Question about Nissan Quest

Open Question

05 nissan quest power sliding door won't close

Posted by on

  • 2 more comments 
  • juanyjimenez Mar 30, 2009

    My "04 Quest right door isn't working and right seat is also not sliding back and forth and stuck in reclined position.



  • juanyjimenez Mar 30, 2009

    My remote isn't opening right door and right seat control doesn't work.

  • Anonymous Apr 07, 2009

    my doors on my 07 quest will not close either-- guess i have to call the dealer tomorrow...

  • rpaulbhatia Apr 15, 2009

    My sliding door was not closing a couple of months ago. It would slide, but when it tried to latch would stop dead or reopen. I greased the sliding rails, wheels, and door latch mechanism. It started latching again, but I am unsure exactly why.

×

5 Suggested Answers

  • 1 Answer

SOURCE: sliding door won't close. 2004 nissa quest

Mine was doing the same thing. I took it in and watched them fix it and first they steam cleaned the area under the floor where the rollers are. Then they took a spray and lubricated the rollers and the track where the rollers are. then they cleaned the brass connectors on the side of the door where the safety pins touch. I could have saved ALOT of money doing this myself. I hope this helps!

Posted on May 12, 2009

micromaster
  • 3614 Answers

SOURCE: My 1999 pontiac montana rear sliding power door will not work

hi there,

this can be stuck contacts on the door. better to check the sliding contact point for any dirt debris on the slide or it may need some lubricant for easily sliding.

Posted on Apr 18, 2009

  • 1 Answer

SOURCE: 05 caravan passenger power sliding door will lock but not open

READ YOUR MANUAL. THERE IS A SEQUENCE INVOLVING REMOVING A FUSE WHICH RESETS THE ELECTRIC DOOR OPENER. IT IS DESCRIBED IN THE MANUAL. EASY TO DO ONE YOU HAVE THE BOOK IN HAND.

Posted on Apr 27, 2009

  • 4369 Answers

SOURCE: Im looking for a sliding door handle for a 2000 nissan quest van.

ebay has them all the time also, go here for help on Quests http://autos.groups.yahoo.com/group/villagerquest/

Posted on Jun 08, 2009

  • 42 Answers

SOURCE: I have also broke off my 2001 Nissan Quest sliding

the child lock rod may have been extended...
open the driver side door, and with a skinny finger, push that child lock rod back in towards the rear of the sliding door
use the passenger side as reference
once you pushed it in, you can now open it from the inside handle

Posted on Jun 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the rear sliding door interior panel on 2001 Nissan Quest?


Mostly clips, screws hold the handle on and bezel around it has clips that can carefully be pried off.. A door panel tool should be used to enage and pry panel clips off

Aug 22, 2014 | 2001 Nissan Quest

1 Answer

My sliding door hinge broke


if it will go back in the track reinsert it in and slowly close the door..and dont use until a replacement hinge is gotten from the towyard...

Jan 21, 2013 | 2000 Nissan Quest

1 Answer

2005 Nissan Quest automatic sliding door does not close


I would advise you check the guide area at the bottom where the door slides. There could be something lodged in the guide causing the problem.

Good luck!

I Can Fix It

Jun 11, 2009 | 2005 Nissan Quest

2 Answers

Im looking for a sliding door handle for a 2000 nissan quest van.


ebay has them all the time also, go here for help on Quests http://autos.groups.yahoo.com/group/villagerquest/

Jun 01, 2009 | 2000 Nissan Quest

1 Answer

Broken door handle - 2001 Nissan Quest SE


first you van order parts at discount from tascafordparts.com.
quest & mecrury villager are the same vehicle made at the same assembly plant. good luck to all. If you were in detroit area, I wold help you.

Trim Panel —Sliding Door Removal
  1. Remove the sliding door trim panel finish panel.
532ac84.gif 2. Remove the sliding door trim panel 2965fbe.gif Latch Remote Control —Sliding Door Removal
  1. Remove the rear sliding door trim panel. For additional information, refer to Section 501-05 .
  1. Position the watershield aside.
  1. If equipped, disconnect the sliding door power door lock actuator electrical connector.
f373e91.gif
  1. NOTE: Mark the position of the sliding door rear latch cable adjusting bracket before removing the bolt.
  2. Disconnect the sliding door rear latch cable.
  3. Remove the bolt.
  4. Remove the sliding door rear latch cable adjusting bracket from the latch remote control.
  5. Disconnect the sliding door rear latch cable from the latch remote control.
b8f2f32.gif
  1. Remove the 4 sliding door front latch bolts.
NOTE: If necessary, transfer parts to the new sliding door latch remote control.
Remove the sliding door latch remote control.
  1. Remove the bolts.
  1. Remove the sliding door latch remote control.
cb5ee71.gif
Handle —Exterior, Sliding Door Removal
  1. Remove the sliding door latch remote control. For additional information, refer to Latch Remote Control—Sliding Door .
  1. Remove the sliding door exterior handle.
    1. Remove the nuts.
    1. Remove the sliding door exterior handle.
0c820f3.gif

Mar 08, 2009 | 2001 Nissan Quest

1 Answer

I have a Broken Exterior Sliding Door handle


tascafordparts.com same car as vilager

Jan 16, 2009 | 2001 Nissan Quest

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...