An expert who has achieved level 2 by getting 100 points
An expert who has answered 20 questions.
An expert that has over 10 points.
An expert whose answer got voted for 2 times.
Re: TURNING SIGNALS DONT SEL-CANCEL HELP!!!!
I had a similar problem with my 2000 mercury cougar i changed out my wiper switch and that didnt fix it i changed out my windshield wiper motor and it was good to go, i would suggest looking at the unit that has a holding circuit possibly the blinker relay for the signal light
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
there is a cancel spring in the steering wheel that when the wheel comes back it pushes the signal switch to the off position.when these get worn/broken they stop turning off the signals.the only way to fix this is to pull the steering wheel off to gain access to the switch to either fix or replace the switch.
This is common for the turn signal/multifunction switch to do this. They have little plastis tabs that are hit when the steering is turned to cancel the signal. If those tabs have worn down or broken, the switch continues to work but will not cancel. Replace the switch if this is a major annoyance to you. Let me know if you need instructions or diagrams.
Raise the tilt wheel to the upper position
Remove the lower philips screws securing the upper and lower clamshells on the column.
Release the top and bottom clamshells from one another by pressing together where they meet.
Unplug the electrical connector from the back of the turn signal stalk
Early 2000 eclipses:
Remove two philips screws bolting the signal stalk base to the column
Late 2000 eclipses:
Squeeze the top and bottom release levers to release the signal stalk base from the column
Pull the stalk and base straight outward to remove from the column.