Chrysler was in a fender bender. THe front left light and blinker was damaged need to be complete replaced. Cannot find anyone who carries the light for this model.

Minor fender bender ? Where , front , rear etc.... Could have damaged wiring harness , sometimes GM mounts the PCM - engine computer behind fenders , body parts etc...

you have obvious short in the wiring - check the bulbs first, then the wiring. it is rarity to exchange relay - if it was not physically damaged during accident.

No such device. It sounds like you are not getting fuel. Try this:
* disconnect the battery for about 30 seconds. This will reset the ECU, which causes it to re calibrate the engine management.

Check if the ECU is throwing any sort of error code.

Your fender bender may have damaged some wiring, or the repair may have left something disconnected.

try the fuses or wire fuse links , the only other thing in the circuit is the wires broken or the light low switch is bad

check to be sure your 'Fender bender' didn't break the electrical connections to your starter, or any other wiring under the hood. be thorough

Has the car been in a fender bender ? check for wiring going to the front and rear lights to see if on has rubbed into a ground wire or the body. ( even if there has been no accident.)

There may not be a sensor in that very location where the damage is but it may have been enough to trigger at least one sensor. The thing to do would have a shop hook up a scanner and see why the light is on instead of replacing sensors. Usually it takes more force to trigger a sensor inside the car than it does to trigger and outside sensor. And at least two sensors need to trigger before an airbag is deployed.

It is very common for all of these lights to come on all at the same time. They are all related to your Antilock Brake and Traction control system. ABS = Antilock Brake System, TRAC OFF = the traction control system is disabled - either because there is a malfunction in the ABS system or you have turned off the traction control button. VSC = Vehicle Skid Control. - (which uses the ABS and the Traction Control to function.)

The most common cause of these lights coming on is one or more defective wheel speed sensors. Although there are many other possible causes as well. Your ABS and Traction Control system must be scanned for fault codes to diagnose the problem. If you had damage to your wheels/axles during your "fender bender" this may have something to do with it. Otherwise it may just be coincidence that part of these systems failed right after your accident.

The DTC (Data Trouble Code) P1491 for Chrysler-Jeep is for the Radiator Fan Control Relay Circuit, and the radiator fan control relay is located between the radiator and the AC condenser, and there is the possibility that a collision could have damaged the radiator control relay or the wiring. Here is an image of a chrysler radiator control relay to help assist you.

Left side or right side Front bumper mount bracket.
click on link to see part.
http://www.amazon.com/Mounting-BRACKET-Passenger-1993-1997-Corolla/dp/B002SDNF6I