Question about 2002 Chevrolet Silverado 1500HD

1 Answer

Heater blower switch on 2003 Chevrolet Silverado

Need to replace heater blower switch

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chevrolet Master
  • 19,396 Answers

Do you want the part?

Posted on Jul 29, 2008

  • Ginko
    Ginko Jul 29, 2008

    To replace heater blower switch find the underhood fuse-relay box that is located near to the master cylinder, there you find the switch.
    You can buy the part online here or at any local car parts shop.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2003 chevy silverado 2500hd heater fan goes on and off in cold weather

If it does it at all speeds, I would look at the controller. Loose plug or contact inside it. If it does it only in low speeds or only high, replace the resistor, behind the blower.

Nov 29, 2015 | 2003 Chevrolet Silverado 2500HD

1 Answer

2003 Chevy silverado heater fan won't shut off after truck engine is turned off. How do I turn it off?

This is a problem with the blower motor module. It needs replaced it is located on the passenger side under the dash by the blower motor. You can unplug this and it will turn off.

Jan 10, 2011 | 2003 Chevrolet Silverado 1500

1 Answer

The heater/ac blower only works on high

Mos likely the switch on the dash for the speed settings for the blower motor has gone out. You can check this by using a test light and checking each connection coming out of the switch. If you have fire coming from all the terminals then the blower itself could be bad.

Jun 25, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

2003 silverado abs/brake light and service 4x4 light comes on heater blower quit working at the same time.

Possible bad ignition switch. Check out video on YouTube called 2003 Trailblazer, no blower, abs and brake lights on. I know it says trailblazer, but it applies to most of gm full size trucks. 2003-2007 including Silverado. Video tells you how to test to see if that is the problem.

Jan 06, 2010 | 2003 Chevrolet Silverado 2500HD

1 Answer

2003 silverado only blows on 5

tempertaure resistor need to replaced , located near the blower motor.

Sep 05, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

2003 silverado blower fan stays on..

under the passenger side dash, right above floor board there is a wire connector. That connector is for your blower resistor. If you unhook it, the blower will stop running, hook it back up and you will have a blower. You can also remove the fuse. Point being you can use your truck. Order the new part and replace it. I can't remember how many wires went to it off hand, its rectangular, mayber 6-7or 8ish.

Jul 11, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

2003 Silverado heater blower switch

I had this same problem on my 2003 Chevy Silverado. It is the resistor pack that is bad. Not the switch or the knob that you turn. It is loacated on the passanger side underneeth the glove box. You have to take a cover off to replace it. This is a dealer item, so you will have to get it from a GM dealer parts dept. You will also have to replace the plug that goes to it as it will be overheated. The resistor pack was about 69.00 but the plug was outrageus about 160.00. I chose not to use the plug.
Soldered on some wires directly to the resistor pack and then soldered them to the wires on the truck. Good Luck

Jul 29, 2008 | 2002 Chevrolet Silverado 1500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides