Question about Volvo S80

Open Question

I have a 2007 volvo s80 AWD D5 the following faults have been read 1)P250 A Engine oil sensor:oil levl supply voltage too high 2)U 0322 Contol Unit Software error General Fault

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 36 Answers

SOURCE: Volvo se D5.Estate 2004 year .

press and hold button below speedo immediately switch ignition on Keep button depressed until service message has been reset release reset button within 4 seconds there will be an audible signal when reset complete if reset button is not released within 4 seconds then the service interval indicator will not be reset.

Good Luck

Posted on Sep 06, 2008

ginko
  • 19396 Answers

SOURCE: 4 Faults detected on engine diagnostics check

Try first unplugging battery cable for ten minutuse, to reset ECM, and do a scan again, there are too many unrelated error codes at the same time

Posted on Oct 06, 2008

  • 1 Answer

SOURCE: volvo s80 dashboard fault

I recently purchased a 2002 S60 D5 which had this problem. I am not a Volvo expert so don't know if it could be the same fault, but it sounds identical. No lights, gauges etc, but intermittently and very briefly comes on. Having heard some silly prices for replacement dash and ECU, I had a look. I found 4 poor soldered joints on the dash circuit board (top left processor & heat sink). I cleaned them and re-soldered them, although I had continuity just after cleaning the corrosion. The dashboard has worked perfectly since (3 weeks) . If you try this make sure you disconnect the battery first or you may have the SRS airbag warning light on! (I had to have it re-set at the dealers!!)

The whole process took less than an hour. If you are not electronically savvi get one of your mates who is to have a look..

Posted on Apr 21, 2009

  • 56 Answers

SOURCE: volvo s60 idle sensor

if you could get your hands on a scanner to read some live data it would help your plight,there is a cam position sensor when you take of the the plastic head cover at the timing belt end,did you check plugs,it also might help to clean the maf with some contact spray,sounds like plugs

Posted on May 27, 2009

REDOIL
  • 355 Answers

SOURCE: 2002 Volvo S60 with Engine fault codes

THE 445 IS THE EVAP PURGE VALVE IT MAY BE BAD BOTH 446 IS SAME VAVLE YOU NEED TO SEE IF THE HOSE ARE GOOD ON THIS VAVLE MAKE SHERE NO CRACKS IF NOT PULL HOSES AND SEE IF SOMTHING IN VAVLE ITS NEAR THE CANSTER AND THAT IS NEAR THE GAS TANK UNDER CAR PUT CHECK GAS CAP MAKE SHERE ITS TIGHT HOPE THIS HELPS

Posted on Sep 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 sensor bank 1 circuit 1 2000 Volvo S80


This is a fault for the first O2 sensor, It is important to know the added info scanners provide about the electrical fault detected (can indicate mixtures, heater circuit, slow response or plain electrical fault) Keep in mind depending on the missing info you can have an air leak from the pcv system, evap system or a small hole in the Induction/Intake hoses, What engine do you have?

Apr 24, 2015 | 2000 Volvo S80

Tip

Komatsu Fault Codes


E02 PC-the EPC system;
E03, Swing parking brake system;
E10, the engine controller power failure, the engine control drive system circuit malfunction (this engine stall;
E11, the engine control system failure (decrease of output power, in order to protect the engine);
E14, the feedback system abnormalities;
E15, engine sensors (temperature, fuel pressure, oil pressure) fault;
EOE, a network failure.
The fault code: the 989L00 the engine controller lock warning (mode 1).
989M00, the engine controller to lock warning (mode 2).
989N00, the engine controller to lock warning (mode 3).
AA10NX air filter clogging.
AB00KE charging voltage is too low.
B @ BAZG, low oil pressure.
B @ BAZK, the oil level is too low.
B @ BCNS, engine coolant overheating.
The @ B BCZK the coolant level is too low.
B @ the HANS, the hydraulic oil from overheating.
CA111, the engine controller internal fault.
CA115, the engine speed sensor and backup speed sensor failure.
CA122, the intake air pressure sensor feedback voltage is too high failure.
CA123, the intake air pressure sensor feedback voltage is too low failure.
CA131, the throttle plate sensor feedback voltage failure.
CA132 throttle plate sensor feedback voltage and low failure.
CA144, high coolant temperature sensor feedback voltage fault 145, the coolant temperature sensor feedback voltage is too low failure;
CA153, intake air temperature sensor feedback voltage is too high failure;
CA154, intake air temperature sensor feedback voltage is too low failure;
CA155, the intake air temperature is too high (over limit);
CA187, sensor power supply voltage is too high failure;

