Question about 1999 Dodge Ram

1 Answer

1999 dodge ram misfire have changed plugs and dist cap and rotor, on the road need help fast

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 130 Answers

Make sure plug wires are on righr and i had that with a ram it was catalatic converter

Posted on Mar 12, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New plug misfire in dodge ram 1500 6 cyl van


could be your coil, but can also be internal, have you replaced both the air & fuel filters ? if so, dump some good fuel injector cleaner into tank when half empty , top off with 91-92 octane fuel, see how that works for you, do some highway driving, stop & go traffic creates problems, todays fuel w/ethonal is bad for older cars, be sure to have code cleared from ecm !

Feb 15, 2013 | 1999 Dodge Ram

2 Answers

I have a 2001 dodge ram 1500 4wd and three codes came up P 300 p 301 and p 308 what are these ??? help please!!


The codes mean as follows
PO300 multiple cylinder misfires
PO301 #1 cylinder misfire
PO308 #8 cylinder misfire
Some of the more common causes for these codes popping at once are, if you went through a big
puddle and the engine and wires are wet or the distributor cap and/or wires are bad or the camshaft
sensor(located inside dist cap) is bad and sending false signals. Hope this helps.

Oct 29, 2010 | Dodge Pickup Cars & Trucks

1 Answer

I have a 1999 ram 2500 with a 360 gas engine 70,000 miles. Driving down road quit. Spark at coil none at plugs, pulled dist cap rotor NOT turning when we rolled engine over with starter. Pulled distributor...


Something has sheared. Is there a pin on the distributor drive gear, are the gears on the cam and dist. shaft perfect / no flat spots at all, is there a keyway or key on the crank or cam gears that has sheared? Must be a weak point that was slipping somewhere.

Sep 26, 2010 | 1999 Dodge Ram

1 Answer

97 dodge ram no spark


then i would replace whats called the hall effect sensor its that black plastic plate you see when you take dist cap off. just pull rotor and lift up the sensor.dist cap is what holds it on.also under the sensor will be a stamped sheet metal piece that looks like the top of a castle wall. make sure its not loose on the shaft.if it is then new dist will be needed

May 09, 2010 | 1997 Dodge Ram 1500 Club Cab

2 Answers

Got a 1990 dodge ram charger with a 360 in it. got fire from coil to distriber but not to moter . not the wires or pluges. so help


it could be the rotor arm or dissy cap worn i had the same fault with my rangerover v8 i changed them and it was fine

Feb 07, 2010 | 1990 Dodge Ramcharger

1 Answer

99 tahoe 350. misfire #3. new cpi unit, plugs,


coil packs? or dist engine? check coil packs for cracks and leakage on distributor egines check for side to side play in the dist shaft if any play then change it!

Jan 17, 2010 | 1999 Chevrolet Tahoe

1 Answer

I have a 2000 dodge stratus and cylinders 4,5,and 6 misfires at idle I changed the plugs ,wires, dis.cap and rotor.the compression is fine on a11l


There is a distributor control module underneath the dist cap change that make sure to lube it with the silicone it comes with

Sep 09, 2009 | 1997 Dodge Stratus

2 Answers

Misfire on #6 and #8 cylinder 1996 Dodge Ram 1500


strip heads off again and remove the valves and check the seats ,regrind the valves and fit new springs and seals ,also check the cam lobes for deformation (wear)

Jun 22, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
1999 Dodge Ram Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...