Question about 2000 Mazda MPV

1 Answer

Change the water pump - 2000 Mazda MPV

Posted by on

  • 1 more comment 
  • Anonymous Nov 25, 2008

    I need help with changing a water pump

  • bigjoeacpro Jan 09, 2009

    i need to locate and replace my water pump.

  • Anonymous Mar 10, 2009

    same problem

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What are the symtoms when a waterpump going bad for a 2000 Mazda MPV?

Posted on Nov 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is water pump fuse located


If your water pump has failed you will simply just have to change it.It does not have a fuse and a rule of thumb is change the water pump when you change the timing belt at 60000 which is the correct interval to change the timing belt and you already have easy access to change the water pump also.

Oct 20, 2013 | Honda CR-V Cars & Trucks

1 Answer

I would like instructions on changing a water pump in 2005 Chevy uplander V6 3900


This is probably the easiest water pump of all vehicles to change.


c0ebf96b-78f3-4862-ba77-ee445584a574.gif

Water Pump Replacement

Removal Procedure



  1. Drain the cooling system.
  2. Loosen the water pump pulley bolts.
  3. Remove the drive belt.
  4. Remove the water pump pulley bolts and pulley.


  1. Remove the water pump bolts, pump, and gasket.
  2. Clean the water pump mating surfaces.
Installation Procedure



  1. Install the water pump gasket and pump (1).
Notice: Refer to Fastener Notice in Service Precautions.

  1. Install the water pump bolts.
    • Tighten the bolts to 10 Nm (89 inch lbs.) .


  1. Install the water pump pulley and bolt until snug.
  2. Install the drive belt
  3. Install the water pump pulley bolts.
    • Tighten the bolts to 25 Nm (18 ft. lbs.) .
  1. Fill the cooling system
  2. Inspect for leaks.

Aug 18, 2013 | Cars & Trucks

1 Answer

2000 FORD EXPEDITION OVERHEATING....changed thermostat,radiator cap, confirmed fan clutch is working, no radiator leak noted, changing coolant temperature sensor as a type...water pump not leaking or...


yes. the impellor on these engines have a tendency to come off the water pump.First you can see if the pump is working by removing a heater hose then have someone to start the engine. if the water sprays a good, solid stream out then the water pump is good. if the water just barely comes out or not at all then the pump is weak or "bad".

Aug 13, 2011 | Ford Expedition Cars & Trucks

1 Answer

I have a 2003 pontiac grandam with a intake gasket leak. I am planning to have it fixed but i have advised to change the water pump also. I am having no water pump problems is that advisable to do.


CHANGE WATER PUMP WILL SAVE YOU SOME MONEY, TO CHANGE INTAKE GASKET HAVE TO DISAMBLE PART OF YOUR ENGINE , AND IF YOU NEVER HAVE CHANGED YOUR WATER PUMP IT WIL PREBENT FUTURE PROBLEMS. BUT DOESN'T MEANS THAT YOU NEED TO CHANGE WATER PUMP.

Feb 17, 2011 | 2003 Pontiac Grand Am

3 Answers

Do you have to change the water pump when changing the timing belt/timing?


You don't have too, but not bad idea, the timing belt drives the water pump, if you just replace timing belt, and not water pump, water pump could go out and mess up the timing belt, now it has to be done all over again, timing belt, water pump and labor.

Sep 16, 2010 | 1996 Subaru Legacy

4 Answers

2003 kia rio- water pumps


I would follow the mechanics recommedations. I think he's taliking about the cam and crankshaft seals. Yes the water pump should be replaced as well. The pump that sprays windshield washer fluid onto the windshield is called the windshield washer pump. The water pump is on the engine and pumps water (coolant/antifreeze) through the engine to the radiator and heater core.

Oct 29, 2009 | 2003 Kia Rio

1 Answer

Water pump housing problems


your pump wep hole, bad pump not pep boys fault :( sorry just need water pump.

Sep 08, 2009 | Toyota Camry Cars & Trucks

3 Answers

Do I change water pump when having timing belt changed


I would go to auto zone and get a diagram and the timing belt and do it yourself and the water pump (no it does not have to be changed everytime the timing belt is changed but if the car has over 60,000miles then it is best to change them both) it is not that hard especially if the car is not out of time just make sure you disconnect the negative side of the battery

Jan 21, 2009 | 2001 Hyundai Elantra

1 Answer

How to change a water pump on a 1999 Buick Century 3100?


the water pump on the 3.1 isnt to hard to change ...
  1. Disconnect the negative battery cable.
  2. Partially drain the cooling system into a suitable container.
  3. Remove the drive belt guard.
  4. Loosen the water pump pulley bolts before removing the drive belt. This should help keep the pulley from turning as the bolts are loosened.
  5. Remove the drive belt. Remove the water pump pulley bolts and remove the pulley.
  6. Remove the water pump bolts and separate the pump from the engine front cover.

Dec 09, 2008 | 1998 Buick Century

1 Answer

Leaking water pump


leaking water pump was standard for that year.
Changing it without changing of taking of the cam belt shouldnt be a problem. but wen u get the new water pump make sure it the same cause in changes from serise 1 to serise 2

Oct 17, 2008 | 1994 Mazda 626

Not finding what you are looking for?
2000 Mazda MPV Logo

Related Topics:

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...