Question about 1998 Mercedes-Benz C-Class
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: skoda octavia 1.9 tdi
try the intercooler pipes next to the turbo i had an a4 tdi and that done the same thing lots and lots of smoke and very little power .cheap repair and won't take all your day off let me know if that helps
Posted on Oct 01, 2008
problem one is the timer control for the heaters ,also check the heaters that they are working ,oil problem ? look under the rubber boot that goes over the oil switch ,pull it back and if oil under the cover renew the oil switch,these motors do suffer from heater light flashing on and i know people have spent megabucks trying to cure it ,its a fault with dash and printed circuits ,but the heaters are not coming on i know because i have driven one with the heater circuit light coming on and i had a extended light on a long wire and the heaters are not coming on ,ignore it just renew the faulty glow plugs,as for EGR valve just pull teh vacumn pipe off the ERG valve and leave disconnect ,more hassle than its worth changing it ,you could end up with a ECU computer .Still a nice reliable motor though and economical
Posted on Jan 21, 2010
Testimonial: "Thanks for your usefull answer. Afer I stop the engine 2 times from EGR valve, both board alarms have been reseted. What does it mean? Thanks again."
I have no idea what a skoda octavia is, but I know brakes are brakes. You have 2 bolts holding the pads in a slide, the bolts have threads only at the top, the rest is the slide, pull those bolts, if that doesn't release the slide, take out the 2 bolts holding the caliper on there, pull the slide out the other way. replace the pads, make sure they go back in the way came out. Put the bolts back on, tighten them up, you should be all set. The pad thickness sensor is just a ground, when the wire hits metal, it turns on a light, It should go off when it is not touching anything. You should have squealers on there too, they give an audible screech telling you it is time for some new pads. Hope this helps.
Posted on Apr 26, 2010
Tips for a great answer:
Jun 12, 2017 | Skoda Cars & Trucks
Feb 17, 2016 | Skoda Cars & Trucks
Oct 21, 2013 | Skoda Octavia Cars & Trucks
Jan 02, 2013 | 2008 Skoda Octavia 1.9
Dec 30, 2012 | 2005 Skoda Octavia 1.4
May 15, 2012 | Skoda Octavia Cars & Trucks
383 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: