Question about 2000 Jeep Wrangler

1 Answer

When you turn the ignition the car cranks about 8 times before it starts. The battery and starter are fine.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 372 Answers

Could be a idle air control motor. Or a temperature sensor. I have seen either cause this issue

Posted on Jul 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

99 mustang won't start it only do 1 click. If it


Battery good, cables good, all connections clean and tight, no corrosion on battery terminals?
Try to determine if click is from solenoid on the starter or starter relay. Turn the headlights on and watch them while someone turns the key to start. If they get dim, probably the starter-have it tested-even new ones are sometimes bad. If lights don't dim, you will need to check the start circuit. Check for power on the small wire to starter solenoid when key is held in start. If no power there, work back towards the ignition switch. Check the neutral safety switch-should have power in and power out when key held in crank. The ignition switch will have a start wire out of the switch going to the neutral safety switch. It should have power with key in start, the only time the start wire will have power.
Post back with what you find-good luck.

Sep 25, 2013 | Ford Mustang Cars & Trucks

1 Answer

I have a 2001 honda civic if i try to start it without pressing the gas pedal which seems to be sticking it will not crank it makes no noise whatsoever


Low fuel pressure or problem with spark plugs or crank sensor is got dirty and needs cleaning or its time to replace crank sensor.


Check out the help links shown below for no start problem and cranks but no start problem.


Click the link :-----

It can be the issue with weak battery or faulty battery or if battery is ok,then its faulty starter causing the issue.


From start to end troubleshooting these problem i suggest you to click the link below and follow its procedure:-----



What to Do When Car Turns Over But Won't Start?

http://technoanswers.blogspot.com/2012/11/what-to-do-when-car-turns-over-but-wont.html


-----------
Car starting issues?

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

------------
Car Starting Problems

http://whoisbyme.blogspot.in/2012/06/car-starting-problems.html


--------
1991 Toyota Trecel: Engine Starts fine but dies when gets Warm?

http://whatisbyme.blogspot.in/2012/05/1991-toyota-trecel-engine-starts-fine.html

----------
1994 Toyota Pickup: Starts fine but dies in few seconds?

http://howtobyme.blogspot.in/2012/05/1994-toyota-pickup-starts-fine-but-dies.html


---------
1999 Chrysler Cirrus: 8 IGN Fuel Starter Fuse Blows?

http://whatisbyme.blogspot.in/2012/06/1999-chrysler-cirrus-8-ign-fuel-starter.html


-----------
2001 Toyota Camry: No start After replacing Battery?

http://whatisbyme.blogspot.in/2012/05/2001-toyota-camry-no-start-after.html

----------
1989 Toyota Pickup Truck: Turns over but not start? http://whatisbyme.blogspot.in/2012/05/1989-toyota-pickup-truck-turns-over-but.html

--------------
Car dead and will not Start? http://whatisbyme.blogspot.in/2012/05/car-dead-and-will-not-start.html

--------
1995 Lexus LS400: Running Hot?

http://whatisbyme.blogspot.in/2012/05/1995-lexus-ls400-running-hot.html


----------
2001 Toyota Prius will not start? http://whatisbyme.blogspot.in/2012/05/2001-toyota-prius-will-not-start.html

---------
1996 Jeep Grand Cherokee: Engine will not start? http://repairhelpcenter.blogspot.in/2012/06/1996-jeep-grand-cherokee-engine-will.html ------------- Mitsubishi will not start

http://www.howtorepairguide.com

---------

These will help.

Thanks.

Nov 25, 2012 | 2001 Honda Accord

1 Answer

1995 t-bird v8. Starter will not crank, clicking noise coming from possible relay behind right headlamp. Battery is good and lights are bright no dimming when key is turned


The Ford V-8 they use in both Crown Vic and T-Bird are good for losing the solenoid to the starter. Replace that first before looking for a new starter.

Apr 17, 2012 | Ford Cars & Trucks

2 Answers

I drove my 1999 accord EX to work & 8 hrs. later I tried to start it and it did nothing. Tried jumping still nothing. Put new battery on and it still did nothing.What is the problem?


Hi, diagnosing a no-start condition requires a logical approach to figuring out what might be preventing your car from starting. First, if the engine won't even crank over when you turn the ignition to START, your car obviously won't start.
When you turn the ignition key to start your car, voltage from the battery flows through the ignition switch to the Park/Neutral safety switch and/or brake pedal or clutch pedal safety switch (you have to push the pedal down before the circuit will complete) to the starter relay or solenoid. When the relay or solenoid is energized by voltage from the ignition switch circuit, it closes a contact that routes more power from the battery directly to the starter to crank the engine. The starter motor spins, pushes the starter drive gear to engage the flywheel and cranks the engine.

If the engine fails to crank, there is a fault in one of the components in the battery/ignition/starter circuit.

