Question about 2004 Chevrolet Avalanche

1 Answer

Abs light came on ,now hear like what sounds like apump running. next morning battery was dead .it ran all night.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,608 Answers

This is your electronic brake control module(ebcm).This is the module for the anti-lock brake system.The module is located on the inside of the frame just below the drivers seat area.The problem is the electrical part of the module.This is the top part of the module and you don`t have to disconnect any brake lines.It also isn`t in the easiest of places to work in.The 4 screws that hold it down are torx head screws and being in the area that they are in it can be difficult to remove because of rust.The other thing is this module is not cheap.If you don`t want it to drain the battery and don`t want to fix it right away then you can just remove the abs fuse in the under hood fuse panel.But you will not have anti-lock brakes.Just the regular brake system.If you do decide to replace it make sure you clean the area very good before starting because you don`t want dirt to get into the module when you take off the top part.Remember do not undo any brake lines.The fuse is a maxi fuse this means it is one of the big ones.Hope this helps.and let me know if you have any more questions.Good luck.

Posted on Mar 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

BATTERY DRAINING WHILE SITTING


Hello Michelle, You could take it to a mechanic to test for a voltage draw . Make sure the glove box light is not on steady.

Dec 21, 2015 | Cars & Trucks

1 Answer

1996 Plymouth breeze .put in used battery ran well .next day dead. Charged up . Ran again check engine light stays on door light stays on fuel gauge moves to different positions Help. Thanx left ove


I fail to see how you do not believe you have a
failed battery,the used one

Buy a new battery with the correct Group Size for the
car & at least 700 CCA rating

Napa top of the line with NO Caps on top, would be a
good choice

Look on napa web site.they are made by Penn Battery

BAT 8475 690 CCA $112.37

Nov 10, 2014 | 1996 Plymouth Breeze

2 Answers

1998 pontiac sunfire manual. Car starts but sputters and then dies and is completly dead but in the morning will start again and then die. I changed the coil pack but still the same. what can it be?


You can't do any testing, until you have a battery
that will take and hold a charge

Then you move on to testing the Alternator,then
Fuel Pressure & continue on with other testing

Apr 04, 2013 | 1997 Pontiac Sunfire

1 Answer

03 avalanche power keeps on drawing from somewhere and in the morning its dead. I will jump it and it will run fine!


are you leaving anything plugged in, cellphone charger, radar dector, emergency lights, cb, etc, if so unplug all of it that will kill the battery, if not the case, you got a short somewhere

Jan 14, 2013 | 2003 Chevrolet Avalanche

3 Answers

Cranks but won't start like it has no gas


did you reset the alarm/immobiliser system every time the power was disconnected???

May 21, 2010 | 1997 Volkswagen Jetta

1 Answer

ABS light stayed on; now I have a dead battery.


My best bet would be a short in your cracked plug which is probably energizing your braking unit the whole time which runs your battery down. I would, if you have the knowledge and sills disassemble the plug on your truch and see if you can spot the damage. Disconnect your battery first.

Jan 04, 2010 | 1998 Volvo V70

2 Answers

99 passat 2.8, vehicle was driven the night


That code is a Throttle Position Malfunction code.

This means one of two things:
1. The throttle body needs replaced
2. After the dead battery, you need to adapt the the throttle body.

The cheap way to do this is to leave the driver's door open, turn the key to the on position, but do not start the car. You will hear the throttle body self-adjust. This may take up to 2 minutes. That should get it close enough. To get it perfect requires a trip to the dealership.

If it does not help, the throttle body might be dead.

Dec 18, 2009 | 1999 Volkswagen Passat

1 Answer

Battery drain on 1990 Ford Tempo


HELLO CHARGE THE BATTERY UP AND START THE CAR AND PULL THE POSTIVE CABLE OFF THE BATTERY IF IT SAYS RUNNING YOUR ALTERNATOR IS WORKING BUT IF IT DIES THE ALTERNATOR NEEDS TO BE REPLACED

Mar 01, 2009 | 1990 Ford Tempo

Not finding what you are looking for?
2004 Chevrolet Avalanche Logo

379 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...