Question about 2008 Toyota Yaris Sedan

Open Question

My Toyota Yaris sometime does not want to accelerate and feel if it has no power. Feel like it not getting fuel or the throttle sensor is not responding

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: 2009 Toyota Camry problems

All Toyota auto trans cars downshift when descending a hill when you tap the brake. This is called "Downhill Shift Logic"; what this is for is to eliminate the double shift when you come to the bottom of a hill and then accelerate. Normal condition. Usually happens above 38 MPH.
Also: The cruise will accelerate when going uphill. Normal condition.Plus: The cruise will not disengage back to the set MPH after you top the hill. Toyota recommends to disengage the cruise when encountering steep terrain.

Posted on Sep 09, 2008

  • 8 Answers

SOURCE: jerking problem

Morganoffat,
I'm not a mechanic but I have 15 years in the parts business. From what you say I will point you into the direction I beleive your problem is. I would check your throttle control. follow the air intake to the engine intake manifold. in that area you will find what is called a "throttle position sensor". it is activated be the postion of the "gas pedal" it work alittle like a reostat switch. not much you can do with it other than checking ohm redings at differnt positions or replaceing it. Good Luck

Posted on Nov 11, 2008

  • 651 Answers

SOURCE: Hesitation upon acceleration

check your air filter, fuel filter and vacuum lines.

Posted on Feb 08, 2009

polarcycle
  • 1392 Answers

SOURCE: toyota yaris brakes how do you bleed the brakes on a toyota yaris

have someone pump the pedal and hold it, then you work from the right rear, left rear, right front, left front, while the person pumps and holds several times at each wheel.

Posted on Jun 10, 2009

GARYca
  • 672 Answers

SOURCE: No spark, 1988 Toyota Camry 3SFE 4cyl, 5 speed.

there is no crank sensor on this vehicles 2.0L. If you have power to the coil, new coil, cap and rotor try this if not done yet>>>Unplug coil power first....Try pulling off the distributor cap, and make sure the rotor is spinning with the cam...If this fails to spin, inspect the entire distributor assembly. If it passes, Inspect all the power circuit and wiring to the dist assembly, if ok possible ecu. i recommend having a mechanic check it out!! Hopefully this helps...please rate...thanks

Posted on Aug 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1992 Toyota 4runner v6 while accelerating will build pressure I can feel in the gas pedal, then backfiring if I continue to accelerate. Sometimes I can avoid backfire by pushing clutch and shifting up...


Check the fuel pressure, and then see where youre at and if it is restricted from the pump or filter.
Next, try to see if you can get any codes out of the SUV. CEL can store any issues for quite some time, and it could be the MAF sensor, as that is very common with these.
I would also check into timing, it could be a few teeth off, pumping cylinders with fuel when they should be firing and causing this. And that is not good. At All.

Mar 18, 2015 | 1992 Toyota 4Runner

1 Answer

How to determine if a variable timing control solenoid is damaged from being jammed by gauze filter


Assuming there's a sensor to the control solenoid, the sensor would've sent a trouble code to the ECM, activating your "check engine" light. When you accelerate, it increases pressure in fuel lines, so if there's restriction (such as dirty fuel filter) in fuel line, then it would accelerate rough with hesitation in throttle response.

Nov 29, 2013 | 2000 Jaguar S-Type

1 Answer

To start, I coded my engine and got P0171 - Bank 1 System too Lean. From a stop, when I start out I have a sputter. I push the pedal more & there is no engine rev, and no acceleration. Then the engine...


i have had that problem before its most likely a dirty throttle body or a bad throttle position sensor or air idle control sensor some times cleaning the sensors will work before changing them

Aug 10, 2013 | 2000 Chevrolet Prizm

1 Answer

My 2004 avalanche accelerator pedal don't do anything


Replace the T.P.S. sensor." throttle position sensor"

Feb 06, 2013 | Chevrolet Avalanche Cars & Trucks

1 Answer

2007 yaris 90,000ks. While idling the car starts shuttering randomly and the rpm goes up and down as my foot is on the break. Sometimes the engine revs by itself and the car returns to normal but it has...


Check the following for:
- Vacuum leak.
- Intake manifold gasket/ seal leak.
- Throttle body seal leak.
- Check Valve clearance.
- Electronic throttle control system.
- ECM power source circuit.

Dec 29, 2011 | 2007 Toyota Yaris

1 Answer

Manual for toyota yaris 2009




  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.


Regards, Tony

Oct 11, 2011 | 2007 Toyota Yaris

2 Answers

Toyota Vitz 2003: (ABS and HandBrake warning light constantly on)


this is a common first sign of your antilock brake computer failing. You will most likely never feel a difference in your car but there is a slight chance all your safety features will not operate properly in a collision.

Jun 09, 2009 | 2007 Toyota Yaris

3 Answers

VITZ 2006 AUTO WITH CODE P1589


p1589 acceleration sensor learning value how fix problems

Apr 11, 2009 | 2007 Toyota Yaris

1 Answer

RODEO 99 ECM PROBLEM


that can happen for several reasons the least being the ecm. first thing is it could be a weak fuel pumpand the only way to check this is with a fuel pressure gauge. it should be between 17 and 25 psi. next it could be the TPS(throttle position sensor) this controls your idle. this is located on the throttle body has a weatherproof plug and is held with (2) screws . next is the engine speed sensor this helps the ecm adjust the fuel/air mixture in conjunction with the TPS,IAC valve,O2 sensor<and the egr valve. to pinpoint the sensor problem you have to have a diagnostic scan done. please rate this.......thanks

Sep 23, 2008 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...