Question about 2000 Chevrolet Impala

1 Answer

Heater control botton works only on number 5 how can i fix it

Posted by on

  • Anonymous Aug 06, 2008

    i have the same problem with my air control it only work,s on 5



1 Answer

Need a new blower resistor switch -- about $20 at AutoZone. I just replaced mine.

Posted on Aug 30, 2008


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 56 Answers

SOURCE: heater/ac controler dial don't work

The Blower Motor Resistor is a common problem in the style GM vans, its located just to the left of the blower motor, which is under the passenger side of the dash, behind a carpeted panel. Costs about $26 for the part and can be changed in about 15 minutes. Chances are the blower motor is fine, and the switch is usually ok on these!!

Posted on Feb 09, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Block heater installation on 2012 toyota corolla

if the cores are blocked the the only fix is to replace it with a new one . C heck first that the heater controls and the hoses are working and clean.

Apr 03, 2014 | 2012 Toyota Corolla L Sedan 1.8L 4-cyl....

1 Answer

Equinox wiring

see the diagram attached, and fix it. 1) horn button, 2) horn 3)horn relay 4) horn 5) wires loose or corroded. God bless you

Jul 17, 2013 | Cars & Trucks

1 Answer

All dashboard/ center console lights out.

Test the dash first. Put key in hold down trip reset botton. Turn the key to on but don't start. Release the trip botton. Should turn on all dash lights & check for codes in the odometer. If getting codes reply back.

Feb 11, 2010 | 2004 Dodge Caravan

1 Answer

2005 Lincoln LS. It blows extremely hot air all the time, and is unresponsive to temperature inputs from either side of the car. It always blows hot air.

There is a very good chance the Dual Coolant Control Valve has failed. This is located at the botton right side of the engine fan shroud and has 3 heater hoses connected to it. This valve controls heater or AC temperature inside the car.

Jan 05, 2010 | 2002 Lincoln LS

1 Answer

My heater does not work,inside of the panel show well, botton up,

I'm not an expert, but I took my 2000 Lincoln Nav to the shop and they told me the issue is that my accuator is not opening properly to allow the heat to go through; therefore, it's overheating. That's why I can feel some heat on the front in the back. All vents, including the rear vent blows strong, but they blow very cold.

Unfortunately, I'm also having an issue with my engine intake manifold or intake gasket being cracked causing anti-freeze to leak out of my tailpipe and smell badly through the vents - even on defrost - so until that's fixed, I'll never have heat.

Nov 12, 2009 | 2000 Lincoln Navigator

1 Answer

Heater motor only runs on high

Replace the heater blower resistor.

Dec 26, 2008 | 2002 Pontiac Grand Prix

1 Answer

No hot air from heater, fan works, air conditioner works

Check and see that there is heat in both heater hoses going to and from your heater.It is shows that you are getting a flow through the heater core.
If the hoses are not both hwarm then you may have restricted flow either in the hoses, the control valves or in the core.
I they are both warm then check the following.
I had a cold car that the hoses were reversed on and the hot water was going into the top of the heater core. I solved the problem by reversing the heater hoses to have the hot water going into the core on the botton and returning to the motor thru the top line.
Good Luck

Aug 10, 2008 | 1985 Ford F150

1 Answer

X5 -alarm system can't be activated

I press the remote control middle (BMW) botton, one time to set up the alarm, when I release the alarm, I press the one above the
BMW botton one time, this botton control driver side door too, if I want to open other three doors, I have to repress the same botton one more time.

Hope this can help .

May 17, 2008 | 2002 BMW 5 Series

Not finding what you are looking for?
2000 Chevrolet Impala Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides