Question about Chevrolet 1500

1 Answer

How high can your truck legally be lifted off the ground in sandiego califonia

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 417 Answers

Hi,

call the non emergency police line for that area, since theyre the ones that hand the tickets out they would have to know.

J

Posted on Aug 01, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I can adjust the low beam on my 2010 Impala but I can't adjust the high beam


low beam and high beam is in the one setting unless you have separate headlights
procedure is to place the car on level ground 3 feet from a wall that reflects the head light
draw a cross on the wall at the height of the center of head light lens
switch on the head lights (high beam)and you will see the center beam of high beam on the wall
using the screws at the back of the assembly adjust that spot to be pointing slightly to the left if rh drive ot left if lh drive and about 1 inch below the line that you drew on the wall
when you have that correct , it will put the low beam in the correct legal position
if the rear of the vehicle is sitting down , trailer of caravan on , the the head lights have to still be adjusted to legal setting

Oct 20, 2015 | Cars & Trucks

1 Answer

How do I replaced the oil pump on a 2000 ford expedition?


You must raise the engine off the mounts as high as possible and then remove the oil pane to access the pump, a huge job even on a lift much less on the ground.

Feb 16, 2012 | 2000 Ford Expedition

1 Answer

Car not starting, its turning over, changed the fuel filter. could it be the crank sensor.


Check if you have High voltage that cross the high tension wires, lift the cap on the spark plug then pin point to any ground and then turn the engine start if there's spark meaning this stage is ok.

Aug 15, 2011 | 2003 Chevrolet Malibu

1 Answer

Rumble in front end


possible constant velocity joints dry or worn to excess try turning hard lock and drive round if noisy then a would say that's your problem

Apr 09, 2010 | 2004 Nissan Sentra

1 Answer

1998 silverado low beams dont work


There is a relay that toggles between high and low beam, when the turn signal switch lifted.
The relay could be burned out.
Pull the relay from the fuse box.
You can tell when you have the right one, because then no lights at all.
Read side of relay to understand pinout.
Use test light to see if turn signal ground happens when someone lifts on the turn signal handle.
If so, then relay probably bad.
Put it back in an feel for click?
Or take it out and run your own power and ground across the primary, to make it click out of the car.
About $10 at Shucks or Autozone.

Feb 15, 2010 | 1998 Chevrolet C1500

1 Answer

Want to know if the timing is different on a 1997 California cummins than a non-California cummins diesel


Yep , Cummins even do a variation for different cities in Califonia, they do it by zip code

Ring Cummins and ask them to supply you with your individual version

Jan 03, 2010 | 1997 Dodge Ram

1 Answer

Rear shocks are causing car to be lifted high off the ground


the leveling switch on the rear suspension could be out of adjustment - it turns the pump on when rear is to low and turns off when level

Sep 28, 2009 | 1998 Cadillac DeVille

1 Answer

Driver's side high beam shorted out.


Take a test light or volt meter and unplug electrical connector at high beam light and with key on and headlight switch on (highbeem on) you should have power at dark green and white wire. If not then check 15 amp headlamp fuse. There is one for left and one for right. They are located at underhood fuse block (left fenderwell).Lift cover and look in cover for description. If there is power at headlight green/ wt wire then check for ground at the other wire black and purple.If no ground could have bad headlamp ground relay located at body relay box (left side of dash) or the ground connection for this relay a black wire located at left side of dash. Joe ASE Master Tec

Jan 19, 2009 | 1999 Chevrolet S-10 Pickup

1 Answer

Failed Califonia Emission


Check the exhaust this could be the main reason for the emission if the engine is not service properly this lead the same results, check the ignition ratio of your car.......................

Jun 09, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63577 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...