Question about Jaguar XJ6

2 Answers

Can the starter inhibitor by by passed on an xj6

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi can the inhibit switch stop it starting on a s type jag

Posted on Oct 31, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 42 Answers

No you will short your car out

Posted on Jul 30, 2008

  • geoff buck Aug 13, 2012

    why your only looping to make the circiut ????

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine will not crank in park or neutral starter is ok


check or isolate auto inhibitor switch and see if that works.if it does,get a new inhibitor switch

Mar 18, 2015 | Cars & Trucks

1 Answer

Where is my starter located


PASS SIDE OF MOTOR IN THE REAR BOTTOM OF ENGINE COMPARTMENT.

Nov 14, 2013 | 1985 Jaguar XJ6

2 Answers

I have a 92 sentra lights come on but when i turn key nothing happens. Starter good ,relay good, head lights don't dim when you turn key . Car won't turn over at all


If by lights, you mean the dash lights come on, then ignition switch must be getting power. If dash is not working with key on, check the 30 amp fuse link which powers the ignition switch.
If switch is good and starter is good, the start wire from switch goes to, if automatic, to inhibitor relay (the park/neutral function) and then to starter. There is also an inhibitor switch on the shifter or on the transaxle that turns on the inhibitor relay when key is on and shifter in park or neutral. The inhibitor switch is powered by a 10 amp fuse D.
If you have a manual transmission, the start wire from ignition switch goes to the clutch interlock relay and then to the starter. This relay is turned on by the clutch interlock switch on the clutch pedal.
You can check for power on either relay, the inhibitor relay or the clutch interlock relay, with a test light. Pull the relay out, have the key held in start position. Now both relays would have power showing on two terminals where the relay plugs in. If inhibitor relay only has power on one terminal or no power at all, either ignition switch is not sending power or fuse D is out or the inhibitor switch is not working right. If clutch interlock switch does not have power on two terminals either the ignition switch is not sending power or the clutch interlock switch is bad.
If the relay checks are good, check for power on the small wire to starter with key held in start. If you have power there, the starter solenoid must be out.

May 08, 2013 | Cars & Trucks

1 Answer

I turn the key nothing happens? I have new battery, I put in a new starter, all the lights and bells work. The starter has been tested it'"s new. I changed ignition relayy switch still nothing It...


I have a 93 pathfinder SE 4X4 automatic transmission that had full power, new starter and battery. Sometimes it will start and sometimes not. By passed starter relay by adding push button start and it started 6-8 times then nothing. I finally figured out that it was the neutral safety or inhibitor switch on the 4 wheel drive shifter. Just an idea..good luck

Jun 20, 2011 | 1993 Nissan Pathfinder

1 Answer

Find inhibitor relay cannot find it


The starter inhibitor relay is located in the relay box just behind the headlight on the driver's side. It is Nissan part 25630-9662 and has six pins. There are two normally closed contacts that turn off cruise control when you start the engine. The other contacts are normally open and close to energize the starter solenoid when you start the engine. Power for the relay coil must pass through the transmission reverse/neutral safety switch when the transmission is in Park or Neutral. This switch is located on the side of the transmission and is reached from underneath on the front, driver's side. (Remove the plastic protective covering from underneath the engine in that area-it has about 10 screws.)

Dec 05, 2010 | 1993 Nissan Sentra 4 Door

1 Answer

The car will not start or even turn over


check battery leads/both/starter solenoid is situated under bonnet at the firewall just under where the two bonnet stays meet check solenoid operation if not clicking check inhibitor switch operation otherwise starter motor needs overhauling

Aug 25, 2010 | 1993 Jaguar XJ6

1 Answer

1996 Jaguar xj6 starter will not turn over


Lock your doors with key and hold until the alarm activates, then unluck car and start

Jul 15, 2009 | 1997 Jaguar XJ6

1 Answer

Starting problem


SOURCE: Kia Technician Times
TITLE: A/T Inhibitor Switch
APPLIES TO: 95-00 Sephia
SERVICE TIP:
CONDITION
Some 1995 thru 2000 Sephia Automatic Transmission equipped vehicles may exhibit the following inhibitor switch concerns: - The vehicle may not start intermittently in park or neutral. - The vehicle TCU may intermittently lose the gear position signal from the inhibitor switch and go into failsafe mode (third gear). If the inhibitor switch signal returns while driving, the TCU will return to normal transmission control. The vehicle will then upshift or downshift abruptly depending on vehicle speed. - The TCU will set a pending OBDII code and then after two key cycles, the MIL light will come on and the O/D light will flash.
CAUSE
Corrosion/dirt on the inhibitor switch connector terminals or internal contacts.
CORRECTIVE ACTION Replace the inhibitor switch with P/N KFW35-21-444 and carefully adjust per procedures in the applicable service manual.
Note: The 1998-2000 Sephia Service Manual has an error on page 42-104 inhibitor switch inspection/adjustment. The connector terminal chart should show terminals 5 and 7 having continuity in neutral. The correct inhibitor switch terminal locations are shown below.

I Hope this Info Corrects Your Problem Please Don't Forget to RATE Me ! Thank you

Feb 09, 2009 | 1999 Kia Sportage

1 Answer

XJ6 1991 JAG . STARTING PROBLEM


inhibitor switch on the blink,heavy steering ??this could be a variety of things,that need a hands on so i would suggest calling a mobile mechanic

Nov 18, 2008 | 1994 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...