Replaced speed senser on 1996 plymonth breaze speed omiter still wont work and car will not shift out of low gear

A speed sensor would make it shift different (Harsh shifts, long shifts) but wouldn't kill the engine. I would check the pressure of the fuel. Low pressure could be the pump or the regulator.

not likely some cars have a nylon gear around diff but dosent give trouble often. try fuses, wiring and clocks in that order

Sure you can if a mechanic can do it so can you if you have the right tools and knowlege. First you need to know which one thers's one at each whell at the fround rear end housingf the rear rear end housing and the one in the side of the transfer case where the speedometer cable would'of connected on an older model and then theors three in the sides of the trans mission, Touque converter speed forward turbine speed output turbine speed. What proble are you trying to fix? the speedometer not working? Abs light on? Cheack engine light on? Cruise control not working? If the cruise control does work the speed senser is good and the check engine light will be on if the speed senser is'nt working. If the speed senser is'nt working the car will only take off in low and not shift to seecond or any higher gear as the computer doesn't know how fast the car is going. If the speedometer is'nt working and it does shift and cruise and the check engine light is'nt on then the speed senser is working but the speedometer is'nt if it is'nt and everything else is woring then as your driving hit the speedometer with your fist and see if it comes back on they can get stuck and i've fixed quite a few and they stayed fixed. On to wheel drive models with the rear wheels jacked off the ground safty I've run the car up to speed and trying wiggleing the wires and connectors till I wiggled the right thing till the speedometer came on ( including smacking the speedometer ) Just don't hit it too hard as it'll bust just like anything else.

The transmission is shifted with a computer. The computer needs input signals in order to make a shift decision, There are three speed sensors (input,output,and vehicle speed) that must work for a shift to be comanded. I wouldrecomend you sheck for stored codes and check the vehicle speed sensor.Is the speedo working?

If it shifts normally and then it warms up and goes backwards OK and the check enigine light works and isn't on while driving the trans has the right fluild and it's not low then the trans has bad troble. If the check engine light is on find and fix the reason Speed sensers Theres 3 leaks burnt fluild correct and see if its fixed the engine needs to run right and hit the right temperture as it runs. otherwise an expensivew rebuild is next or a used transmission.

I am looking for a diagram that shows were the speed sensor is located on the transmission.Of a 96 Grand Caravan.

You sure its the transmission? Wheezing sound is usually the catylitic converter becoming plugged. Also...at 3-5K rpm you are not idling, you are reving the engine...(in that case, trans may be slipping or flairing between shifts, unless the unit is staying in one gear and just delaying shift till you reach that rpm. actual shift point should be close to 2,000rpm) I'd check the cat first.

need to find leak and fix . tranny oil pan gasket .torque converter seal.side pan gasket .leak where speed sensor.or governor.need to fix keep driving low.burn out clutches bands and drums

two issues here. this may be a low fluid issue. i would check the level of the fluid first. the next issue could be a blown shift solenoid. these are located inside of the transmission pan.also, check the filter as well.(transmission filter could be clogged)

Replace your input and output speed sensers. They each cost 12.50 at Chrysler dealer. They can give you a diagram as to where they are located. Easy to do.