Question about Pontiac Bonneville

1 Answer

Ignition torn apart will start but then dies - Bonneville Pontiac Cars & Trucks

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Replace the ignition with a useed one from a wrecking yard.

Posted on Jul 31, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Blower motor/ac doesnt come on at any setting. Tried a new blower motor, new resistor and new relays. Very frustrating, I have the dash torn apart now to see if its a problem with the cluster/switch or...

is there anything ells not cigarette lighter. etc. there is a relay to start from ignition feeds power from a low volt system to a high volt system for the blower motor. usually a long black relay with 2 small connectors and 2 large connectors some have 3 small ones.

Aug 23, 2013 | 2003 Chevrolet Cavalier

1 Answer

My oil cover was loose and all my oil drained so in the middle of the road the car died. I tried to start is it cranks but wont start and i dont know what the problem is it is a 2002 daewoo lanos hatchback

first thing we need to chek for is spark in ignition system,fuel psi, injector trigger from ecm(noid lite action) and finally if we have all these u need to chek engine compression in the cylinders. very possible u could have a torn timing belt.

Apr 08, 2011 | Daewoo Lanos Cars & Trucks

1 Answer

My husbands F250 started having problems this week. When he would turn the truck off to go in somewhere and come back out it wouldn't start. It is a stick, so if he was on a hill he could get it started....

the ignition module is what it sounds like to me.... with the heated module functioning sporadically.
The bucking like a horse and dieing indicates a timing issue though.
are you getting any codes?

Jul 16, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

91 Dakota, Dead short on ignition switch circuit. Red wire shows ground along with the blue wire. Both 40 and 50 Amp fuses blew. Have torn the whole truck apart and even replaced the ignition switch and no...

Remove the feed wire from the switch. Short gone?
If it has it is after the switch, if not the cable feeding the switch is probably trapped and been damaged. Follow it back to the feed point.

Sep 05, 2017 | 1991 Dodge Dakota

1 Answer

Starts buts dies instantly ! how do i reset

You may have damaged the chip inside the key fob. If you are using a new key it won't let you use it without the small chip located in the small part of the key lock assembly on the flip key end. If you have purchased and cut a new key you can take this old module apart remove the chip and put it in new assembly or tape it beside the ignition. The dealer is your only other choice, good luck.

Nov 20, 2009 | 2000 Volkswagen Beetle

1 Answer

Someone tried to steal my 2002 mazda b2300

You'll need a new ignition switch. After installation, the dealer can either reprogram your old keys or you can buy a new key and have it programmed.

Jun 11, 2009 | Mazda B2300 Cars & Trucks

2 Answers

89 bronco II stars then dies

if the fuel pump cutoff was tripped it would not start at all, I know this for sure, I am a Ford dealer tech and I specialize in no starts and check eng lights. If the ignition switch is bad the 2 halves of the switch will be starting to come apart, it is very common, u should be able to either see it or feel it with your hand.

Jan 08, 2009 | 1989 Ford Bronco II

1 Answer

Car starts, then dies within 2or3 seconds.

Try this start eng and before it dies disconnect the starter solenoid, and hold the ignition in the crank position like you are starting it, if the engine remains running replace the ignition switch, they come apart and cause this issue

Sep 20, 2008 | 1996 Lincoln Mark VIII

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides