Question about Mitsubishi Diamante

Open Question

Dont no how to reset the srs light replaced the clock spring disconncted battery turn on off 10 times etc and there is no plug for scan tool the shop had a look can u help

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: SRS light on 1997 acura CL

1.bend a paperclip into a u shape. 2.disconnect the yellow plug in your fuse box under the steering wheel and insert the paperclip into the plug that is now hanging there to complete the circuit.3.turn the ignition on and the srs light will stay on for 6 seconds, then turn off.disconnect the paperclip within 4 seconds after that and the light will come back on.4. reconnect the paperclip within 4 seconds and the srs light will turn off again.5.within another 4 seconds of it going off, disconnect the paperclip and the light will blink letting you know that you have completed all the steps right. you can also use some speaker wire

Posted on Mar 20, 2009

  • 43 Answers

SOURCE: e320 reset SRS

Hi, Joe here to help,
Without going to a dealer, you need to get a scan tool to reset the srs light. Go to an Autozone store, They will scan it and reset it free of charge.

Posted on Apr 07, 2009

  • 333 Answers

SOURCE: endeaver srs light is on after replacing battery

The light is on because the SRS computer detected excessively low voltage, likely right before your battery failed/was replaced.
To clear the light you will need to take it to a dealer or a repair shop with a Mitsubishi-compatible SRS scantool.

This happens so frequently, I never charge customers for clearing SRS lights that are related to battery changes (code will be IG low voltage A and B).


Posted on Oct 03, 2009

  • 1 Answer

SOURCE: suzuki grand vitara RHZ Diesel auto/Diagnostic tool

my 1993 very recently aguired.Grand vitara deisel. has imoberlised it's self. have had guys up with computer diognostics and found it in safe mode.found fault on turbo charger fixed it..all go, went for a short run ..great turned it off and on twice all fine.....next morning it had imoberlised itself again guys came with computer no fault found.. but it still will not start....help please........

Posted on Feb 26, 2010

  • 973 Answers

SOURCE: 1997 VW Golf...airbag light on...fault codes read

Did you have the code cleared after you installed the new part because the ECM cannot clear itself, even though you installed a new part and the code is still in the system? You need to have the code erased with a OBD II scanner.

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Srs airbag light on all the time


This means there is a fault with the airbag and it will not work if you have an accident. Take it to a dealer who repairs this make of car. Be prepared for an expensive repair as they usually are expensive to replace.

May 19, 2016 | Cars & Trucks

1 Answer

My horn quit working and airbag light came on after replacing starter and ignition switch. Help!! I have a 2001 dodge neon


I'm sorry but you may broke the clock spring connection from the column to the steering wheel.First make sure all the wire are connected under the dash after you work on ignition switch.
for clock spring disconnect the battery for 10 min.to discharge the SRS system.
turn the wheels and steering straight.
remove the airbag and store in safe place
remove the steering wheel
remove column cover
disconnect the clock spring and remove
installation in reverse order
the new clock spring have yellow lock tab. after removing the tab DO NOT turn the spring. the wire inside have limit of 2 1/2 turns each way.
good luck

Aug 24, 2014 | Cars & Trucks

1 Answer

How to reset AIRBAG SRS Light on toyota paseo 94


the air bag light resets every time you shut off the key. you may have damaged the air bag clock spring during your repair, if this is the case you will need to replace it also

Jun 10, 2012 | Toyota Paseo Cars & Trucks

1 Answer

Had a leak in front windshield window after it was replaced. After heavy rain this morning, some water was on my steering wheel and some on steering column. Now my SRS light stays on & horn does not...


Depending on the year and make of this car or truck when you turn on the key the system runs a test and if the problem was repaired it will shut light off, if the light remains on then theres a problem. even if you had a scan tool reset the light it will come right back on as soon as the engine is started, this sounds like something got wey and shorted out, the first thing i would check is the fuses and then look around at the bottom of the steering column and check connections for water or rusted terminals,inside the steering wheel is a clock spring that contains wires for horn air bag and other controls if cars has them like cruise or steering wheel radio controls, the part called clock spring is what makes the wheel be able to turn without ripping wires, it like a retractable bunch of wires and sometimes they go bad just from turnning the wheel so often, heres a picture of it, chrysler is famous for problems with this, good day.johnjohn2_97.jpg

Apr 13, 2011 | Toyota Sienna Cars & Trucks

1 Answer

On a 3.2 TL Acura, the "SRS" Indicator Light stays on after the engine starts. What codes will be indicated when I try and read the codes?


