Question about 1997 Mercury Tracer

1 Answer

What will make my 97 tracer while driving rpms drop and car seems as if its off but still running and when i push the gas it does'nt do anything what will cause this

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 504 Answers

Check with scantool for fault code/ massairflow sensor/trottle sensor/pipe at massairflow sensor cut or letting in air

Posted on Mar 11, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 GMC Yukon Denali


Check for trouble codes. You can get this done free at most car part stores.

Aug 16, 2014 | GMC Yukon Denali Cars & Trucks

2 Answers

Why does my 1993 chevy 350 idle so low?


First clean the idle air control valve with a non-chlronated brake cleaner or replace it with a new one.If that did'nt help check your fuel pressure it should be 9-13 psi with the engine running anything less you will need to replace the fuel pump and fuel filter.

Oct 29, 2011 | 2003 Chevrolet Suburban 1500

1 Answer

I have a 1996 mustang 4.6. when i start my car it runs at 2000rpm.will finally sttle at 1000rpms after few min. the rpms will not drop when you push in the clutch. just put a new idle air control valve on...


perhaps there is a air leak at the mating surface. if you have a bottle of propane, use it to ckeck for leaks around the gasket/mating surface. start the engine. open the valve on the bottle DO NT LIGHT direct the gas around the mating surface. if the r's go up you have a leak. it is possible that since this is new, the computer was used to the old one and needs time to adjust

Feb 24, 2010 | 1996 Ford Mustang

1 Answer

My radiator fan won't turn off on a 97 mercury Tracer.


its probably a stuck relay locate it and replace it with another most likely that will cure it. check under the hood for a relay center.it should be diagrammed on the lid and use 1 from a different position first pull the one for the cooling fan if it stops that should cure it

Jul 18, 2009 | 1997 Mercury Tracer

1 Answer

1989 mercury tracer will not idle and does not stay running without pumping the gas and when you push the clutch in the rpms drop immediatly and will die if dont pump the gas and if it drops below 2000 rpm...


Is the check engine light on? I would take it to an auto parts store and have any codes read. It sounds like a possible problem with the throttle position sensor. It is located under hood, center, upper engine area, rear of valve cover, mounted on driver side of throttle valve assembly. Good luck and hope this helps.

Jul 15, 2009 | 1989 Mercury Tracer

1 Answer

1994 grand prix 3.4 very hesitant and shaky


2000 rpm is too hi if it runs their in gear should run about 1500 in park and a 1000 in gear that were mine is i have a 94 gp and if u get water in gas just put a bottle rubbing alkieholl in it cheeper and works just as well

Mar 11, 2009 | 1994 Pontiac Grand Prix

1 Answer

97 cavalier new problems


Make sure fluid level is right first and you might have to change the fluid and filter .. just an idea thanks Jerry

Jan 23, 2009 | 1997 Chevrolet Cavalier

1 Answer

Poor Acceleration on Start 97' Tracer


check your crank/cam shaft sensors - they may be faulty

Nov 19, 2008 | 2004 Nissan Maxima

Not finding what you are looking for?
1997 Mercury Tracer Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75824 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...