Question about 1993 Subaru Legacy

1 Answer

Where is the water pump located on a 93 legacy 2.2 liter

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

Behind the timing belt cover... it is driven by the timing belt.... if you are standing in front of the car it will be just below the a/c compressor and to the right .

Posted on Mar 11, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to change waterpump on 93 subaru 2.2 liter

Big job.. Strip to and remove all cam belt covers etc. then remove water pump and replace. Check out and replace belt and tensioners and idlers as required while there. Get a manual..

Nov 11, 2012 | 1993 Subaru Legacy

1 Answer

I have a 93 subaru legacy and my water pump is leaking how much will that cost to fix?

Really depends on what else you may want to do at the same time, like the timing belt etc. At least four hours labor at most shops plus the parts.

Feb 17, 2011 | 1993 Subaru Legacy

1 Answer

I am needing to replace the fuel relay switch on my 1996 subaru legacy outback, where is it located?

my car wont start ive changed plugs and fuel pump and now ive been told it could be the relay switch but dont know where it is of if it is that any suggestions and my car is a subaru impreza 93

Jun 06, 2010 | 1996 Subaru Legacy

1 Answer

Overheats replaced water pump and thermostat no combustion gases found 1997 legacy 2-5 liter

We just did the same car with the same prob. The block was cracked and was pressurizing the cooling system causing the thermostat not to open. Remove your thermostat and run the car if it doesn't overheat you need a motor. Ours didn't show any hydrocarbons in the coolant either, so try the simple

Dec 14, 2009 | 1997 Subaru Legacy

2 Answers

Water pump location on 93 dodge dynasty 3.0 v6

The water pump is located behind the timing belt cover and is run by the timing belt itself.This is a big job good luck:)

Aug 31, 2009 | 1992 Dodge Dynasty

1 Answer

Legacy lacking power and using lots of fuel

Are you sure its the transmission ecu that is the problem ?
Are you getting any engine ecu error codes ?
Sounds to me like its going into limp home mode.....
Crankshaft sensor ?
Camshaft sensor ?
Engine ecu ?
Thats where I would be looking ........
Looking forward to your reply.

Jun 29, 2009 | 1993 Subaru Legacy

1 Answer

Overheating 93 Subaru Legacy

water pump could be bad again. if the seal is out lets air in around pump propeller and it won't move water and it over heats. its a lot of work but you can fix it your self

Dec 16, 2008 | 1993 Subaru Legacy

Not finding what you are looking for?
1993 Subaru Legacy Logo

Related Topics:

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides