Re: My 2007 Yukon's Entry light wont come on at all.
Look on the left side of the stering wheel and there should be a switch that is for you foglights. On that same switch under the fog light switch there is a button for all entry lights on or off. Just hit that button.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Insert your key into the ignition. Turn the key forward until it can go no further, without starting the vehicle.
Press and hold the "Valet/Override" button located under the
dash. Hold the button until the blinking LED light on your dash is
solid. Switch your "Valet" button to "Off" if you have a button labeled
"On/Off." Your alarm should now be reset. If you wish to enable the
alarm, repeat these steps to turn the alarm back on.
Remove wires from your battery if you wish to temporarily
turn off your alarm. Disconnect the wire connected to the main power
source to permanently disarm your alarm. Trace all wires connected to
your battery and disconnect them. If you have no familiarity with your
vehicle's wiring, you should take your vehicle to a neighborhood
installer to disconnect the wires for you.
Its on the screen - if I remember correctly, you go to the Nav menu and you'll see a "main menu" button (it may say "settings") on right hand side (forgive me I am doing this from memory)... press the button, it will give you the "set clock" option; select daylight savings time or whatever corrects your settings and it will move the hands automatically
Check the buttons.. I have an 06 Grand Prix with the Remote starter on the top and it seems that the conductor on the buttons worn out.. Take the keyfob apart, pull the rubber buttons off the chip, lick your finger and touch the place where the unlock (right side of the fob) would be. That should unlock your doors. I just did it with mine. I would just buy another fob on ebay and change the buttons out.. Hope this works
It sounds like the brake switch, that is usually located along the shaft of the brake peddle under the dash, these sometimes are in a bracket for ajustment may not be able to depress switch. Falow starting at peddle go up to dash, you should be able to see it. Hope this helps.