Question about GMC Jimmy

1 Answer

Starter appears to be bad...battery cable post on the starter free spins. Starter does not engage. My problem is I can't see how to get the starter out. There isn't enough room to pull the starter out.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 65 Answers

If it is a s-10 with a 4.3 you need to drop the exhaust at the manifold flange and at the cat converter then remove the support brackets it will then come down enough to disconnect the wiring
good luck
chris

Posted on Mar 12, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Sorry for the lack of info The starter is new, disconnected the battery replaced the starter ad when the battery was connected the starter starts turning with out the ignition on but not engaging. The...


Well, if your starter starts to turn when you hook the battery cable up, then you have hooked the cable to the wrong post on the starter. You have two large posts and one small post on the starter solenoid, the battery cable goes on the large post that has nothing else hooked to it. The other large post should have a large braided cable going into the starter motor housing. If the starter still will not turn the engine over when it is wired correctly then you will need to look closer at the flywheel ring gear.

Sep 06, 2014 | 2007 Toyota Tundra

4 Answers

Turn key get nothing jump starter and sylenoid just spins


i cant dope out that symptoms.

does it crank or not. be clear there.

no car starts (but my 6sp) if it dont crank.

on A/T cars cranking is a first thing. so does it.?

Solenoids do not spin, the stroke only , it a linear motion.

the Sol. moves the pinion and the main contactor switch only.



my guess is the Starter spins and the crank don\'t spin,

you hear the starter motor spin up, it sings. like bird.

that means the starter /solenoid are bad. (crude)

if the battery is good and or jumper starting off a running car.



It can just be a dirty starter pinion, clean it , repeat.

fixed many for this. i have.



battery cable lugs clean, and good. no green rust.

bad cable usually just make a loud THUNK sound. no spin.

Sep 02, 2014 | 2005 Jeep Wrangler X

1 Answer

GMC 6.0L starter does not engage


To check the starter: key off, transmission in park or neutral, brake set. Pull off the small wire to starter solenoid. Then use a small jumper wire from battery cable post on the starter to the solenoid terminal (can also use a small screwdriver to bridge those terminals). Starter motor should engage the flywheel and spin the engine. If nothing, starter motor or solenoid is bad. If starter works, check for power on the small solenoid wire, with key held in crank. Wire should have power, if not, check start circuit from ignition switch to solenoid-the neutral safety switch is in that circuit.

Dec 11, 2013 | 2003 GMC Sierra 2500HD

3 Answers

When I try to start, why does it sound like the starter is spinning and not engaging anything?


You may need to take the starter off and have it bench tested.
The problem could be the starter drive, or you could have some missing teeth on the flywheel. The drive is supposed to extend when the starter spins to make contact with the teeth on the flywheel. You could also try turning the crank a few inches and try the starter again.

May 09, 2013 | 2002 Nissan Sentra

1 Answer

2003 dyna starter turns but wont engage, new battery fitted


Hi Anonymous, lift up rubber boot on positive cable to starter, unplug starter relay wire usually green, with a jumper wire connected to positive battery cable starter stud, touch blade connecter on starter where starter relay wire was removed. If starter engages and turns over engine then your starter relay is bad. If starter activates but does not engage then your starter drive/clutch is bad. Good luck

Jan 22, 2012 | Cars & Trucks

1 Answer

How can i know if my starter relay is bad on a dodge stratus 2001


IF STARTER RELAY BAD THE STARTER WONT MAKE NO NOISE AT ALL HEADLIGHTS WONT DIM.IF YOU CLICKING NOISE BATTERY VOLTAGE TOO LOW. MAKE SURE BATTERY VOLTS ARE 12.6 VOLTS AND USE TEST LIGHT TO SEE IF STARTER GETTING POWER.COULD HAVE BLOWED IGNITION FUSE OR FAULTY IGNITION SWITCH. TO CHECK STARTER SOLENOID FIRST TURN OFF RADIO THEN REMOVE NEGATIVE BATTERY CABLE AND POSITIVE BATTERY CABLE.THEN REMOVE STARTER BUY A REMOTE SWITCH.YOU NEED BATTERY JUMPER CABLES HOOK BATTERY JUMPER CABLES TO BATTERY PUT POSITIVE CABLE ON POSITIVE BATTERY POST THEN PUT NEGATIVE BATTERY CABLE ON NEGATIVE POST. HOOK BATTERY CABLES TO STARTER USE NEGATIVE CABLE GROUND STARTER BODY AND PUT POSITIVE BATTERY CABLE ON THE LARGE POSITIVE POST ON STARTER SOLENOID. NOW TAKE REMOTE SWITCH HOOK RED WIRE TO STARTER SOLENOID POSITIVE POST THEN HOOK BLACK WIRE TO REMOTE SWITCH TO STARTER SOLENOID SWITCH TERMINAL WITH LETTER S THEN PRESS REMOTE IF STARTER SPINS STRONG WITH A GOOD KICK STARTER GOOD.YOUR PROBLEM COULD BE CORRODED WORN BATTERY CABLES. WEAK BATTERY FAULTY IGNITION SWITCH. IF STARTER DONT WORK WHEN YOU PRESS THE REMOTE SWITCH STARTER SOLNOID BAD OR STARTER ITSELF BAD.IF ALL IS GOOD. CODE SCAN CAR FOR THEFT SECURITY FAULT CODE.

Aug 28, 2011 | 1999 Dodge Caravan

2 Answers

Truck will not start how can i tell if its a starter or selonoid


does it spin real fast without clanging and grinding against the flywheel? if so then its probably the solenoid bad. do you have to hit the starter with a hammer then it works? it is probably bad brushes or a worn motor. eather way i think you can only get a new starter and solenoid together not sold seperate. check for bad battery cables (loose).

May 30, 2011 | 1996 Chevrolet K1500

2 Answers

My car is not ingaging to turn over


If it is just clicking, then the battery is too weak. Charge the battery or jumpstart.

If the battery is full charged and when you turn the key, the starter is just clicking again, possibly bad starter or bad battery cable ground. Check your grounds from the battery.

If it is a new starter and it is clicking like it won't engage, then it is not shimmed properly.

If you figure out what is wrong and need further help, please reply to this post with your questions.

Thanks! Oh, please post your engine size, year of car or truck and model. This helps A LOT!!!

Apr 19, 2011 | Dodge Neon Cars & Trucks

2 Answers

Now what? Changed alternator but car still won't start.


a dropped/disconected starter solenoid cable is a good candidate, a heavy cable runs from the battery to the starter, a lighter cable runs from the ignition to the starter solenoid, the ignition key throws the solenoid which engages the starter pinion gear in the flywheel, and connects the cable to spin the starter motor. even loose may not be producing enoug current to fully engage the starter.
there is a fusible link in the battery cable that is a good candidate.
if the battery were disconnected during alternator changeover, look for loose cables at the battery posts, and corrosion on the posts.
if the battery was not disconnected look for collapsed positive plates on one or more cells of the battery..

Jul 13, 2008 | 1987 Toyota Corolla 2 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...