Question about 2005 Nissan Xterra

1 Answer

Oil pressure gauge moves right below high when i accelerate

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that gotĀ 5 achievements.

    Master:

    An expert who has achieved Level 3.

    Sergeant:

    An expert that hasĀ over 500 points.

  • Master
  • 461 Answers

Replace the oil sending unit

Posted on Mar 11, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What to check when oil pressure gauge flucuates while driving a jeep cherokee


To verify there is a problem, remove the oil pressure sending unit, replace it with a test gauge, start the car, idle, accelerate etc and watch the gauge for any abnormal variations it should react to evry change in acceleration and not be below the minimum or above the max as per the service specs.

Aug 14, 2014 | 2000 Jeep Grand Cherokee Laredo

1 Answer

Oil pressure gauge


oil pressure sensor, low pressure due to dying pump. or blown gasket causing the pressure to leak out. Check the easy ones first like the sensor. Good luck

Nov 08, 2013 | 2004 Dodge Ram 1500

1 Answer

95 jeep wrangler. 4 cyl engine. Oil gauge normal with engine idle but reads high if accelerate goes all the way up


Do you have under drive pulleys? If so, you can expect that to happen. It does not mean that something is wrong. You may have a high volume oil pump too. I have under drive pulleys on my Camaro and the oil pressure and voltage readings go up. I have never had a problem with that. I would worry when the oil pressure gauge does not move at all $$$$$$.

Aug 04, 2012 | 1995 Jeep Wrangler

1 Answer

The oil pressure gauge in my Bronco 2 suddenly dropped to zero after fluctuating from below zero to mid range while accelerating. Checked oil level and was fine. Can I still drive it? About 130 miles away...


You need to verify that you actually have oil pressure before continuing to drive. It may only be the sender or the gauge, but you need to verify oil pressure. The sender is on the right side of the engine block, remove that,pull your coil wire so the engine won't start, and crank it over. If you have oil pressure, oil will squirt out of hole.

Jul 13, 2011 | 2002 Chevrolet TrailBlazer

1 Answer

My 1989 Ford Ranger 2.3L 2wd has a problem in the oil pressure area. The pressure gauge at idle says normal but when accelerating it goes past Low. I replaced the pressure sending unit and it didnt...


I would take the sender out and install a temporary manual gauge (we use a manual SW gauge connected to a 3' length of 1/4" high pressure hose). If the oil pressure is normal on the manual gauge then about the only thing left is the gauge itself.

Apr 16, 2011 | Ford Ranger Cars & Trucks

2 Answers

OIL PRESSURE GUAGE, IT SHOULD BE STABLE?


bout the oil pressure gauge its normal to go up but not to high coz u might overheat, try checking the cylinderhead gasket if there is pressure coming out, replace the gasket if needed

Jul 15, 2009 | 1999 GMC Yukon

3 Answers

Oil pressure gauge moves too much


Have your oil sending unit checked, this part is not to expensive

Jun 16, 2009 | 1994 Jeep Cherokee Country

1 Answer

1993 Jeep Grand Cherokee, V6. Oil Pressure Gauge Read High.


it could be the sensor you should look at the oil pressure relief valve

Jun 10, 2009 | 1994 Jeep Cherokee

1 Answer

92 cherokee very high oil pressure


sounds to me like you have a bad oil pressure sinding unit

Feb 02, 2009 | 1996 Jeep Cherokee Country

1 Answer

1992 jeep wrangler oil pressure goes off scale while accelerating


try replacing the oil filter and oil make sure u use the right grade oil for it if it still does it u need yo go to mechanic or if u have one connect a external oil pressure gauge to the engine to check if the car gauge is reading correctly if it is reading right then the oil pressure releif vale is stikking

if the car gauge is reading wrong change oil pressure sender

Dec 20, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
2005 Nissan Xterra Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75235 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...