Question about Triumph Tr 8

1 Answer

The car is 77 truimph spitfire;battery has power nothing else does.

Posted by on


1 Answer

Engine on st

Posted on Oct 05, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1974 truimph spitfire mk4 firing order

Edward, Firing order 1-3-4-2 for spitfire. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Engine Tuning Data for the Triumph Spitfire and GT6
Distributor drive gear and firing order question Spitfire GT6 Forum...
getting spark plug wires back in the right order MGB GT Forum MG...

Jun 14, 2016 | Triumph Cars & Trucks

1 Answer

My 1969 triumph spitfire has been running fine but lately has started suddenly cutting out and losing power under heavy uphill loads. When this happens it always blows oil and smoke out aroumd the bol

time to rebuild motor or replace it. The smoke your seeing is pressure from the cylinder escaping around the piston rings into the crankcase and venting out the covers

Aug 24, 2014 | Cars & Trucks

1 Answer

Fh41825he engine number what cc

The F series engines are from Triumph Spitfires. FH is a 1300cc engine (1296cc) from a Spitfire Mk4. I can't remember if it's a small crank journal engine like the Herald 13/60 GE engine (good) or a large crank (not as good).

Mar 04, 2013 | Triumph Spitfire Cars & Trucks

1 Answer

My 89' bronco II runs fine at an idle but stutters and cuts out alot, mostly in the 2000-3000rpm range. It does it so bad I worry it will blow a gear in my ******! I have a dts code 77 witch I und

Well code 77 is nothing - you are supposed to hit the brake pedal and the gas pedal during the KOEO test. Code 77 is no movement of the gas pedal.
I guess I would start with the statement about driving it home with no problems on the battery, but problems after the alternator was installed.
Have you checked the charging system to see if it is charging around 14 volts ? It could be overcharging which would cause electrical problems.
Unless you can figure out what changed when you replaced the alternator, you will have to find out if you are dealing with a fuel problem or ignition to proceed with any troubleshooting.
Ford products are famous for ground problems. You might recheck the ground connections, especially in the engine compartment.

Sep 20, 2012 | Ford Cars & Trucks

1 Answer

77 Caddy Battery drains--alternator and battery have been tested and both are good

If the alternator and battery is tested and pass then you current draw that has to be known. Do you have a test light? youll have to put it in series to negative terminal to negative battery . if it light up there you start the hunt glove box light bulb trunk light bulb.and dash lights.didnt the 77 have power seats? they are popular for battery drain is it warm how about the passenger side why the seat well because they have power even without the key in ignition. Here is your find without test light , with the car sitting feel the power seat is it warm if it is there is your drain, if it isnt go to glove box is the bulb warm if it is there the short, if its not check the trunk where ever the draw is at it has to do with devices that turn on without the key being needed.

Apr 28, 2011 | Cadillac DeVille Cars & Trucks

2 Answers

I have a 1976 Triumph Spitfire 1500. It will ...

On older model vehicles we start having lots of electricle issues. the current flow gets interupted and broken because ALL of our GROUND wires get corroded where they are screwed to the body or frame. it is important that these connections get sandpaper shiny cleaned and tightly screwed backin. solves many issues.

Apr 07, 2017 | Cars & Trucks

1 Answer

C4(1986) power seats in a C3 ( 77.)

yes you will need to make your brackets. and the best place to get your power from is the battery but put a inline fuse or braker.or you could put in a relay that come on with the key?

Jul 17, 2009 | 1972 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

500 Answers


Level 3 Expert

77544 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides