I have a 91 Camry that has the passenger side door was replaced with a power window style door. All the other doors are manual. I have the pigtail coming out of the door-with nothing to plug it into. If I could get a wiring diagram-I could wire it with a 30 amp inline fuse-but I don't know what wire is for what function..
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
more than likely one of the switches are bad (down side of switch works but up side of switch dont) being as the switches are wired together if one goes bad other one won't work either take the switch out one of back doors should be same as front passenger door put rear switch in front passenger door if works then u know front door switch is bad if it doesn't then drivers door switch is bad u replaced window regulator Did that come with motor too??? if not check to see if motor is good there is two wires going to motor cut isolation back on wires and using some jumper wires attach one wire to positive terminal of a 12 volt battery attach other wire to negative terminal of battery window should move up or down reverse connections and window should move other way
To remove mirror pry off inside triangle panel(black) which exposes 3 nuts which are removed with socket wrench. Detach wire harness and pull out mirror assembly. To replace insert new mirror screws thru assigned holes and reconnect wire harness and tighten nuts to snug. Push inside triangle panel back into place and you're done! It's that easy.
No won't be fuse. My guess is there is something faulty with the main controller. You could probably verify this by trying the switch on right rear passenger door. If it works there then the problem is at the main controller in the driver door. Could be a loose wire or the switch itself is broken.
ok. first u remove the door panel(s), with the window rolled up, u will be able to see the back side of the exterior door handle. there will be three bolts, they are size 10metric. there is also a rod attached to the handle held in place by a plastic clip, remove the rod, then remove the three bolts. from the outside remove the exterior door handle being careful not to scratch painted surface. Repeat for the other door(s). Repeat this for installation.
It is rare that the power window relay will fail. Personally, I would look to see if there is power at the master switch on the driver's door. Anywhere. If the is NO POWER, you have a broken wire between the door & the LF kick panel where the wires come thru the body into the door shell. If there is power, the master switch is narmally the culprit
I'd bet on a broken wire in the harness going to the drivers door. I suggest the drivers door because it is used the most often. You can pull the master switch and check the wires for continuity to the harness just under the dash at the fuse box, after removing the lower dash trim panel. Sometimes you can gently pull on the wires of the door harness from under the dash and one will pull right out. Thats how I found mine.