Question about 1990 Buick Century

1 Answer

The power windows in the front doors do not work. Window on passanger side goes down several inches, but will not go up. Have relaced motors and switches in both. what's causing problem and how can it be fixed?

Posted by on

  • 1 more comment 
  • Anonymous Nov 16, 2008

    how do i fix the windows

  • psionic1011 Nov 29, 2008

    windows fell apart need a diagram

  • codyhicks Dec 13, 2008

    my front left door window ont go up or down

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check the black rubber boot that protect the wires coming out of the driver door going in under the dash...move the boot around while trying to roll up the window and see if you get anything ..if so , you have a broken wire inside the boot..

Posted on Dec 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Passanger window wont roll up from driver side or passanger side


Replace the regulator. It comes with the motor. You have to remove the door panel to access it.

May 26, 2015 | 2006 Kia Sorento

1 Answer

Front passenger window only goes up. front passenger door switch or driver door switch only operate window up. all other windows fine.


if you make a fist and hit the door on the inside about the middle of the door card HARD while holding the button and it goes down -you have a bad regulator motor- if that doesn't do anything it may be the swicth in the passangers door but i really suspect the motor-cheers Denny

Nov 03, 2013 | 2000 Ford Expedition

1 Answer

My passanger front window is stuck in the down position. Could this be the window switch?


The same thing happend with my 94 lesabre. I thought it was the switch but i realized that the switch was fine. I went at the junk yard and got my self a power window motor. That is proboably what is wrong with your windows. I recommend that you get yourself new or used window motors and that sould do it!

Best of luck

Oct 10, 2012 | 1994 Buick LeSabre

1 Answer

Rear passanger side window won't go up or down


Window regulator most likely but before changing it out take the door panel off and apply current to the contacts of the actualy regulator. If the window goes up then switch the contacts and now it will go down. If nothing then regulator (window motor) is bad. If it works then your master control switch for all the windows is going bad.

Aug 30, 2012 | Cars & Trucks

2 Answers

2000 ford f250 passanger side window wont go up


Check the wires on the driver's door between the door and the post. A break in a wire will affect the passenger side.

Apr 04, 2012 | 2000 Ford F250 Super Duty Crew Cabs

2 Answers

My mazda 3 power window switch not working on master switch,but the other are working.except on front left hand poer window switch


I have a 2005 Mazda 3. The driver's side power window won't go down...the other 3 windows do (from the left door power switch). When I try to open the driver's window, I hear a noise...maybe like a motor switch?

Sep 24, 2010 | 2005 Mazda 3

1 Answer

How to relace power window motor


Motor
  1. Raise the window glass to the full-up position if possible. If the glass cannot be raised and is in a partially down or full-down position, it must be supported so that it will not fall into the door well when removing the window motor.
  2. Disconnect the negative battery cable.
  3. Remove the door trim panel and watershield.
  4. Detach the window motor harness connector.
WARNING

If the front door power window regulator counterbalance spring must be removed or replaced for any reason, make sure that the front door power window regulator arms are in a fixed position prior to removal to prevent possible injury during c-spring unwind.


WARNING

If the front door power window regulator counterbalance spring must be removed or replaced for any reason, make sure that the front door power window regulator arms are in a fixed position prior to removal to prevent possible injury during c-spring unwind.

// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 32; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]> var _strTreeScrollHidName = 'ctl00_hidTreeScrollPos';

  1. Remove the three window motor mounting screws.
  2. Remove the window motor.

To install:

  1. Position the window motor to the power window regulator. Install the three screws snugly but do not tighten all the way.
  2. Attach the window regulator electric drive wires at the connector and cycle the door window glass to make sure the motor gear engages. After the gears are engaged, tighten the three window motor retaining screws to 54-88 inch lbs.(6-10 Nm).
  3. Connect the negative battery cable.
  4. Check the power window for proper operation.
  5. Install the door trim panel and watershield.
// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 32; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]> var _strTreeScrollHidName = 'ctl00_hidTreeScrollPos';

Sep 13, 2010 | 1998 Ford Taurus

1 Answer

Help me with my window


The right side is the passengers side does the window go down using the drivers side switch? If it doesn't work from either side switch its probably the power wire going to the down side of the switch. Check for power at the Wire on switch both sides and make sure you have power going to both up and down side, Sometimes the wires get broken in between the door and door jam, By getting pinched, Hope that helps ya out Thanks

Jun 17, 2008 | 2003 Chevrolet Venture Passanger

Not finding what you are looking for?
1990 Buick Century Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...