Question about 1994 Ford Crown Victoria

1 Answer

Over drive light always blink and trans wont shift in to 3,4 gear

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,122 Answers

Hi Rod, Your vehicle needs to be taken to a shop who have the correct scan tool for your vehicle. The scan will display what part is defective. The flashing light shows the need for attention and where the attention is required. As an example; if the engine check light is flashing that unit will be the centre of the investigation. When the overdrive light flashes, the problem is with the gearbox. Regards Johngee10

Posted on Mar 11, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rodeo wont shift right from winter drive


well you need tranny service.?
right?
did you scan the PCM first to see if there are DTC errors for the trans. seem not and that is first. after.
1: checking levels in box.
2: checking fuses.


older post missed by me.

Mar 09, 2015 | 2001 Isuzu Rodeo

1 Answer

Ok so I have an 03 Dodge Neon SXT. When you first start driving the trans switches gears but hard but once u slow down nd try to go again the trans wont shift and my speedometer isnt working. Changed the...


Trans output sensor?? speed sensor maybe? Did the speedometer start working? This is where you have to start. Important feature for shifting. This is electrical and checking wires for continuity. If it always goes in gear and drives, I would look hard at replacing the solenoid package. It's on the front side of the transmission. Costs around $300. You have to remove the cooler lines, a sensor, and 3 bolts to remove it. Clean it, around/behind it first. You absolutely do NOT want any dirt getting in the holes on the transmission.

Dec 11, 2014 | Cars & Trucks

1 Answer

1994 trooper trans light blinking took it in shop did a trans flush filter,gaskit and tran oil change. but this is the thing trooper misses and tran hold back but when shop checks computer reads nothing...


check out the neutral saftey switch on trans, if its reporting unknown gear on scanner while moving t bar it wont know what gear to be in and give you similar problems, also has oil been leaking into switch before?

Feb 17, 2011 | 1994 Isuzu Trooper

1 Answer

I have a 2000 GMC sierra 2500 truck. The guy I bought it from had a new transmition put in it. After driving a while I noticed that the tranny wouldn't shift into low gears 1st & 2nd on comand. and...


-----check possible tps [throttle position sensor ]circuit for damage or faulty sensor----if good check the fuses and trans harness for shorts damage or disconnection,check o2 sensors wiring possible ground to exhaust ,or internal leak 2nd gear apply circuit[servo assembly or 1-2 accumulator] or poor pump pressure

Feb 13, 2010 | 2000 GMC Sierra

2 Answers

I have a playmouth grand voyager 1999 3L,my transmission will not shift up in gear.On drive or reverse it goes well but will not shift.I think it could be an electrique problem,cause the transmission looks...


Your trans is stuck in safe mode, you are only using 2nd gear, this means it is not shifting but staying at a gear so you will not damage the trans. This is an electrical setting , however usually comes from the computer receiving bad information , rough shift, however it can be reset. Remove the positive battery cable for 30 minutes then see if it shifts, also check your fluid level, it can go into safe mode from low fluid if you made a turn and the trans slipped from low fluid . If your trans goes back into safe mode again have it checked, most important, do not drive over 45 mph or allow your rpms to raise over 3 , I have seen many motor problems that spawned from this type of trans problem, if not corrected.

Good Luck

Aug 16, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Wont shift into high gear the over drive is not working


check to see if your overdrive light lockout light is blinking if so you have intrenal trans problems

Jul 08, 2009 | 2001 Ford F350 Super Duty SuperCab

1 Answer

Trans wont shift into over drive on 1992 chevy 5.7 liter k1500


Do all the other gears work fine? Shift point at the right time? 1 to 2, 2 to 3, What speed does it shift 1 to 2 at light throttle? These are good for having stuck TV valves or broken TV cables. Does it **** when it shifts or when you put it in gear?

Apr 08, 2009 | 1992 Chevrolet K1500

1 Answer

Shifting when warm


take your s-10 to a reputable trans' shop NOW!!
you have an internal problem,BUT if you'r lucky,it may just be the "range switch"on the side of the trans(hair dryer needed to heat the "goo"-sealer on the harness plug)

the trans' is in "limp(default)mode,just to keep you moving!!
driving it this way for a month WILL destroy the transmission!!

Dec 15, 2008 | 1999 Chevrolet Blazer

1 Answer

Gear Position light D4 is always flashing irrespective of gear.


This issue is caused by a transmission fault or malfunction, most likely a shift solenoid in the trans has failed or the trans control module has a problem, the trans can be tested for codes that will show what circuit or component of the trans controls is causing the light to stay blinking, have it tested.

Dec 12, 2008 | 1995 Honda Accord

1 Answer

TRANS IND LIGHT BLINCK AFTER ENG HOT TRANS WONT SHIFT UNTIL TURN ENG OFF


How is your transmission fluid? Check the level of your fluid while the engine is running.

Aug 04, 2008 | 1995 Honda Accord

Not finding what you are looking for?
1994 Ford Crown Victoria Logo

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...