More Fault Codes HERE http://truckmanual.weebly.com/komatsu-fault-codes.html

on Dec 20, 2016 | Cars & Trucks

1 Answer

Where do you put the disc for sat nav in a volvo S80 d5 2007


See pg 13
http://esd.volvocars.com/local/us/Navigation_Manuals/2011-Volvo-Navigation-Manual-C30-S40-V50-C70-XC90.pdf

Mar 02, 2015 | 2005 Volvo S80

2 Answers

S80 will not start ran hot dont sound like its firing


have the OBD codes read as will pinpoint the sensor/switch at fault as could be a few things save you time and money searching blind

May 25, 2014 | 2007 Volvo S80 V8 Sedan

1 Answer

Transmission


check the fluid level in the gear box. Too much and not enough will cause overheating. have a pressure test done on the gear box to check for internal problems . Change the transmission fluid. . Have the bands and clutches adjusted to ensure that they are not slipping. If you are pulling trailers /caravans then the weight and speed will be factors that overheat the transmission oil. Run fault codes to check for sensors solenoids and servo faults.

Dec 10, 2013 | Cars & Trucks

1 Answer

2007 Volvo S80 won't shift out of park, where is the override switch?


starter interlock shift solenoid may be bad usually located in the center console.

Oct 14, 2013 | 2007 Volvo S80 D5

1 Answer

Oil control valve/selenoid valve


IT'S WHERE YOUR OIL FILTER IS,REMOVE AND YOU WILL SEE,IT'S WHERE THE OIL ENTER'S THE FILTER.

Aug 29, 2013 | 2007 Volvo S80 D5

1 Answer

Hur byter jag växellädsolja på


160....O2 Sensor Circuit No Activity Detected (Bank 2 Sensor 2)

P0161....O2 Sensor Heater Circuit (Bank 2 Sensor 2)

P0162....O2 Sensor Circuit Malfunction (Bank 2 Sensor 3)

P0163....O2 Sensor Circuit Low Voltage (Bank 2 Sensor 3)

P0164....O2 Sensor Circuit High Voltage (Bank 2 Sensor 3)

P0165....O2 Sensor Circuit Slow Response (Bank 2 Sensor 3)

P0166....O2 Sensor Circuit No Activity Detected (Bank 2 Sensor 3)

P0167....O2 Sensor Heater Circuit (Bank 2 Sensor 3)

P0168....Fuel Temperature Too High

P0169....Incorrect Fuel Composition

P0170....Fuel Trim (Bank 1)

P0171....System too Lean (Bank 1)

P0172....System too Rich (Bank 1)

P0173....Fuel Trim Malfunction (Bank 2)

P0174....System too Lean (Bank 2)

P0175....System too Rich (Bank 2)

P0176....Fuel Composition Sensor Circuit

P0177....Fuel Composition Sensor Circuit Range/Performance

P0178....Fuel Composition Sensor Circuit Low Input

P0179....Fuel Composition Sensor Circuit High Input

P0180....Fuel Temperature Sensor A Circuit

P0181....Fuel Temperature Sensor A Circuit Range/Performance

P0182....Fuel Temperature Sensor A Circuit Low Input

P0183....Fuel Temperature Sensor A Circuit High Input

P0184....Fuel Temperature Sensor A Circuit Intermittent

P0185....Fuel Temperature Sensor B Circuit

P0186....Fuel Temperature Sensor B Circuit Range/Performance

P0187....Fuel Temperature Sensor B Circuit Low Input

P0188....Fuel Temperature Sensor B Circuit High Input

P0189....Fuel Temperature Sensor B Circuit Intermittent

P0190....Fuel Rail Pressure Sensor Circuit

P0191....Fuel Rail Pressure Sensor Circuit Range/Performance

P0192....Fuel Rail Pressure Sensor Circuit Low In put

P0193....Fuel Rail Pressure Sensor Circuit High Input

P0194....Fuel Rail Pressure Sensor Circuit Intermittent

P0195....Engine Oil Temperature Sensor

P0196....Engine Oil Temperature Sensor Range/Performance

Nov 20, 2010 | 2004 Volvo S80

1 Answer

I have an s80 2007 d5 diesel volvo. the


I took the car to volvo garage in the morning . They found out that there was a cut cable in the engine compartment near the throttle valve.
Anyway i want to express my thanks to you for your immediate response.

Regards
George

Feb 08, 2010 | 2007 Volvo S80 V8 Sedan

2 Answers

S80 Difficult to start


Change the fuel filter. If pump is new, and you are not leaking gas from lines, than either the filter is clogged, injector stuck open

Jun 22, 2009 | 2002 Volvo S80

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...