Para crear un omellete con jamón, debes de picar primero cebollas luego pones los dos huevos sobre el sarten, picas el jamón, pones el jamón en el huevo. Las cebollas las cortas y las pones en el huevo y las sazonas, y pones queso rayado.
El omellete quedará listo en unos minutos. Yo lo recomiendo con un jugo de naranja y un pancito.
An expert who has achieved level 3 by getting 1000 points
An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.
An expert that got 20 achievements.
An expert that got 10 achievements.
Re: Break light switch installation
Look on the bar the brake pedal is attached to, you will see a switch at or near the top, go to the dealer with your VIN# and buy a new one, first make sure the issue is not the fuse or the bulbs/wiring, don't throw parts at it, it will get very expensive fast, do the electrical test/checks first.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Normally, the switch is right over your break pedal. it is a small piece with 2 wires. Disconnect the wire form the switch and try to bridge the contacts f.e. witch an paper clamp. If the break lights goes on, check if the switch is right placed. That means that the break pedal must hit the downside of the switch to press in a small plastic part that opens the contacts inside the switch. Try to move this part in with your fingers and check if it comes out quick if you press down the break pedal. If bridging works, but the reest not, replaces the switch and take care for proper installation
purchass the new switch so you can see how the connectors engage. remove the old switch from the brake arm being careful to dislocate the switch wires connector so as not to break it. reinstall new switch and plug back in.the switch should self allign when you press the brake peddal.
Have you checked your fuse yet? It will be labeled tail lamp probably. If the fuse is ok, you need to check the break switch. It is located above your break pedal. It looks chrome and it is a round cylinder. The break leg hits the break switch button when you hit the break, which turns on the break lights. You can mess with the small button and it might help. If not, it will need replaced. If you need anything else Joelsta, please let me know. I am here to help. A 4 thumbs up is appreciated if you appreciate the answer. Thanks.
maybe? But I would I would look under the dash and see if the head light switch is unplugged. More then likely the removed the dash to put in the steeling column. As for the break lights there is a break light switch behind the break pedal. That switch might be wore out or have a broken wire. The headlights and break lights work independent from each other. So when they put in the column in. They might have forgotten to plug them back in.
u have a problem with ur break light switch,,, its at the brake pedal and is threaded into the brake pedal bracket, if u have a new one and are going to replace it, disconnect the connector, loosen the 14mm nut and remove the switch by turning it counterclockwise...install ther new switch by turning it clockwise and tightening the 14mm nut then reconnect the connector...be sure to adjust the switch or else the brake lights will stay on at all times...draining ur battery and possibly burning out ur bulbs...this also releases ur trans from park to put into gears