Question about Ford F-150

1 Answer

My truck was in a accident and now y have no power in anny place in the truck

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 827 Answers

Did you check the ground? inspect the wiring harness fully? what condition is the battery in? The battery cables? etc., etc.,
Best regards
Ck

Posted on Mar 12, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Who can I contact to fix my turbo in Pretoria?


Check your local listings for turbo rebuilding. I had a customer recently that needed a turbo for their Dodge diesel truck. Dealer wanted $1,400 for a new turbo and the customer couldn't afford it. I found a local shop that does only turbo rebuilding and had his repaired for $600.

Jul 17, 2014 | 2010 Toyota Fortuner 3.0D-4D

1 Answer

Tacoma 2001 isnt geting anny gas solution


sounds like yiour fuel pump is not running or you have a clooged fuel filter. If the pump is not running it could be the relay or a bad pump. The pump runs for about 1.5 second when you turn on the key.. go to back of truck and have someone just turn the key on to the accessory position. you should be able to hear the pump start and stop.. Kinda a bussing noise.

May 13, 2014 | 2001 Toyota Tacoma

1 Answer

How to take horn cap on steering wheel off without setting off air bag to replace horn cam?


u shoudnt have anny problem if u disconect battery mak sure wires are in the same spot when u put it back in with out power it wont go off

Apr 05, 2011 | 2000 Chevrolet S-10

1 Answer

I have a 97 kia sephia auto trans 4 door i have no power


these electronics are very sensitive now. he could have shorted out the entire computer system which is probalby what happened

Apr 15, 2010 | 1997 Kia Sephia

1 Answer

1996 Cadillac Deville not shifting into drive or top gear. Also starts in second. Traction control button doesn't change anything. Flushed fluid but no change.


change shift solinoids. located in transmission pan. 4.6l north star has a 4t80e tranny. remove bolts holding pan drop pan . now disconnect the shift solinoids thair are 2 u should see several bolts around 20 bolts holdong the valve body to the transmission unscrew thees bolts . ( 10MM) before removing all bolts disconnect the hook with a clip going to the valve body.its located to a spring and lever. now remove rest of bolts. DO NOT LET IT FALL DOWN. remove the connector going to manifold pressure sensor. use a flat head screw driver to pull clips holding the solinoids in place. thair should be a small **** located on the other side of throdle body. DO NOT REMOVE ALL THE BOLTS OUT OF THE BODY. THAIR ARE BALL BERINGS INSIDE THAT WILL FALL OUT OF PLACE. the screen is located in between the shift solinoids. DO NOT DO THIS JOB WITHOUT ALREADY HAVING THE REPLACMENT PARTS ON HAND. when putting every thang back together i would check the wiring harness for anny shorts . ANNY OTHER ?S EMAIL ME AT BRANDONDAY87@YAHOO.COM

Feb 24, 2010 | 1996 Cadillac DeVille

1 Answer

How do i check my break pads on a '93 dodge ram 50?


  1. jack up car
  2. place a stand under car
  3. remove tire ( have a friens stand on breaks )
  4. now remove caliper usually 2 bolts on rear of caliper
  5. break pads normally are 3/4 - 1 inch thick new
ok now if you are un sure at anny point in the directions or locating bolts (STOP) go no further
replace tire tighten nuts up and go to a mechanic
it might cost a bit but the alternative is a posability and your life or the life of a family of four is worth more than a few bucks

Jan 07, 2010 | 1993 Dodge Power Ram 50

1 Answer

Headlights power


check your fuses and look under the hood for a black relay box and it might have a fuse in the box for head lights. The cover that comes off of relay box will tell you (inside) what each relay or fuse is for.

Jan 25, 2009 | 1995 Pontiac Trans Sport

2 Answers

Put coolant in wrong place


was it the washer fluid tank?

Dec 27, 2008 | 2007 BMW X3 3.0si SAV

1 Answer

Don,t start


well if you have no spark u will not have powr anny where else. well maby the battery power but....

check spark plugs, trac wires to plugs to see if one is broken. if u cant fix it bring it to a garage they will help.

Oct 02, 2008 | 1994 Audi 100

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...