Question about 2004 Jeep Grand Cherokee

1 Answer

Power windows and power locks stopped working on the passenger side only.

Posted by on

  • antiquecar Jul 30, 2008

    2000 year model Grand Cherokee Limited with 114,000 miles. Clean car, Passenger side front window has been operating independently at times. Now nothing on that side of the car works including power mirror and inside light on door.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Broken wire in passenger door jamb

Posted on Jul 30, 2008

6 Suggested Answers

SOURCE: Power windows, door locks and mirrors inop.

Not a solution for the problem exactly but to the person who pulled his fuse for the dome lamps, all you need to do is turn the interior lights off at the turn signal switch next time. I'm going to have my wiring repaired tomorrow. Thanks for the info.

Posted on Sep 08, 2008

  • 110 Answers

SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work

i had same problem on my jeep i disconnected the battery then reconnected everything worked fine after that

Posted on Nov 25, 2008

  • 2 Answers

SOURCE: HAVE A 03 GMC SIERRA

I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.

Posted on Dec 21, 2008

  • 840 Answers

SOURCE: 04 Jeep Power Windows

you can pop up the panel that holds the buttons check the underside that everything is hooked up then check fuses and if you need the buttons you can install them pretty easily

Posted on Jan 25, 2009

  • 3 Answers

SOURCE: 2003 Dodge durango sport all four power windows not working

I know its not what anyone would want to here but sounds like a short. Best thing to do is first wiggle your key switch when the vehicle in in the on position then at the same time try to check to see if locks or windows are working. Then do the same in while the rig is running. If that dont work your ignition is fine and you need to take off door panels and check and wiggle all conections on window motors and lock motors and look for melted or burt wire or some that might have got hot. If all is good there you need to go to the back of the fuse box were the fuses to those items plug in and check there. As far as the service engine light goes either take it to the nearest Schucks or AutoZone and they will check it for free if not cycle the key on and off 3 times and on the 3rd time leave it in the on position look at your odometer light and it will flash a code remember that code and type Dodge then the code on yahoo search and it should tell you why your light is on Hintz whay sensor is bad. Hope this helps.

Posted on Apr 05, 2009

  • 1 Answer

SOURCE: 2004 GMC Canyon with 9000

Did you recently install a third party stereo?

Posted on Jan 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger power window stopped working with either controls


Power Windows not working - CarGurus

www.cargurus.com > Questions > Honda > Accord

CarGurusOct 9, 2012 - Power Windows not working - I have a 2006 Honda Accord and thepassenger and back power windows quit working all at once. ... My key less entry doesn't work either after I replaced the master Window control unit. 6 out of ...

Passenger Power Window Not Working ' ClubCivic.com - Your Online ...

www.clubcivic.com > ... > Interior / Audio / Electronics
Oct 28, 2009 - My passenger side window is not responding to either the driver side orpassenger side switch. It is in the up position and wont go down.

Jan 19, 2016 | Cars & Trucks

2 Answers

My passenger side electric window stopped working on my 1991gmc sierra 1500. The passenger side switch panel don't work for the window but works for the lock. Driver side master switch doesn't work for the...


The odds of both switches going bad at the same time is high, remove the door panel and tap on the window motor with a hammer, while trying the switches. I may have jammed up. Ground a test light and check the motor connection, while trying the switch, power will show on either side depending on if it turning up or down

Mar 19, 2015 | Cars & Trucks

1 Answer

Driver's side power window working, but all three passenger windows died at same time. How to assess issue? (i.e., fuses to check, etc.)


Check the window lock out. You may have pushed that on accident. It locks the passenger and rear windows so people dont use them when the driver wants to control window operation.. Usually for annoying kids :) The window lock out usually has a pic of a window with an "X" or a pic of a window with the word "lock"

If that is not it, It sounds like the controls went bad. This happens from time to time. When liquids get onto the window controls its common that some go out and or they all go out. I would put my best guess on the window lock out.
Only true and accurate way to check is manually see if power is exiting the window controller to the rear windows and or passenger window... you would need a Volt meter to watch voltage.

Jan 10, 2015 | Cars & Trucks

1 Answer

Why doesn't my 2000 chevy blazer power windows and door locks and remote mirror doesnt work. Power window on passenger side does work


well, the first thing is to check the fuses and or relay for power windows.should be listed in your owners manual. if ok, then remove switch from drivers side window and check for power. if power to the switch then use a jumper wire from power side to motor side of switch. if window works then its the switch causing the problem. Good-day!

May 04, 2014 | 2000 Chevrolet Blazer

2 Answers

2007 chevy silverado power window dome light and power mirror passenger side front


Beings as everything that stopped working is on the passenger side, I'd think some wiring got disconnected or broken.

Jan 14, 2014 | Cars & Trucks

2 Answers

Doorlocks dont work except from passenger side. mirrors dont work. windows dont work from anywhere


First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

Mar 15, 2011 | 2005 Ford F-150

2 Answers

Power window switchs on 1996 gmc jimmy


Inspect or replace the window lock and unlock switch on the drivers door power window switch. There is a lock and unlock switch that will disable the switches to the other power window in the Jimmy. Check to make sure that switch is in the unlock position to have the other power window switch to work.
Thank you for suing fixya and good luck.

Apr 19, 2010 | 1996 GMC Jimmy

1 Answer

2005 Chrysler T&C passenger side window went down and won't come up. All other automatic windows and door locks work fine - don't hear any motor sound / buzz / etc. when either driver side or passenger...


If the window had not been slow in it's action before it stopped working I'm guessing you only have a connection problem. I would remove the door panel and using a multimeter check the hot wire to see if power is reaching the switch. If it is check the connection on the motor. If power is reaching the motor through the switch you have a faulty motor. If at any point of testing there is no power backtrack the power wire to find where the break is. (it's usually in the door jam)

Apr 13, 2010 | 2005 Chrysler Town & Country

1 Answer

1993 Ford F150 4X4 Power door locks, power window on passenger side and lumbar control on seats stopped working


CK FOR POWER TO LOCK @ WINDOW SWITCH IT COMES FOR MASTER WINDOW SWITCH ON LEFT SIDE DOOR NOT SHORE ON LUMBAR CONN.UNDER SEAT CK IT FOR POWER

Aug 11, 2009 | Ford F-150 Cars & Trucks

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...