Question about 1986 Ford Econoline

1 Answer

I have an 86 Ford Econoline Van and the Cruise control doesnt work any suggestions?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 83 Answers

Hi ,
More than likely you have a vacuum problem either a vacuum hose is off or cracked or the vacuum servo for the cruise control is bad also check the fuses. Have a good day.

Posted on Mar 11, 2011

Testimonial: "Thank you so much and your quick response!"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I HAVE A 2002 E150 ECONOLINE VAN. THE RADIO, THE HORN, TURN SIGNALS AND ER FLASHER QUIT WORKING.


Could be a lose connection in the dash , more then likely . Who replaced the gauge an drive indicator ? The horn / cruise control /turn signals / radio all share a common ground point it looks like ,G203
G203 Behind upper LH side of I/P, near cowl
Maybe after gauge & drive indicator replacement connection became lose . None of these componets share a power supply (fuse) I can't send picture of the location of G- 203 sorry ! Instrument cluster would need to come out to see the ground .

Dec 26, 2016 | 2002 Ford Econoline Cutaway

1 Answer

Where is the engine fuse box on an '86 Ford 351


Older vehicles didn't have a fuse box under the engine. You may have a fusible link burned out, should be close to battery. Check the hazards fuse for power in the under dash fuse panel. If fuse has no power going to it, probably a fuse link.

Aug 05, 2013 | Cars & Trucks

1 Answer

I have a 1990 jayco motorhome that is powered by a Ford f-350 econoline with a 460 ci motor. I need to know which fuse is for the cruise control?


I would guess a 1990 E350 Econoline Van Owner Manual would have the chart. ISn't it on the fuse panel cover?

If you have no luck, let me know and I will try to search my archieves.

Aug 28, 2011 | Ford F-350 Cars & Trucks

1 Answer

How am I able to test an Idle Air Control Valve for a 2000 Ford Econoline Universal Van E-150 5.4L?


if you go to the trouble to remove it id suggest installing a new one if the van is idling incorrectly or abnormally high it may be faulty

Jan 19, 2010 | 2000 Ford Econoline

1 Answer

Cruise control stopped working on 1993 Ford Econoline van - can't set speed. What usually goes wrong? What should we check? Is there a wiring diagram available?


you can probably see the diagram in the manual. its a wire that runs from the steering to the throttle. make sure there is no interference with the cable.hope it helps

Mar 10, 2009 | 1993 Ford F150 SuperCab

1 Answer

1995 ford econoline van speedo/trans


It is either the speed sensor, the wireing in between ot the speedometer module it self. The sensor sends pulse train signal to the speedometer module and there it drives the speedometer and is divided in frequency by about 7 and feed to the computer and the cruise control. When the signal drops the Engine management computer thinks the speed is real slow and raises the transmission pressure.

In the one I had it was a cold solder jooint on the bacjk of the speedometer module itself but this was the divided output and the speedometer itself still worked. The easyest part would be the sensor that mounts on the rear axile I believe and should cost less than 30.00 dollars. If not that thebn it's the wiring or the speedometer module electronics..


Mar 04, 2009 | 1995 Ford Econoline

1 Answer

Flashing SRS Dash Light/ non-working cruse control


The flashing light should be giving you a code that will help determine the fault. It will be in morse code like 3 flashes then a short pause and 2 flashes.
However with your second concern that cruise control does not work I would have to say you most likely have a bad clock spring. This is a unit that mounts behind the steering wheel to make electrical contact with cruise switches and air bag.

Feb 06, 2009 | 1992 Ford Econoline

1 Answer

1998 steering clearance


I would suggest you actually contact the ford motor company for suggestions on the conversion as i believe they have a program in place for it.

Robert

Jan 10, 2009 | 1998 Ford Econoline

Not finding what you are looking for?
Cars & Trucks Logo

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...