Question about 2008 Chevrolet Impala

1 Answer

Malfunctionning gas indicator was low on

Malfunctionning gas indicatorwas low on fuel (still on 1st red indicator)filled car yesterday - gas indicator still lit(have removed and pt on gas cap again)

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 215 Answers

Its a fualty sending unit. Unfortunately its part of the fuel pump which is in the fuel tank. The only way to fix it is to replace the fuel pump assembly.

Posted on Mar 11, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why would my OBD or malfunction indicator light come on and stay on?


Check engine light comes on with faulty oxygen sensor, loose gas cap or faulty gas cap. sometimes with low octane fuel as well. fill up with high octane fuel, tighten down the cap and see if it helps.

Jul 14, 2015 | Cars & Trucks

1 Answer

I have a 2010 Grand Cherokee 5.7 Hemi. The Malfunction Indicator Light is now on, and the ECO indicator does not seem to be working, as well the remote start will start the vehicle but then it will s


Glad I am in Florida,but that does not help you!! You need to have the codes pulled to see whats going on. The light being on means the ecm has detected a fault. Hope this helps, Bill

Jan 06, 2015 | 2010 Jeep Grand Cherokee

1 Answer

2002 ford taurus check engine lite code is po460, a mechanic replaced the fuel pump, still didn't pass inspection......please help!


I am going to paste a list of potential causes for a p0460. There is a cure for a dirty reader card and Ford recommends CHEVRON TECHRON fuel system cleaner. Run tank low, put in cleaner, use best gas you can find,avoid your frequent brand.

02-06-2006 06:19 PM #2 TXFO user-offline.png Not Special Enough txfo.gif?dateline=1249691143 Join Date Jul 2002 Location New Braunfels, TX Posts 13,976 icon1.png Re: Fuel level sensor circuit malfunction (P0460)? P0460 - Fuel Level Sensor Circuit Malfunction The PCM monitors the fuel level input (FLI) circuit for electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified fuel fill percentage in the fuel tank. Empty fuel tank
Fuel pump (FP) module stuck open
Incorrectly installed fuel gauge
Damaged instrument cluster
CASE GND circuit open
FLI shorted to VPWR
Damaged PCM
Overfilled fuel tank
Fuel pump (FP) module stuck closed
Damaged fuel gauge
FLI circuit open
FLI circuit shorted to CASE GND or PWR GND
CSE GND shorted to VPWR
Monitor FLI PID and FLI V PID in key ON engine RUNNING. FLI PID at 25% fill (with non matching fuel gauge) and FLI V PID less than 0.90 volts [for FLI PID at 75% fill (with non matching fuel gauge) and FLI V PID greater than 2.45 volts] indicates a hard fault.

Jul 13, 2011 | Ford Taurus Cars & Trucks

1 Answer

I have a 94 priszm and have had to replace 3 gas tanks in the


If you have ANY DAMP SURFACE AT ALL on that Tank You DO Have a Leak and it Must be Found,
The Steal Fuel Lines around the tank Get Rusty and Leak You must ELIMINATE Any POSSIBLE Leak, as this can Turn into A Tragidy.

Jul 12, 2009 | 1992 Geo Prizm

2 Answers

Electronic gas guage fuel level indicator says fuel level low even after a fill-up


their are several possibilities sending unit is malfunctioning or a short in the wires, if 2006 is it not still under warranty?

Jul 08, 2009 | 2006 Chevrolet Trailblazer

2 Answers

95 aurora wont start


did check engine light come on? if so have codes checked there are many things that could cause this issue, cam sensor, could be one issue

Jul 07, 2009 | 1995 Oldsmobile Aurora

1 Answer

MALFUNCTION LIGHT


Are you over filling and is your gas cap tighten fully to where if it is loose it will throw a code.Your fuelsystem is pressurize and if your fuel cap is loose it will not perform correctly..Or if your over filling the tank that could also cause that problem..

Mar 31, 2009 | 2003 Honda Accord

1 Answer

98 SC2 Gas Gauge


the float in the inside gas tank is sticking

Nov 02, 2008 | 1998 Saturn SC

Not finding what you are looking for?
2008 Chevrolet Impala Logo

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...