Question about 1989 GMC Sierra

1 Answer

Blew the transmission ,...installed anew {used} transmission, now nothing is moving, everything seems to be connected corrertly by eyesight, is it possible that i created a airleak along the lines?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Did u fill up the fluid???

Posted on Apr 06, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Everything was fine, put it in park, about 20sec later the engine just stopped. No misses, no surges, nothing. will not re-start.

Its hard to say for sure .It could be a feak thing that something went when you shifted it into park .
But the last thing was to shift to park .Their is a switch you could check on the side of the transmission called the interlock switch its directly hooked to the shift coloum and it moves everytime you move the level.Tells the computer what mode the transmission is in .
Try moveing the lever aroud play with it a bit .The switch is located on the drivers side of the trany towards the front of the trany mess with the electrical connecter to it wiggle it around see what happens .It may start if it dose replace the switch .If it dosn't start it may still be the problem .
I know this because I also have an S10 and have had similar problems with mine
PS its a pain to replace but not hard to get at .

Mar 30, 2015 | 2000 Chevrolet S-10

1 Answer

I have a 2000 Jaguar S Series that won't disingage from park to any gear??? Car runs won't come out of gear ???

Check the obvious first. Is the fluid in the transmission at the correct level and the correct type for the car? Does it smell burnt ? Move on to the mechanicals. Is the linkage that controls the transmission operating? On to the electricals. Do all the connections to the transmission seem intact? Any missing connections? Burnt wires? If all the above appear to be correct then the trouble lies inside the transmission.

Jan 18, 2015 | 2000 Jaguar S-Type

1 Answer

How do you fix transmission? transmission over heated, blew out fluid. replaced the fluid,then move it. went forward some then nothing. wouldnt go reversed at all.

When the trans overheats and blows the fluid out of it, the trans has suffered damage, as you have found out by the no-movement you have now. You need to find a trans shop to have it rebuilt.

Jun 01, 2014 | 2003 Ford Explorer

1 Answer

Automatic transmission will not engage gear

Sounds like the transmission is gone .Check the fluid level ,and sometimes the filters inside the transmission gets clogged up.have it checked by a qualified transmission mechanic.

Jan 05, 2014 | 2007 Chevrolet Chevrolet Equinox LT

1 Answer

My 1999 honda civic si 4od light is flashing why

The light flashes whenever the electronic transmission control unit senses a fault in the system controls of the transmission. You need the computer tested by the dealer or a shop with a special tester.

Aug 24, 2012 | Honda Cars & Trucks

1 Answer

New rebuilt Transmission,now have starting problem?

was the neutral safety switch adjusted try moving the shifter slowly threw the gears while turning the key that wilol show you YOU MUST KEEP YOUR FOOT ON THE BRAKE THE TRANS MAY NOT BE IN NEUTRAL WHEN THE SWITCH IS

Aug 11, 2012 | 2002 Chrysler PT Cruiser

1 Answer

1996 pontiac grand prix

i have one of these cars i love it but and the transmissions GM used in them are not good at all there is a pin in the differential that has a tendency to slip out and the car will not move..happened to me but i was blew the transmission so hard the gears shot right out of the bottom of the cost me 1500 dollars to replace might be luckier because it dident blow up like that i would call some transmission places and tell them whats going on and get an estimate..

Oct 27, 2008 | 1996 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides