Question about 1988 Chevrolet Cavalier Z24

1 Answer

88 chevy corsica

I could start the car in neutral but when i put it in gear it stalls

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Change the saffty nutrol switch i take it front wheel drive if so right where the tran line up u will see a plug on the tran either 5 or 7 wire some time or or less wire

Posted on Mar 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 88 grand am Se 2.0 OHC turbo, automatic the turbo does not work. my problem is that it runs great for about 1/2 hour driving until it gets warmed up. I come to a light it starts to surge and...


The TCC solenoid in the transmission needs to be replaced. It is under the side cover. It controls the converter to lock up for better fuel mileage. If you want to drive car until you get it fixed you can un-plug the connector going to the transmission on the front of transmission. This will keep it from going to lock up mode and keep it from stalling until you can fix it. Common problem.

Apr 02, 2011 | 1988 Pontiac Grand Am

1 Answer

1. My 88 Corsica stalls out mostly when I break for stop lights or signs. What could my problem be, and how can I solve this? 2. Also the ac smokes, it seems to come from under the car after being used...


I'm assuming it an auto trans if its stock corsica. Is it only when the car is in gear (drive 1, 2, 3, or reverse? IF so you may very well have a bad torque converter. And the ac smoking I cant really say, you will ned to look under the car when its running to pinpoint the issue first,,

Jan 31, 2011 | 1988 Chevrolet Corsica

2 Answers

1991 Chevy Corsica Starts up and Dies 5 minutes later


Sounds like a faulty sensor. Have you changed your fuel filter? Checked all vacuum lines? Any check engine light on?

Aug 02, 2009 | 1991 Chevrolet Corsica

2 Answers

Vibration when in gear, and stalling.


The problem is the torque converter solenoid. I had it happen on my 94 Cavalier a few years back and was a cheap fix at the local car mechanic. What happens is the transmission warms up and hits a certain speed where the solenoid engages, but then it sticks and won't disengage until it cools down sufficiently. When it sticks, it causes the car to shake when slowing down and will snub out the engine if you come to a stop.

Mar 09, 2009 | 1994 Chevrolet Cavalier

1 Answer

My Chevy Corsica 87 stalls when I have to stop at a light .


When it stalls, does it start back up and then die again when you put it in drive or just not start back up?

Mar 02, 2009 | 1987 Chevrolet Corsica

1 Answer

Location of crank position sensor on 92 chevy corsica 3.1


You will have a no start or stalls after engine gets hot and then cools down restarts, the sensor is on the front of the engine mounted into the cam gear cover if it is not visiable get under the, (here is a picture) car and look.d37e0b9.jpg

Jan 21, 2009 | 1988 Chevrolet Corsica

1 Answer

I have a 1995 Chevy corsica it starts up fine, i went to go put it into gear and it wont go i tried all, reverse, drive, overdrive, low and it wont even budge


call a garage,this could be a multitude of faults but most likely the problemis the front clutch has gone or the pump

Jan 01, 2009 | 1995 Chevrolet Corsica

Not finding what you are looking for?
Cars & Trucks Logo

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...