Question about Mercury Sable

1 Answer

My car squeak when i turn it on and it has power steering fluid in it what is wrong?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

Check the belts. If they're loose or smooth (glazed) they need to be adjusted or replaced.

Posted on Mar 12, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Steering wheel squeeks when turning either direction.


A squeak or a whining noise? If it is a squeak then it is something mechanical from your steering column down. Could be anything from rack and pinion to the tie rods and ball joints. If it is a whining noise the you need to check your power steering fluid and power steering pump. If the fluid is low then you have a leak in the power steering system somewhere and needs to be fixed before you ruin the pump.

May 17, 2016 | Cars & Trucks

1 Answer

Why has steering started squeaking loudly when parking or low speed turning?


I would say it have to be bad joints or breaks.

Steering is all electronics these days so it can only be loosen.

Apr 04, 2016 | Cars & Trucks

1 Answer

What do i do for loud squeak when i turn flymo tl400


Loud squeak when turning on is usually low power steering fluid or a water pump going out. If the power steering fluid is fine keep an eye on your temp gauge and make sure it is staying consistent when hot.

Feb 24, 2015 | Cars & Trucks

1 Answer

How do I know if my Power steering unit(?) has to be replaced


no power steering fluid would cause the pump to overheat, damaging seals.
the foam might have been pump cavitation causing injestion of air in the fluid, (makes the hydro fluid "frothy")
spraying ANY lubricant on the belts will cause them to slip and make a squeaking/squealing noise.

check the location of the leak, wipe down the hoses (cheap causes for leaks) fill the power steering. put some newspapers under the car, start the car, turn the wheels lock to lock, shut off car, check for leaks, should tell you if it is a hose or connection, or rack unit

Apr 16, 2012 | Mazda 626 Cars & Trucks

1 Answer

Steering is noisy at slow speeds when turning


This car is essentailly the same as the Lincoln LS & T-Bird.
Here is their solution.

please rate if this helps you. Thanks.

ISSUE: Some 2003-2005 Thunderbird, Aviator, and Lincoln LS vehicles may exhibit steering gear squeak when turning the steering wheel, especially during low speed parking maneuvers. The noise may sound like it is coming from the steering column area and may be felt as a roughness in the steering wheel, while turning.
ACTION: Refer to the following Service Procedure.
SERVICE PROCEDURE NOTE: USE ONLY THE FLUID AND ADDITIVE SPECIFIED IN THIS ARTICLE. USING ANY OTHER FLUIDS OR ADDITIVES MAY RESULT IN SEAL DETERIORATION AND LEAKS.
  1. Open the hood and remove the power steering reservoir cap.
  2. Raise the vehicle on a hoist. Refer to Workshop Manual, Section 100-00.
  3. With engine off, drain power steering fluid by disconnecting steering lines and clamp plate from steering gear. Refer to Steering Gear Removal and Installation procedure in Workshop Manual, Section 211-00, follow only the steps required to disconnect the steering lines.
  4. Turn steering wheel lock-to-lock to drain fluid completely.
  5. Reconnect steering lines and clamp plate to steering gear. Torque retainer to 15 N-m (11 lb-ft) for Lincoln LS and Thunderbird, torque to 25 N-m (18 lb-ft) for Aviator.
  6. Lower vehicle.
  7. In a clean container mix 50 ml (10 teaspoons or 1.7 oz.) of Motorcraft Additive Friction Modifier, Part Number XL-3, with 50 ml of Motorcraft MERCON® Multi-Purpose Automatic Transmission Fluid, Part Number XT-2-QDX. NOTE: DO NOT PERFORM STEPS 8 AND 9 ON A HOT VEHICLE.
  8. Pour the above mixture into the power steering reservoir.
  9. Top off (fill) the power steering system with Motorcraft MERCON® Multi-Purpose Automatic Transmission Fluid, Part Number XT-2-QDX and reinstall the power steering reservoir cap.
  10. Raise vehicle on hoist enough so the front wheels are off the ground and can be turned from lock-to-lock.
  11. Start the engine and keep it at idle. Remain inside of the vehicle.
  12. Slowly cycle the steering wheel from lock-to-lock for two (2) minutes.
  13. Quickly and forcefully turn the steering wheel in one direction to full lock (either side). Bounce the steering wheel on/off of full lock twenty (20) times forcefully. NOTE: IT IS CRITICAL THAT THE STEERING WHEEL IS TURNED QUICKLY AND FORCEFULLY IN ORDER TO CREATE A PRESSURE SPIKE IN THE POWER STEERING SYSTEM.
  14. Repeat Step 13 in the other direction. Return the steering wheel to on center position.
  15. Slowly turn steering wheel to full lock in one direction (either direction) to achieve maximum pump pressure. Hold at full lock for one (1) second, then turn the steering wheel back 90 degrees as quickly as possible. Repeat this procedure twenty (20) times. NOTE: DO NOT HOLD THE STEERING WHEEL AGAINST THE STOPS FOR MORE THAN THREE TO FIVE (3-5) SECONDS AT A TIME. DAMAGE TO THE POWER STEERING PUMP MAY OCCUR.
  16. Repeat Step 15 in the other direction.
  17. Cycle the steering wheel slowly for 1 minute to confirm that the squeak is corrected and return vehicle to the customer. NOTE: IF THE SQUEAK CONTINUES, REPEAT STEPS 13-16 ONE ADDITIONAL TIME. IF THE SQUEAK IS STILL NOT CORRECTED PROCEED TO STEP 18.
  18. If the squeak is still present after performing Step 17, replace the steering gear. Refer to Workshop Manual, Section 211-00 for removal and installation procedures.

