Question about Chrysler Town & Country

Open Question

1998 chrysler town and country. passanger side parking lights will not turn on and now the headlights turn on as soon as i open the door. didnt do that before! please help. i have replaced bulbs

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 422 Answers

SOURCE: how to remove & clean headlight/foglight cover on

autozone has a chemical called blue magic that works pretty well, just use some really fine sandpaper and buff it with some blue majuc

Posted on Mar 26, 2009

  • 1130 Answers

SOURCE: Left low beam headlight on Chrysler 2003 T&C wont work while engine is on

Ill guarantee you have an electrical short on the left side of the headlight switch,circuit.From here its immpossible for me to go any further.Good Luck.,Get A Wiring diagram.

Posted on Apr 18, 2009

  • 1348 Answers

SOURCE: Describe your 2005 Chrysler Town &

check the bulbs do not have fractured filaments,and check the headlamp relay.check the sockets for corrosion and if all that checks out ok check the connection on the back of the headlight switch and the daytime running light module

Posted on Aug 15, 2009

  • 3 Answers


I had the same problem on my 07 and it turned out to be caused by the bulbs getting too hot and melting the surrounding plastic which opened the circuit powering them. I was able to fix the problem by removing the bulbs and cleaning the sockets allowing the bulbs to seat correctly. The lenses snap off to give you access to the bulbs. If you are not familiar with how interiors of cars come apart, I would not suggest doing it as you may crack the lens.

Posted on Oct 13, 2009

  • 1986 Answers

SOURCE: how to replace our low beam headlight on 1999 town and country

1.) Open the hood of your van 2.) On the passenger side of the vehicle, look behind the headlight enclosure. You will see a set of wires running into the back of it. This is the power clip. Either with your hand or a flat-head screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful not to touch the glass part of the new bulb. The oils in your skin can substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1998 Chyrsler Town and Country Anti Theft system won't disarm

1St make sure your using the same key you always do not your spare or something that was cut new. also read your book on security usually there is a period of leaving the key in the ignition for so long so it will recognize this is the right key.

Jun 26, 2014 | 1998 Chrysler Town & Country

1 Answer

Parking lights stay on

Great news I just got a letter from Chrysler corp, saying that there is a warranty extension or recall on some 2005 & 2006 Chrysler Town & Country for a headlight / parking light issue , it states that if a problem arises with the headlights or parking lights it is most likely a faulty switch and that Chrysler will replace it for free , My suggestion is is to call or stop in at your nearest Chrysler dealership's service dept. and check to see ( and verify) if your vehicle's problem would be covered under this particular warranty.

Mar 09, 2013 | 2006 Chrysler Town & Country

1 Answer

How to change the headlight on a 1998 chrysler

One screw on top and two nuts on the back ,then you can take the whole headlight housing out.

Jan 02, 2010 | 1998 Chrysler Town & Country

2 Answers

Security alarm on so car won't start

Try locking/unlocking the passenger door with the key into the door lock to reset the alarm system. If the passenger side doesn't work, then try the driver side. Good luck.

Sep 29, 2009 | 1998 Chrysler Town & Country

1 Answer

Codes - U0140, U0155, U110C

2005 town and country code U110C this problem?

Sep 23, 2009 | 2005 Chrysler Town & Country

1 Answer

Power slider's open or close part of the way and then open or close on there own

Are you parked on a level surface when this happens? I have a 2008 town and country and I have noticed that the doors are hyper sensitive… If I park on an incline my doors also behave as you have described. My solution is to try to park on level surfaces.

Apr 15, 2009 | 2008 Chrysler Town & Country

1 Answer

Door closed but door ajar comes on

There is a switch or sensor on the door frame either on the hinch side or on the latch side. Try to activate it with the the car on. With the door open, the door open light should light on, if it is a mechanical switch, push it in, if a sensor, touch it with a steel object, the light should turn off. This means the door switch is working ok. Now try the same again but this time push the switch slowly until the door ajar warning light turns on. This means that the switch works ok. Now, close the door from outside and check that there is no gap betwwen the body and the door line all over the perimeter of it. If there is a gap mainly at the latch side or at the hinch side, it can be your problem. If so, let me know so I can show you how to adjust the door to eliminate the gap.
If there is no gaps, your door switch is to low (too far in), let me know so I can show you how to adjust it.

Jan 15, 2009 | 1998 Chrysler Town & Country

1 Answer

Passanger side elctric door

sounds like your solenoid is wearing out or wiring connections need cleaning refer to repair manual from either haynes or chiltons and under electrical section follow instructions on testing also I noticed when I had similar problems with customers it actually helped to change the batteries in the remote unit itself but not always, alot of times I had to either clean or replace solenoids

Dec 24, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides