Question about 1994 Chevrolet G20

1 Answer

Back up lights don't work - 1994 Chevrolet G20

Posted by on

  • channels123 Dec 29, 2008

    back up lights dont work i checked fuse they are all good lights are hooked up and bulbs are good.

  • armyjoejr Jan 11, 2009

    My back up lights do not work either. Same thing bulbs are good and fuse is good

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 37 Answers

With test light,make sure you are getting juice to the b/u lamp sockets.if no power,check at fuse.if power there,problem may be in nuetral safety switch or harness

Posted on Jan 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1991 celica and for some reason the front signals does not work at all. When I turn on the blinkers it blink really fast on both sides but hazard light works fine it blinks normal but it...


check the main earth wire near the battery. and one near the rear of the lights. unbolt them and clean the connectors up put some grease on them after. then check again. remember that when the earth wires come off the radio code will be needed to reset the the radio. be safe and take the battery off.

Sep 28, 2013 | Cars & Trucks

2 Answers

Dodge Caravan break lights in back don`t work


do they work if you put on the head lights. ? do they work when you step on the brake pedal?

Jan 04, 2013 | 1999 Dodge Caravan

1 Answer

How can I figure out why fuse 15A keeps blowing? My dashboard lights don't work nor do the back lights. My breaks and signals work but at night when I turn the car on the regular lights in the back...


There is a shorted wire somewhere in that circuit. Check to see if any wires are pinched under a bracket or brace where he was working. I have seen it where it was a light bulb the was bad. Need someone familiar with a volt/ohm meter to help trace problem. Good Luck. You did not state where he had been working.

Apr 17, 2012 | 1996 Honda Accord

1 Answer

Back lights don't go on


Left hand side of the transmission is the back up light switch on the top jump the 2 wire if the back then works replace the switch

Mar 07, 2012 | 1997 Land Rover Discovery

1 Answer

The head lights are on but the back lights don't


Open the boot, then remove the cover of the back light then replace the bulb.

Sep 25, 2011 | 1989 Toyota Camry

1 Answer

I have a 1998 Ford Expedition, and the licence plate lights don't work. I've replaced the bulbs. I don't have an owners manual so don't know which relay switch to change. Can anyone help?...


Hi, there is no relay, and the plate light run off the same fuse as the tail lights. The problem must be in the wiring or sockets in the back of the truck.

jturcotte_1910.gif

Jul 04, 2011 | Ford Expedition Cars & Trucks

1 Answer

Now power to the trailor hook up on back bumper, fuses are O.k. wiring apears to be o.k. it is dodge ram 1500 4x 4 single cab c/w 4.7 8cly. be nice to get a wiring diagram. thanks Wayne


you will need to check the wiring under the bumper where the trailer wiring is with a test light and with the different lights working.you will probably have to move back in the wiring by 6" and retest until you find were the loss of power is.you don`t say if all the lights don`t work or just certain ones.the brown wire is the tail light,green is the right signal light,yellow is the left signal light and white is the ground wire.you could have broken wires at the trailer hook up itself.

Mar 22, 2011 | Dodge Ram 1500 Cars & Trucks

1 Answer

Left side brake and hazard lights don"t work


sounds like a bad turn signal switch, wiggle it , just a little bit,... see if some of the lights start to work. do your turn lights work correctly??

Dec 02, 2008 | 2000 Chevrolet Lumina

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...