Question about 2000 Jeep Grand Cherokee

2 Answers

How long does it take for the computer to reset so i can get an emmission check? 2002 grand ch. limited. ive heard up to a week, but was looking for anouther opinion. thank you.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Jeep Master
  • 1,311 Answers

It is typically 10 drive cycles and could take anywhere from 2 to 5 days depending on the type of driving you do. Try to take the car on the highway for a few miles, get off the highway, shut it down for a while, then do some local street driving.

Posted on Mar 16, 2011

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

All my dashboard lights comes on and all my guages drops all the way down......what causes this I have a 2000 jeep Cherokee......

Posted on Apr 25, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Buick regal drive cycle instructions


If you had a emissions problem and it has been corrected and the check light is out, then it should be cleared after 200 miles.Or will just show is a inactive fault

Jan 08, 2015 | 2003 Buick Regal

1 Answer

Anyone has a grand prix with monitors incomplete for an emmissions test


drive at a steady 50mph for about 10miles after a cold am srart

Jul 13, 2012 | Cars & Trucks

1 Answer

How do you reset the computer so it can go through emmissions.


I would veture a guess the failure is an emission code problem and the conditions for the failed problem are not met. Make sure the fuel level is just below 3/4 full. That will allow the emissions tests to run. You can also disconnect the battery cable for 10 minutes and that will reset the fault counter.

Nov 18, 2011 | 2002 Pontiac Grand Prix

2 Answers

2001 Pontiac Grand Am


you probaly have a small pin hole in the evap system somewhere. Mechanics usually wont try to fix this problem because its a pain in rear end to locate the leak. This problem should not effect the performance of the car

Apr 14, 2010 | 2001 Pontiac Grand Am SE

1 Answer

Engine light on. car runs perfectly. emmission good


if this is the check engine light, it probably needs reset. What you do is take the positive cable off the battery, lay it aside so it doesn't touch the terminal, go inside your vehicle and turn the ignition on and completely off (3) times, put switch back in normal off position, reinstall positive battery cable to battery and this should reset your computer

Nov 11, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Very rough idle on 2002 Jeep Grand Cherokee Limited Edition V8


If you haven't changed the plugs or had the fuel system cleaned, now would be a good time to do it. The number 1 culprit for rough idles is dirty injectors or plugs. You can try an injector cleaner in a can (or bottle) for under $10 and see if it helps, and then work from there. If there isn't any improvement then if you are able to, check the plugs for any gunky buildup and if you find a bad plug, make sure you replace them all (or have them replaced) at the same time.

Aug 03, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Check engine light sensors have been reset but don't show a reading


U will need to drive a mixture of stop and go, city low speed and freeway miles, this can take a week and 20-50 miles or so for the system to finish it's internal self testing. this is called a drive cycle test.

May 27, 2009 | 2002 Dodge Durango

1 Answer

Check engine light will not turn off on my 2001pontiac grand am


take battery cables off and put back on. should reset

Apr 21, 2009 | 2001 Pontiac Grand Am SE

1 Answer

Starts up fine, then dies ...


check o2 sensers and ground wire to them make sure its no corroded if you have v8 engine the groud is under ac unit.

Mar 01, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Engine / emission light and burned out alternator


Oxygen sensor might be faulty, as it causes the light to come on, but injectors hardly causes the light to come on, alternator( battery) light is an indication that the alternator needs to be replaced.

Nov 14, 2008 | 2005 Chrysler PT Cruiser

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

589 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...