Question about Geo Storm

1 Answer

Need R&R information to replace for waterpump Geo Storm 1993 4 cyl

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,796 Answers

Hi!!
Here is the Info you requested:
WATER PUMP REMOVAL & INSTALLATION
Except Twincam Engines See Figures 1 and 2

  • Disconnect the negative battery cable and drain the cooling system.
  • Loosen the power steering pump adjustment bolts and remove the drive belt.
  • Remove the timing belt; refer to the procedure later in this section.
  • Remove the tension pulley and spring.
  • Remove the water pump mounting bolts, water pump and gasket. Clean the mounting surfaces of all remaining gasket material.
  • To install, reverse the removal procedures. Tighten the water pump bolts to 17 ft. lbs. (23 Nm) and the tension pulley to 30 ft. lbs. (40 Nm).
  • Connect the negative battery cable and fill the cooling system, then start the engine and check for leaks.

FIG 1 Need R&R information to replace - 1kbron_114.jpg
FIG 2 1kbron_115.jpg

Twincam Engines See Figure 3
1.6L DOHC ENGINE
  • Disconnect the negative battery cable and drain the cooling system.
  • Support the engine using a suitable floor jack and remove the right front engine mount.
  • Remove the engine mount bridge and the upper timing belt cover.
  • Remove the power steering belt and the lower timing belt cover.
  • Loosen the timing belt tension pulley and remove the timing belt.
  • Remove the power steering pump and bracket.
  • Remove the water pump attaching bolts, then the water pump from the vehicle. Thoroughly clean all remaining gasket material from the mating surfaces.
  • Reverse procedure to install and tighten the water pump bolts to 17 ft. lbs. (24 Nm). Connect the negative battery cable and refill the cooling system. Start the engine and check for leaks.

  • 1.8L ENGINE
    • Disconnect the negative battery cable and drain the engine cooling system.
    • Remove the timing belt covers; refer to the procedure later in this section. Loosen the timing belt tensioner pulley bolt, then remove the belt from the water pump pulley.
    • Remove the 2 bolts from the power steering pump bracket, then position the pump aside with the lines still attached. Be careful not to kink or damage the steering fluid lines.
    • Remove the water pump mounting bolts, then remove the pump from the engine. Thoroughly clean the gasket mating surfaces of all remaining gasket material.

    To install:
    • Install the water pump using a new gasket, then tighten the retaining bolts to 18 ft. lbs. (24 Nm).
    • Position the power steering pump assembly, then install the retaining bolts and tighten to 25 ft. lbs. (34 Nm).
    • Install the timing belt to the pump pulley, then tighten the tensioner pulley bolt to 30 ft. lbs. (40 Nm).
    • Install the timing belt covers.
    • Connect the negative battery cable and fill the cooling system, then start the engine and check for leaks
    Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Posted on Mar 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does a distributor from a 1993 geo storm gsi 1.8 fit a 1993 geo storm base?


most probably not, the GSi has a different head. Base has a 12 valve, GSi has a 16V. Check for part numbers. Do you need just the cap or the entire distributor?

Mar 12, 2015 | 1993 Geo Storm

1 Answer

Oil capacity on a 1991 geo storm


1991 GEO STORM 1.6L 4-cyl Engine Code 5 DOHCCAPACITIES
Engine, with filter.......... 3.2 quarts
Cooling System, W/ MT Initial Fill.......... 7.4 quarts
Cooling System, W/ AT Initial Fill.......... 8.0 quarts
Automatic Transmission, Initial Fill........ 4.3 quarts [1]
Automatic Transmission, Total Fill......... 7.0 quarts
Manual Transmission, ..........4.0 pints[1] With ENG at operating temperature, shift through all gears.
Check fluid level in PARK and add fluid as needed.1991 GEO STORM 1.6L 4-cyl Engine Code 6 SOHC
1992 GEO STORM 1.8L 4-cyl Engine Code 8 DOHCCAPACITIES
Engine, with filter.......... 4.0 quarts
Cooling System, W/ AT Initial Fill.......... 8.0 quarts
Cooling System, W MT Initial Fill........... 7.4 quarts
Automatic Transmission, Initial Fill........ 4.3 quarts [1]
Automatic Transmission, Total Fill......... 7.0 quarts
Manual Transmission, .......... 4.0 pints[1] With ENG at operating temperature, shift through all gears.
Check fluid level in PARK and add fluid as needed.

Sep 12, 2012 | 1991 Geo Storm

1 Answer

How do i replace a water pump on a 1993 geo


1 disconnect battery ground cable
2 drain cooling system
3 on models with a/c, proceed as follows:

a discharge a/c system
b loosen upper and lower compressor bolts and remove compressor drive belt
c remove a/c line from top of radiator shroud

4 remove water pump drive belt
5 remove reservoir tank from radiator bracket
6 remove radiator shroud and fan/clutch from vehicle
7 remove waterpump pulley from waterpump
8 remove timing tensioner and timing belt
9 remove dipstick tube
10 remove alternator mounting bracket at water pump
11 remove water pump mounting bolts and water pump
12 reverse procedure to install, using new gasket and rubber seal

Feb 18, 2010 | 1993 Geo Tracker

1 Answer

My valves are bent on my 93 Geo Storm. How much to replace?


For a price you will need to call a repair shop. Yes, the head gasket will need replacement, you are going to have the head off, It may cost more than the car is worth.

Nov 25, 2009 | 1993 Geo Metro

2 Answers

What is the engine size of a '92 geo storm


The Geo Storm is was equipped with a 1.6L 4 cylinder engine,
the GSI Geo Storm had a 1.8L 4 cylinder engine.

Nov 20, 2009 | 1992 Geo Storm

1 Answer

1993 geo overheats then stalls ignitition module just replaced. Heats up light comes on and dies


Hello jerandtashbr and thank you for asking your question, on Fixya.

Here is a simple process that will walk you through a few steps that will pinpoint the overheating problem on your 1993 Geo Storm, without even using any tools. It has helped millions of people, and I am certain that it will help you, because I wrote it for people in your exact situation.
How to diagnose your overheating Geo Storm

Get more great (money saving) tips and tricks about your vehicle from: twitter.com/acoates23234

Thanks for the vote, and good luck!

Sep 24, 2009 | 1993 Geo Storm

1 Answer

1993 geo storm no brake lights...


Locate fuse panels. Typically under dash, side foot well or under hood. Covers usually have fuse labels. Obtain repair manual.

Jul 10, 2009 | 1993 Geo Storm

1 Answer

How to replace a heater core on a 93 geo storm possible diagram


try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 20, 2009 | 1993 Geo Storm

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

440 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...