Question about 1990 Mitsubishi Minivan

1 Answer

Wich kind of oil engine I have to put in? - 1990 Mitsubishi Minivan

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 166 Answers

Should say right on oil cap

Posted on Mar 12, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I got metal dust in the engine oil

Hi,I would say that if the noyse is coming from the bottom part of the engine then its proberly the big end berrings that have worn out wich means that the engine will need striped down and rebilt,sorry best of luck.

Nov 30, 2013 | 2004 Chrysler Sebring

1 Answer

Rattling under engine after oil change

And what Kind Of Oil Did We Put in Too It ?That Don,t Sound Good To Me Sounds Like You HAve Bearing Noise so replace the Oil Again with Heavier OIL That,s NASTY THING to Do to Some ONe sorry to Hear this It,s Been Done Before to others I Know Put in 10/30 into it Ok the right Amount into it

Jun 03, 2012 | Ford Windstar Cars & Trucks

1 Answer

Engine knocking

what kind of car???
if your in a cold climat and your oil is dirty lifters will knock
till they fill with oil
i would change oil and filter
read your manual and put in the proper weight 5w30

fords are famous for pluging the oil filter on the 6 cyl. engines,thus reduceing oil flow to the upper engine

Dec 16, 2011 | Cars & Trucks

1 Answer

Where do I put oil in this thing? New to me '91 6.2

what kind of oil are you putting in? Engine oil, or transmission fluid? Engine oil should be on one of the valve covers or there will be an oil filler neck. Trans fluid you add in the trans stick

Feb 10, 2011 | 1991 Chevrolet C/K 3500

1 Answer

What kind of oil should I put in my 85 Porsche 944

definitely use a high mileage, synthetic oil for foreign made cars appropriate for a 4 cylinder engine.

May 20, 2010 | 1985 Porsche 944

1 Answer

Have an oil leak from somewhere under the engine. Have already replaced the oil pan gasket, and the valve cover gaskets. Still have oil coming from under engine someplace. What could be possible problem?

check the oil pressure sending unit,clean engine then look to see where it is leaking,could be oil sending unit,dist drive seal or engine rear main.Need to determine wich side of engine.

Mar 31, 2010 | 1995 Dodge Intrepid

2 Answers

19968 chrysler town and country- oil light stays on, oil level is fine.

This could be caused by a faulty oil sending unit, wich is located on the intake manifold or near it

Nov 07, 2009 | 1998 Chrysler Town & Country

2 Answers

Got a 1998 dodge neon with the 2.0 dohv 16v engine and it seems to burn oil on idle but goes away when rev it up or take it for a drive got any ideas?

your valve seals are worn or guides on the head. wha you need to do is take a compression test of each cilynder and when you are doing that check each spark plug for signs of oil wich means that is the cylinder with the problem so its either going to be the head or the piston rings

Oct 04, 2009 | 1998 Dodge Neon

1 Answer

A4,2007,1,9 tdi,B7,BRB engine code

You will have to speak to a audi dealer ref the DPF side of things, the oil you have to use is the audi castrol long-life oil. Audi say you can use upto a litre of oil to every 1000 miles

Feb 22, 2009 | 2007 Audi A4 Convertible

1 Answer

Cause and solution

sounds like one of the oil breather pipes is bloked wich will cause oil to feed to the cylinder wich will cause smoke and uneavan running wich will cause the car to **** when standing. take off all breathing pipes main ones come from the rocker covers clean them and put them back. the main engine breather will come out of the engine block do the same.

Jun 17, 2008 | BMW 750 Cars & Trucks

Not finding what you are looking for?
1990 Mitsubishi Minivan Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides