Question about 1995 Dodge Caravan

1 Answer

98 caravan no abs

Front brakes lock up and overheat after driving for about 20 min
after mastercylinder was replaced
replaced front brake pads rotor calipers brake hoses proportioning valve
still happened
replaced rear wheel cylinders and when bleeding them have to push very hard the brake pedal to get it to the floor

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 251 Answers

U need to bleed ur brakes some more Helping one person at a time Shaun

Posted on Nov 15, 2008

1 Suggested Answer

  • 422 Answers

SOURCE: 98 caravan no abs

sounds to me if you replaced all of that than the power booster is sticking

Posted on Oct 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put new brake pads on the front and now i dont have a full pedel of brake.The abs light and traction light are both on


how much brake fluid did you remove or put brake shoes on wrong reason abs light on.check brake fluid.when replace front brakes you have make sure mastercylinder reservoir corver on then pump brake pedal seat brake shoes against rotor then check brake fluid level.

Dec 27, 2012 | 2000 Chrysler Concorde

3 Answers

2004 Dodge the longer you drive the tighter and hotter the brakes get.


all dodge caravans from 2002 through 2011 have known problems with sticking calipers. if you google caravan brake problems you will see all the complaints. there are TBI's and recalls on them. I have a 2005 dodge caravan in my garage with all 4 calipers locked up. It is a good idea to replace the brake pads with the best ones and new rotors to

Dec 13, 2012 | 2004 Dodge Caravan

1 Answer

Rear rotor replacement for a 1985 mercadies benz 500 sel


YOU NEED TO SAFELY RAISE SUPPORT REAR OF VECHICLE ON JACKSTANDS. MAKE SURE VECHICLE PARKED ON SOLID LEVEL GROUND. YOU NEED TO SIPHON JUST A LITTLE BRAKE FLUID OUT OF THE MASTERCYLINDER.BECAUSE YOU NEED TO USE LARGE C - CLAMP TO COMPRESS FORCE PISTONS BACK IN THE CALIPER BORES USING LARGE C - CLAMP DOING THIS WILL ALLOW YOU ENOUGH ROOM INSTALL NEW REAR BRAKE PADS.TO REMOVE REAR PADS ONCE YOU COMPRESS PISTON BACK IN THE CYLINDER BORE. YOU CAN TO REMOVE REAR BRAKE PADS BY REMOVING RETAINING PINS IF EQUIPPED OR BRAKE PADS HELD IN PLACE BY RETAINING BOLTS.ONCE YOU HAVE NEW REAR BRAKE PADS INSTALLED.PLACE MASTERCYLINDER COVER BACK ON TOP OF MASTERCYLINDER THEN PUMP BRAKE PEDAL TO SEAT NEW REAR BRAKE PADS AGAINST THE ROTOR UNTIL BRAKE PEDAL FEEL FIRM AND SOLID.THEN RECHECK BRAKE FLUID LEVEL IN BRAKE MASTERCYLINDER ADD LITTLE MORE FLUID IF NEED DONT OVER FILL MASTERCYLINDER.

Sep 11, 2011 | Mercedes-Benz 500-Class Cars & Trucks

1 Answer

Changing the rear brake pads and can't compress the piston into the caliper- any ideas? 2003 rendezvous


FIRST REMOVE SMALL AMOUNT OF BRAKE FLUID FROM THE BRAKE MASTERCYLINDER. THEN USE A LARGE C - CLAMP AND LEAVE THE OLD BRAKE PAD IN PLACE ON PISTON SIDE THEN COMPRESS THE PISTON IN CALIPER BORE. IF YOU SEE SIGNS OF BRAKE FLUID LEAKING AROUND PISTON SEAL.THE BRAKE CALIPER NEED REPLACING.WHEN YOU FINISH BRAKE JOB NEW BRAKE SHOES IN PLACE MAKE SURE BRAKE MASTERCYLINDER COVER BACK ON MASTERCYLINER THEN PUMP BRAKE PEDAL UNTIL NEW BRAKE PADS SEAT AGAINST BRAKE ROTOR.CHECK BRAKE FLUID LEVEL IN MASTERCYLINDER MAKE SURE ITS NOT LOW.

Aug 12, 2011 | 2003 Buick Rendezvous

1 Answer

Passenger side front brakes locking up


There are a number of problems that can cause that. It could be a bad caliper which is either hanging up or not returning correctly. It could be a bad proportioning valve or ABS motor. It doesn't have to be the passenger caliper that is bad. If the driver side isn't moving then all the brake pressure will go into the passenger side. Check your pads for excessive wear also. Metal on metal contact will cause that or a heat cracked pad could be causing uneven pressure. Check your rotors for glazing as well. If the pads don't grab until high pressure is applied then the brake could lock up. Pads rotors and calipers should cost less than two hundred dollars and if you replace all of them then you shouldn't have to worry about them for another twenty thousand miles or so. Take out the ABS fuse and drive it first and see if it does the same thing. If it does, then it's not the ABS motor. To me, it sounds like a caliper hanging up. Good luck.

Apr 20, 2010 | 1992 Dodge Caravan

1 Answer

Rear brake noise after brake replacement


probably a dumb question, but if there is a backing plate, did you make sure it isnt bent and hitting the rotor? you never want to sand new rotors, although i dont think it would cause this concern. i would suggest lightly scuffing up the brake pads. this will eliminate any noise caused by the contact of the rotors and pads. if it goes away then you know its a problem with the pads/rotors.

scoring of only the inside rotors would make me think that possibly the caliper slides are frozen up. make sure they move quite freely on the slides. it is not uncommon for brake pads to score rotors though.

but brake noises at low speeds that dont' change when applying light brake pressure are usually some sort of metal or something contacting the rotor.

Mar 23, 2010 | Toyota Camry Cars & Trucks

1 Answer

2002 ram 1500 brake and abs light on


there should be adjustment under vehicle looks like bolt attached to cable just back off nut and loosen bolt 

Oct 06, 2009 | 2002 Dodge Caravan

1 Answer

How do turn abs light off,changed front


You don't. Check all the wheel speed sensors & make sure they aren't damaged. If not, check the codes & diagnose from there.

Jul 13, 2009 | 1997 Dodge Caravan

2 Answers

98 caravan no abs


sounds to me if you replaced all of that than the power booster is sticking

Oct 12, 2008 | 1998 Dodge Caravan

Not finding what you are looking for?
1995 Dodge Caravan Logo

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...