Ten Reasons why you car won't start..
  1. Low battery (Check battery voltage, recharge if low, or jump start with another vehicle or battery charger).
  2. Loose or corroded battery cables (Inspect, clean and tighten BOTH ends of BOTH battery cables).
  3. Bad starter relay wiring connections or ground connection (Inspect, clean, tighten wiring connections).
  4. Bad starter relay/solenoid (Check for voltage at relay, if relay has voltage but there is no "click" when key is turned to start, replace relay).
  5. Bad starter (Jump battery voltage direct to starter to see if it spins, or remove starter and have it bench tested at auto parts store).
  6. Damaged starter drive or teeth on flywheel (Remove starter and inspect drive gear and flywheel teeth, replace damaged parts if necessary).
  7. Bad ignition switch (Check to see if voltage reaches starter relay/solenoid when turn to start. If not, check for open P/N switch and brake or clutch pedal switch. Replace ignition switch if defective).
  8. Open P/N safety switch, or open Brake Pedal Safety Switch (automatic transmission) or open Clutch Pedal Switch (manual transmission). Bypass switch with jumper wire to see if engine cranks, or use test light or voltmeter to check for voltage passing through switch when ignition is turned to start.
  9. Engine seized due to bearing failure or internal damage (Use socket and long handle to see if engine can be turned by hand, if not engine is locked up).
  10. Engine hydrolocked due to coolant leak from leaky head gasket (Use socket and wrench to see if engine rotates, remove spark plugs and see if coolant comes out or engine can not be cranked with plugs out).

Hope it helps identify and solve the problem

Jan 16, 2011 | 1999 Honda Accord

2 Answers

When I insert key to start the car it will not turn at all. What is this part called?


The component is a starter. When you insert your key into the ignition and turn it, you switch on the power to the coil and vehicle computers. By turning the key to the start position it will supply power to the starter and solenoid which cranks the engine until you release the key allowing to return to the ignition on position. If the battery is weak the starter solenoid may engage producing a clicking sound, but it will not crank the engine. Another test is to turn on the dome light and try to start the vehicle, if you see the dome light dim when you are trying to start the car the battery is weak or the starter has a short. Starters are temperamental at times and can be intermittent working sometimes and malfunction other times. Your ignition switch, fuse, or relay could also produce symptoms of your vehicle not cranking.

Jul 21, 2010 | 2004 Chevrolet Cavalier

1 Answer

2002 GMC Envoy, i put the key in ignition and vehicle will not start sometimes and other times is starts fine. we have checked the starter, battery and battery connections, all fine. Changed the starter...


Ignition switch and neutral safety switch. Next time it happens wiggle thekeys in the ignition switch and try to restart.If it starts its probably the ignition switch. Then locate neutral safety switch on brake pedal and put meter on B+ wire from switch to starter relay and see if you get B+ on the would -be- crank. Next locate B+ wire from starter relay to starter hook a meter to it and see if you get B+ on the would -be crank.
Where ever B+ is missing is your problem.

Apr 14, 2010 | 2002 GMC Envoy

3 Answers

I have a 2000 toyota avalon ignition problems


Hello I have simular problem the ignition on is stuck in that position with the key turned off and out of the ignition switch.It feels like the key switch is spinning freely in the ignition. Do I need an ignition switch?

Nov 13, 2009 | 2000 Toyota Avalon

2 Answers

Ignition and/or starter problem.


Immobilizer armed its self

May 29, 2009 | 2005 Toyota Matrix

1 Answer

Turn ignition to crank and nothing happens??


find the starter or ignition relay and replace it... generally either on the fuse panel inside the car or the fuse panel located in the engine compartment.

Robert

Dec 17, 2008 | 2000 Hyundai Sonata

1 Answer

99 Saturn SC2 will not crank


Hi,

If I understand you right, the problem is at certain times the engine will not crank, that is turn over when you turn they ignition key to START. And at times it will start and run normally. Offhand, I would discount the possibility of the Ignition Module. To my knowledge it has nothing to do with cranking the engine but rather providing the spark at the plugs through the coil.

Having said that, might it be that the issue is with the starter system. The starter system is initiated at the ignition switch when the key is turned to start. At this point, the ignition switch then provides +12VDC to a starter relay. The relay is but a remote switch with slightly higher amperage capacity. The starter relay then engages and supplies +12VDC to the staring solenoid. The starting solenoid then performs two (2) functions. It provides the switching action (hundreds amps) from the battery heavy cable to the actual starter motor. The solenoid likewise pushes a small pinion gear along the shaft of the starter motor to engage the ring gear. The ring gear is of course on the edge of the flywheel which in turn is attached to the crankshaft.

Starter system problems could be corrected by:
1. check battery, battery cables and connections;
2. charge the battery if required;
3. clean brushes and guides of brush holders of the starter motor;
4. clean the commutator and commutator segments;
5. check/replace the armature or field coils if determined to be defective;
6. in some extreme cases it could be the drive pinion or the flywheel gear ring is defective.
7. often it is the big switch that the solenoid activates that looses contacts causing no +12V internally to the motor.
8. Most likely would be a defective starter relay or the IGN switch itself. Relative to this, you might try and check the connectors/terminals and electrical joints.

In the picture below, the upper portion is the starter solenoid while the one below it is the actual starter.
c9b6a69.jpg
Given the amount of work to overhaul a starter, you might consider just replacing it. This page might be informative.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

May 30, 2008 | Saturn SC2 Cars & Trucks

Not finding what you are looking for?
2000 Jeep Wrangler Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...