Question about 2001 Isuzu Rodeo

1 Answer

My elec. Ign. fuse blows every time you turn the key on and I have looked for a shorted wire no visible burns. what else could make this happen

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 878 Answers

Use a higher amp fuse

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 ford edge. How to replace the starter. System shorts out all electrical lights and displays when engaging the starter


Hi, now if im getting what your laying down... whwhen key goes from ign. To start ,it by design cuts off most elec. Systems i.e. lights stereo etc. to give the starter as much amperage as possible. Now you say its shorting out, it would be blowing fuses or burning. I dont think your starter is issue. Btw, are you using the "chipped"key if you are not your ride will shut down and not start. Hope that helps.

Oct 07, 2016 | 2008 Ford Edge

2 Answers

50A IGN Starter SW/ Starter fuse blows every time I start the vehicle


Run a jumper from the fuse connection to the starter

Nov 13, 2015 | 1998 Dodge Durango

1 Answer

My 2000 Toyota Camry am2 fuse blows when I turn ignition on


If the IGN fuse is not also burned, likely there is a shorted ignition coil or grounded ignition coil power wire. If the IGN fuse is burned then look for a possible shorted light bulb

Mar 25, 2015 | 2000 Toyota Camry

1 Answer

New starter and battery, and no power on a 2003 Toyota Corolla


I am not familer with this exact car but 2 things to look for, Many of the Jap cars have a main fuses. usually located near the battery, ina small fues box there will be a wire that attaches to the positive batt cable that goes to this little fues box It usually powers the IGN circut which powers the starting circut. .. on Americsan cars they use a fuseable link which is a piece of wire that burns out when a live positive wire is shorted out. in place of burning the whole wiring harness. its easy to see this problem since the wire will be burnet in half..

Being that this happened tells me that you have a short probably at or near the starter.that is blowing the fuse or burning the fuseable link. Look for this short or it will just burn out the fuse again.

May 12, 2014 | Toyota Corolla Cars & Trucks

1 Answer

Ford 99 Taurus ignition fuse keeps blowing every time key is turned


A bad something, yes.
The fuse may be the primary fuse for the key switch. If it is, you would need to disconnect the key switch harness and check for a short to ground on each circuit.

Jun 01, 2013 | Ford Cars & Trucks

1 Answer

1997 jaguar xj6 passenger side engine bay fuse box fuse # 10 IGN control (low current) 5 amp blows as soon as turn the key then the battery drains and car dies what is happening and how do i fix it. Also...


I think your thumbler is shorting and blowing the fuse..; replace the tumbler..

your ignition is wired to the tumbler.. if thats shorting it will explain your issues.

May 24, 2010 | Jaguar XJ6 Cars & Trucks

1 Answer

Reverse light fuse blows when put into reverse


Unfortunately, many possibilities. If you have time, start by removing both reverse lamp sockets from light assembly(and keep from touching any metal), remove bulbs from sockets, CAREFULLY INSPECT sockets and wires. New fuse of correct rating. Turn key on and try again in reverse.
Fuse still blows: Next place to look is transmission reverse electrical switch and wiring as far as you can trace looking for burned/stripped wires near transmission and wires by sockets
Fuse doesn't blow: Turn key off and install one lamp in socket at a time. DO NOT install sockets into fixture at this time. Test. Remove first lamp to check second. If still O.K., each socket back into fixture(one at a time same as before)and test. Most common problems: Sockets contaminated, wires shorting at sockets, bulbs installed incorrectly shorting to ground.

Sep 25, 2009 | 1996 Ford Explorer

1 Answer

97 Dodge 2500 wiper fuse


this sound like the wiper motor auto wiper parking is shorting out and so with ign turned on this causing fuse to blow ? if motor has a short wire to earth on exterior ? usually brown ? this is auto park cut or disconnect then ensure you have correct amp fuse and see if fuse blows? if yes then provided the elec plug connector for motor is in good condition ? may well be motor has a fault on armature to earth? hope this helps

Nov 06, 2008 | 2007 Dodge Ram Truck

1 Answer

2003 isuzu rodeo blows engine ign fuse when key is turned on


This is definantly a wiring problem, first of all you will need to check the wiring to your ignition and your starting system to see if you can visually see any wires that are shorting out on something metal or with another wire. Check the wires going to your starter, your coil, your altenator, and remove the cover on your steering column and check there as well then start looking under the dash. If you have had any sort of accident then check for damaged wires in that particular area. If there has been any electrical work done to your car then check in this particulararea as well. in the mean time you should get a breaker to replace the fuse with as when the breaker blows it will actually reset itself after a few seconds as it cools off ( while it trips and cools off it will click ).This may help as you have someone turn the key you my be able to see where the wire is sparking as it shorts out and it will save you money on fuses as you diagnose your problem. Wiring can be very difficult and time consuming to locate where the actual problem lies. Good luck I hope that this helps you and remember to rate all solutions that you get, thanx.

Oct 30, 2008 | 2003 Isuzu Rodeo

Not finding what you are looking for?
2001 Isuzu Rodeo Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...