Question about 2002 Mazda Millenia

1 Answer

Hold button keeps flashing on the dash, check engine light keeps coming on.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 504 Answers

Check with scantool for fault code

Posted on Mar 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to reset the change oil light on a 1997 rav4


rav4 reset maintenance light
pretty standard
hold trip A in with engine and key off while holding trip button in turn key and engine on.
keep holding trip button in until light stops flashing when it stops flashing then release the trip reset button this should clear the maintenance warning light. hope this helps

Dec 26, 2014 | 1997 Toyota RAV4

2 Answers

How do I get the maintainance required light off


Turn the key off, hold down the odo button on the dash, turn the key on and keep holding the odo button for about 7 seconds. The display screen on the dash will start to flash, release the button and press it down again and keep holding it until the display stops blinking. All done.

Aug 24, 2010 | 1997 Honda Civic

1 Answer

I just got a 1998 PLY Voyager 3.3 o.d. trans. 1. Problem lights blink on & off on rear wiper buttons.2. head lights stay on after i turn off engine day or night.3.Doors a jar dash light stays on.4.air...


Problem #1 The blinking lights in the rear wiper rear defrost area can be reset by holding 2 buttons of the 3 on the left hand side. The top and bottom buttons. Turn the key on and hold them for about 10 sec and they should start flashing differently. Just let it do this. After they start flashing different. It will take 5 to 10 mins. Then one or more will quit flashing all together. If they don't after about 20 min reset them again it can take about 5 trys sometimes before they all go out. Also to fix the dash going out try this. This is a common problem with the voyager,caravans and Town & Countrys. What the problem is is a cold soder in the interment cluster itself. The problem area is where the plug comes from the van into the cluster. You need to take the circuit board out of the cluster and reheat the soder on the back side of the circuit board were the plug plugs into. This will fix the cold soder permanitly I think its about 16 pins you have to reheat with the soder gun. If you don't feel comfrotable doing that you can just replace the interment cluster and it will be fine but if you buy a used one make sure it was tested. This also may fix the ABS light and the airbag light. Hope this helps I have done several of them.

Feb 18, 2010 | 1998 Plymouth Voyager

2 Answers

HI, I HAVE AN AUDI A4 AND WAS WONDER DO YOU KNOW HOW TO TURN OFF THE SERVICE WARNING LIGHT ON THE DASH BOARD? "SERVICE" KEEPS COMING UP AND I WOULD LIKE TO GET IT OFF, THANKS


cant remember properly but i think you hold the trip meter switch in and then turn ignition to accessory ,and still hold it down then turn to ignition and something flashes on dash and you go through sequence using the radio volume button on the steering wheel .well something like that

Jan 07, 2010 | 2000 Audi A4

1 Answer

Maintence light flashing 7-8 times ? 92k


IT IS A MILEAGE LIGHT WITH THE KEY OFF HOLD THE SELECT RESET BUTTON ON DASH AT THE SAME TIME TURN KEY ON THE LIGHT WILL FLASH ONE TIME KEEP HOLDING THE BUTTON WHEN THE LIGHT GOES OFF TURN KEY OFF THEN START CAR LIGHT SHOULD GO OFF AFTER A COUPLE OF SECONDS AND SHOULD BE RESET

Dec 20, 2009 | 2002 Honda Accord

2 Answers

ANTI THEFT LIGHT KEEPS FLASHING ON AND OFF


Did you steal it? I heard about you thieves who steal cars then put new transmissions in!!
Seriously, try this, it may help...
Put the key in the ignition, and turn forward all the way just before cranking. Then within 5 seconds, locate, press and hold in the valet/overide button, found under the dash area, (push button, spring loaded) until the installed LED (the blinking light) in your dash area goes on solid, and the siren chirps once. (Your valet switch might be the toggle (on/off) type. in this case, key on, flip switch in opposite direction, then turn the key off.) This should reset the alarm, and reset the grounded relay on the starter wire, allowing you to start the engine. At this point, the only thing working would be the keyless entry from the alarm, if it came equipped that way. Just Repeat these steps to place it back to usable armed mode. You may get 2 chirps, confirming it, and the lights may flash twice as well. That should do it. Check out www.explorerforum.com

Dec 04, 2009 | 1996 Ford Explorer

1 Answer

How do you shut the oil light off


check the fuse box on the driver's side of the dash, there should be a red button in there labeled reset. press & release the button, light flashes then press & hold for 5 secs. if no button turn key to on but do not start engine & press gas pedal to floor 3 times light should flash & go out

Jul 10, 2009 | 2002 Pontiac Grand Am

4 Answers

2007 Volvo S80 V8 Sedan Service reset light


Install remote/key into socket.  Push and hold trip button on instrument cluster with all doors shut.  Push start button one time for key position one while holding trip button and count to five.  keep holding trip button and hit start button to key position two where all the warning lites come on the instrument cluster while still holding trip button.  Count to around ten and triangular warning lite should flash. Release button and remove key and then start engine.  May take a few attempts to reset this lite.  

Mar 30, 2009 | 2007 Volvo S80 V8 Sedan

3 Answers

Resetting the check engine light


On my 2006 you set the odometer to the normal odometer mode using the button on the dash. When you get that setting, hold the button down until the display flashes. Once it begins to flash, let go of the button and then push it again. The light should then go out.

Mar 12, 2009 | 1996 Toyota Camry

3 Answers

Flashing light shows a car and a keyh inside


Thank You Very Much for The Maintenance Required Light Info, as far as the flashing car w the key inside. I'm not sure what key we have? When we bought it it only came with one key so we tried to make a duplicate, which ended up not working because we later found out it needs a chip (or probably what I hear as the smart key?) If the light is supposed to be on (and normal) why does it need reset?

The Maint Reqd light blinks after 4,500 miles, and stays ON continuously after 5,000 miles. This is to remind you that you need an oil change. Give the info from you about your key, you do not have a smart key. You have a transponder key. Off topic, but, FYI, a Toyota dealer can program a transponder key for you.
Back to the Maint Reqd light. Here is how you reset it:
Turn the key on.
Make sure that the odometer reads "ODO", and displays the total mileage traveled...If it displays trip a or trip b, push the black button by the odometer to make the display read ODO.
Turn the key off.
Press and HOLD the black trip reset button until advised to release it.
Turn the key ON. (keep holding th reset button down)
Observe the odometer display.
you will see 5 dashes, 4 dashes, 3 dashes, 2 dashes, 11 dash, followed by five zeros, and the total mileage you started with will re-display.
Release the button.
Turn the key off.

Regarding the flashing light with the car & the key: This is the indicator to show potential theives thatyou vehicle has a sophosticated security system, and it CAN NOT be started by "hot-wiring" it. The flashing light is normal, and consumes no battery power. I hope that this helps you understand these two items better. Thanks for choosing FixYA, and the graciousness of a FixYa rating for my solution to you would be greatly appreciated. Glad to be of assistance; please feel free to call upon me anytime. Have a great day.

Nov 05, 2008 | 2007 Toyota Avalon

Not finding what you are looking for?
2002 Mazda Millenia Logo

304 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...