THE SRS means Air bag sensor and trigger ..

Simply put the SRS light tells you that the sensor cant connect to the trigger of your airbag namely the one locate in the steering wheel. This is beacause of a device known as a clock spring located in the steering. Its moves like a clock and allows the sensor and bag to get connection but sometimes the coil wires get broken.

To fix this take it to a SHOP.
reasons for that.
1.) A DEPLOYED AIR BAG WILL KILL YOU
2.) WITHOUT THE PROPER KNOWLEDGE YOU WILL DEPLOY THE AIR BAG
3.) EQUIPMENT IS EXPENSIVE

the fix involves. (REMOVE BATTERY)
1.) remove the steering wheel using the lock bolt and key
2.) unblot and remove then unlock the clock spring
3.) replace,
4.) recalibrate and reset spring
5.) reset error codes
6.) reassemble
7.) reset error codes.

Mar 20, 2011 | Acura TL Cars & Trucks

1 Answer

Battery was low and put in new battery,problem SRC Light stays on how can I reset the SRC light?


I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

Jan 13, 2010 | 1997 Honda Civic

1 Answer

I have nissan altima 2007 the air bags light is flashing i need turn off how ican do


If the air bag light is flashing- that means there is problem with your SRS air bag system. It stored a code in the computer and wont turn off untill the problem is fixed or cleared manualy with a scan tool- note if you choose to clear the code and turn off the light with a scan tool- if the problem with the system is still there the computer in your car will notice it and store another code and the light will come right back on. also Note that if the air bag light or SRS light is on while driving that system is shut down and your air bags WILL NOT go off if you get into an accident. (the same rules apply if your ABS- anti lock brake light is on- the ABS system will not work) the most common problem with the Altimas and air bag codes are the clock spring assembly located behind your steering wheel- (not the air bag itself on the steering wheel) but there is a round thing that turns with a wire connected to it. you have to remove the steering wheel to service. Best bet - go somewhere that has a scan tool and read what code the computer stored. It will tell you what part of the system has the problem.

Nov 28, 2009 | 2007 Nissan Altima 3.5 Sedan

3 Answers

How to reset srs light on 1996 e320 mercedes benz


try disconecting negative battery terminal for a few seconds

Aug 23, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

2 Answers

Srs light on


1st you need to either buy or make the "SCS Service Connector" #07PAZ-0010100 from H and A Accesories for $3.51. Use a speaker harness for an older Honda which you can buy at a local stereo shop such as Circuit City or Best Buy, and cut the wires and looped them together. You can also use a paperclip but that will make it a little more difficult because you have to connect it and disconnect it a few times quickly. 2nd you need to find the MES (Memory Erase Signal) connector as pictured below scs_small.jpgsrs_plug_small.jpg
It is a yellow connector with two wires in it that is plugged into the fuse box, unplug it and pull it down. Once you have done that you can begin the process of erasing the memory. NOTE: This will only reset your SRS System if what caused it to trigger has been fixed, Ex: turning the ignition on with any SRS Plugs disconnected, such as pulling your seat out.

1st step in erasing the memory is to turn the ignition off and connect the SCS Service connector to the MES Plug.

2nd Turn Ignition on. SRS indicator light will come on for about 6 seconds then go off.

3rd Disconnect SCS service connector for MES connector within 4 seconds after SRS indicator light goes off. SRS indicator light will come on again.

4th Reconnect SCS service connector the MES connector within 4 seconds after SRS light comes on. SRS indicator light will go off.

5th Disconnect SCS service connector from MES connector within 4 seconds. SRS indicator light will indicate that memory is erased by blinking 2 times.

6th Turn ignition off, and wait 10 seconds. Start vehicle like normal and light should come on and go out like normal. You have reset your SRS light, congrats.

If it does not work the first time try it again, the timing has to be perfect. My first time it took me 3 attempts before it worked, but it did work.

Aug 16, 2009 | 2002 Honda Civic

1 Answer

E320 reset SRS


Hi, Joe here to help,
Without going to a dealer, you need to get a scan tool to reset the srs light. Go to an Autozone store, They will scan it and reset it free of charge.

Apr 06, 2009 | 1998 Mercedes-Benz E-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...