PART NUMBER PART NAME XL-3 Motorcraft Additive Friction Modifier XT-2-QDX Motorcraft MERCON® Multi-Purpose Automatic Transmission Fluid 5W4Z-3504-A Steering Gear (LS) 5W6Z-3504-A Steering Gear (Thunderbird) 5C5Z-3504-AA Steering Gear (Aviator)

Aug 15, 2011 | 2003 Jaguar X-Type

1 Answer

It squeaks like a 50 year old vehicle. The front end squeaks even if ur not moving,just turning the steering wheel it will squeak then driving


Hi!
Check the power steering fluid level, if OK, your power steering pump may need to be replaced. If in doubt, take vehicle to and AutoZone or similar autoparts store and have one of the attendants check it out.
Don't forget to rate this post!!

Sep 11, 2010 | 1998 Ford Explorer

1 Answer

We have a hard time turning the steering wheel and when we do it makes a squeaking noise


sounds like you may be out of steering fluid check your power steering reivour add power steering fluid to designated mark on dip stick then watch for leaks

May 05, 2010 | 2006 Dodge Stratus

1 Answer

1996 plymouth voyager steering wheel squeaks when it is turned


You need some power steering fluid. Fill to line markers on power fluid tank while car is off. Start car turn steering wheel all the way to the left then all the way to the right until squealling stops.If it does not stop check fluid level and if it needs add more.Put a cardboard box flat under the car to check for leaks. If no leaks continue filling to line marker until squealing stops.

Jan 13, 2010 | 2003 Toyota Camry

1 Answer

My Isuzu trooper 1990 makes a squeaking sound at the front..recently i notice my power steering fluid leaks but in a small quantity. The squeaking noise make sound when i turn the wheel (with difficulty...


The power steering fluid level is low or the v-belt tension needs adjusting.Its not likely to be the aircon comp.Look at the v-belt.Adjust if needed and also see its not cracked or too shiny that would allow slipping.If in doubt,replace it.It will be the problem.Hope this helps

Jan 01, 2010 | 2000 Jeep Wrangler

1 Answer

1997 chrysler sebring steering squeaks when turning either way


check the power steering fluid and the condition of the drive belt

Mar 08, 2009 | 1997 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

fordexpert

Level 3 Expert

5470 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...