Question about Bentley Continental

1 Answer

I was on vacation and came back and discovered the hood of my Bentley has small dents. About how much would that cost me and would my insurance cover it?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 286 Answers


Expect you have had it fixed by now,? as I see your post is July O8.

If the vehicle was parked outdoors, I expect the damage was due to a hail storm, with large ice balls forming.
When they hit your car, denting of the body panels, and broken screens can be caused.

We have this problem here in Spain, and it is quite common.

This should be covered in you insurance policy, providing you are fully comp.

Good Luck.

Don´t forget to give me a rating please.


Posted on Jan 21, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I check transmission flued in a 2006 Bentley flying spur

With a Bentley you would take it to the Bentley dealership :>)

Lift the hood and look for the dipstick. There is one for the engine and one for transmission which normally has a clip to hold it down.

For the reason I stated first, there are no videos except for Continental.

Apr 29, 2016 | Bentley Cars & Trucks

1 Answer

Bentley GTC 2007 hood is closed but light on inside of car indacating that it's open , how can I get the light to go off

There should be a switch the hood comes in contact with, much like a door switch for the interior lights. That switch may be broken or stuck.

Aug 27, 2012 | Bentley Continental GTC Cars & Trucks

1 Answer

Bentley gt bonnet release

Pop opens the hood
Pull or push the hood release until you heard the hood pop opening whether the hood release is inside your vehicle. However, you need to look anywhere for 2013 Bentley Continental GT W12 and through the grill, carefully feel under the grill and finally behind the bumper to find a lever, arm, button or handle if the hood release is apparently at the front. And then press, pull or push it from the front to back, side to side until finally it can release the hood.
Even though the hood will just open a tiny, it will possibly be stopped by a safety catch which is a metal lever. You should release the hood when you pressed one way or other in order to open all the way. When you are driving, this gizmo accidentally avoids opening the hood.
Raise the hood fast with one hand
Feel along the station between the grill and the hood for the safety catch with the other hand. The rest of the way is to release and raise the hood.
If it is necessary, secure the hood
It is fine if the hood can stay up easily all by itself for 2013 Bentley Continental GT W12. Only if it does not like that, you should have to find a hoop prop which is a thin and long metal rod attached to the bottom edge of the opening hood or to the underside of the hood. In other words, either lift or lower the rod and fit the finishing of it into the slot which is provided to hold it.

Mar 03, 2012 | Bentley Continental GTC Cars & Trucks

1 Answer

Hi i got a 2009 bentely continental gt went on vacation got back and batteteries are flat replaced them but car wont still crank

  • I have never done any Bentley work. However from what you are saying I would suggest locating the junction box under the hood. This is a relay and fuse box. Pop the lid and on the under side is the legend for the panel layout. Look for the main fuse as this fuse will stop everything. I also suggest you look for any relays marked for the "ignition." Sounds like one of the relays for the ignition of that main fuse are bad. For about any car I would start with this after replacing the battery.

  • There is always the possibility of this being the starter just went out too but this can be tested before replacing but check the panel box first.

  • If you have the owners manual you can look up the exact location of them as well.

  • Hope this helps.

Nov 02, 2011 | Cars & Trucks

1 Answer

My 87 nova has small dent in drivers door, broken side view mirrow and mirrow frame hardware broke off where it attachs to car door, insurance adjuster says car is total loss, car has lots of miles but...

Providing that the only damage is as you listed, the reason it has been classified as a total loss is because of its age. Can't give you a $ amount but if the accident was not your fault, generally insurance companies are fairly generous with what they offer. If the post where the door latch pin is located is not twisted, I'd keep the car and get another complete door at a local scrapyard (older cars may be difficult to find but if you try hard I'm sure you will find one.) It isn't that difficult to hang another door on there and a replacement shouldn't cost much more than $100..
Good luck!!

Feb 10, 2011 | 1987 Chevrolet Nova

1 Answer

Front Grill and Hood Damage - Repair Costs

do your insurance will cost more then that

Apr 14, 2010 | 1995 Nissan Quest

1 Answer

Dodge ram 1500 power steering

your insurance company should take care of the repairs or his whomever was at fault either way either the power steering casing is broken causing a leak or a break in the line itself or the belt snapped open the hood and visually look and see what is leaking or the tire could even be rubbing at times without seeing it i cannot say for sure ....but let me know what you discover

Sep 24, 2009 | 2000 Dodge Ram 3500

1 Answer

How do I remove the back bumper (plastic) on a 2003 toyota camry?

you can heat the bumper heat gun ( you can rent one i think?)
this will soft the bumper so you push it out easily on the car

1. inside your trunk remove small back clips in trim panel
2. remove tail lamp four 8mm nut perside unplug wires
3. remove black clips under tail lamps ( flat head screwdriver to pull center of the clip up slowly then remove the hole clip)
4. three if the some clips are bottom if the bumper
5. three or four 10mm nuts in side the quarter panel on the right and left side
6.four s shape clips are top bumper that will pull loose
7. with some help slide bumper by pulling it off it
8. when you reinstall the bumper you may need to tape the strophe reinforcement in place

Feb 24, 2009 | 2003 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bentley Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers


Level 3 Expert

64034 Answers

Kirk Augustin
Kirk Augustin

Level 3 Expert

2019 Answers

Are you a Bentley Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides