly Rear Substrate-RH 4 N808968 Screw 5 F8DB-18B984-
AAW Speaker Grille-Standard (No Badge)-LH 5 F8DB-18985-
AAW Speaker Grille-Standard (No Badge)-RH 5 F8DB-18K901-
BAW Speaker Grille-Mach-LH 5 F8DB-18978-
BAW Speaker Grille-Mach-RH 5 F8DB-238A35-
AAW Speaker Grille-Blank (No Speaker)-LH 5 F8DB-238A34-
AAW Speaker Grille-Blank (No Speaker)-RH A - Tighten to 6-8 Nm (54-70 lb-in) ------------------
Trim Panel, Door Front
Removal
  1. Remove cover behind inside door handle.
  1. Remove screw from bottom of pull cup retaining front door trim panel to front door (20124).
  1. Remove three screws retaining front door trim panel to front door.
  1. NOTE: Do not attempt to remove more than one pushpin at a time.

    Using Rotunda Windshield and Molding Trim Removal Kit 107-R0401 or equivalent, remove the door trim panel by pulling one door trim panel pushpin at a time from the inner door skin.
  1. Disconnect electrical connectors as necessary. Refer to Section 01-14A.
Installation
  1. Follow removal procedure in reverse order.
  1. Replace all pushpins with new pushpins (N808994-S).
Front Door Trim Panel


ar0318d.gif

Jan 14, 2011 | 1999 Ford Taurus

1 Answer

Can I pull the grill off the speakers to put them


NO' YOU DONT NEED TO REMOVE THE ENTIRE DOOR PANEL, TO REPLACE SPEAKERS CONNECT WIRING CONNECTOR TO SPEAKER FIT SPEAKER BACK IN GRILLE AND REPLACE RETAINING SCREWS.

Oct 26, 2009 | 2002 GMC Sierra 1500

1 Answer

Replacing door speakers in a mercury tracer


first remove any screws in door panel, then remove lock and window controls, then take flathead screw driver and SLOWLY pry panel off door. You now will have access to speaker. Speaker is held by 4 screws and wire harness that unclips.
Reverse procedure to reinstall. Door panel pops back in the wholes to reattach

Jun 27, 2009 | 1994 Mercury Cougar

1 Answer

Want to install after market speakers in 06 Chevy Cobalt...


they make a tool V-shaped that should be used for prying around the door panel..door airbags should not be triggered unless wiring for them is shorted, replacing speakers should not mess up any other wiring , fuses should be fine as are..

Jun 02, 2009 | 2006 Chevrolet Cobalt

1 Answer

1994 toyota camry door speaker replacement


Does speaker have an external cover on it, on the outside of door panel? if yes, remove it and speaker porobaly has screws holding it in door. if no, just slots/smalll holes, cut in panel & speaker is concealed behind panel, then the panel will have to come off. Once you get to the speaker it's relatively easy from there.

Mar 13, 2009 | 1994 Toyota Camry

1 Answer

How do you replace the front door speakers in a 1999 Model Hyundai Excel?


You have to take the door panels off.
The front speakers are 6"
So remove the front door panels, unbolt the factory speakers, bolt the new one in the existing holes, reinstall the door panels.
The grills will look factory, but you will have better speakers. Nice way to keep the good stuff hidden from prying eyes.

Oct 19, 2008 | 1994 Hyundai Excel

1 Answer

Replacing front door speakers


You need to pull the door panel to get to the speaker. It is bolted to the door shell, not the door panel.

Sep 18, 2008 | 1996 Toyota Avalon

1 Answer

Speaker Replacement


There should be at least 2 screws that are hiden in the door panel. One around the arm rest and the other down by the light/reflector.
Take those out and the panel should lift up. Becareful there will be a ton of wires that are attached to the door. Disconnect each of these and the panel will be free to remove.
You should have access to the speaker at this time.

Jul 25, 2008 | 2001 Dodge Neon

Not finding what you are looking for?
2003 Chevrolet Avalanche Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...