Question about Dodge Stratus

1 Answer

Car runs realy bad and shows po300 and po353 tsb

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 504 Answers

A code P0300 may mean that one or more of the following has happened:

  • Faulty spark plugs or wires
  • Faulty coil (pack)
  • Faulty oxygen sensor(s)
  • Faulty fuel injector(s)
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Stuck/blocked EGR valve / passages
  • Faulty camshaft position sensor
  • Defective computer

Posted on Mar 12, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Code 353

po353 is ignition coil c primary/secondary curcuit please go to /po353 for more info.

Mar 24, 2014 | 2006 Ford Freestar

1 Answer

The engine is a 2.8 v6 30v ihad thought the new coil pack ,new wires or new sparkplugs were installed wrong since i am now getting codes of po300 po301 po303 and po353 i initially thought the...

u should check with ompression test.P300 is misfire code,it might be low compression in any cylinders.always start from basic first then replace parts

Jan 27, 2014 | 1999 Volkswagen Passat

1 Answer

2003 ford escape 3.0L code PO353

I would think that many misfire codes would mean it runs terrible,coils go bad alot on the early ones,if it runs badly ,coils are suspect.
would say crank sensor if stiil runs ok,but the cam noise is not good,
lean or misfire won't make the cam noisy,something is broken in the valvetrain

Jan 03, 2014 | 2003 Ford Escape

1 Answer

2005 ford escape 3.0L misfire

That is an ignition coil malfunction on the primary side.

Jul 16, 2017 | 2005 Ford Escape

1 Answer

Misfire po300 on 2.2L

Are you sure that the plug gap is correct? and did you use the recommended plug when you changed them? You might also try running a can of sea foam thru with a tank of fuel to make sure your injectors are not dirty. Also check your fuel pressure.

Apr 24, 2013 | Saturn Vue Cars & Trucks

1 Answer

CODES P0300, P1128

po300 is random miss fire doubtful two O2 sensors bad at one time most likely coolant temp sensor is bad causing engine to run rich this will cause O2 sensors to throw a code(thats what they are there for..exhaust gas temp. and raw fuel) running rich will also fowl spark plugs(=miss fire) P1128 ??

Mar 20, 2013 | 2006 Jeep Liberty

1 Answer

Bad coil pack, fouled plugs, bad sparkplug wires

there is a lot issue with this motor with the po300,po303 ,po304 . it has the do with the head and valves. you need to found out which cylinder is mis firing

Oct 29, 2012 | 2008 Hyundai Accent

1 Answer


misfire is usually due to detonation and can be caused by the engine running to hot and poor spark plugs make sure the engine is running at normal operating temperature. Another cause could be bad valves, poor ignition timing, or to low a fuel octane. but most likely it is due to excessive engine heat.

Oct 27, 2012 | 2004 Ford Taurus

2 Answers

My engine light shows a code po300. which is,"random or multipal misfire" I have changed my plugs and put in a new fuel filter. the light went off with the new filter in but came back on in 2...

For PO300 you need to change out the Fuel Leveling sensor and/or the fuel pump which are one in the same. If you do so,you will have your good old peppy - responsive and well tuned truck back! I've got an `02 of the same truck 5.3lit. That fixed me rite up!!! My codes were PO300 &PO463. Runs like it's NEW again! Really hope this helps!!!!!

Feb 21, 2011 | 2003 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

251 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides