Question about Chevrolet TrailBlazer

1 Answer

Where are the IAT sensor wires im my 2007 trailblazer LT i have the inline 6 engine

Posted by on

1 Answer

Check out www.trailvoy.com.

Posted on Sep 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P0014 Diagnostic code, already replaced camshaft actuator & oil twice


code p0014 - Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum

forums.trailvoy.com > ... > OEM Issues

Sep 8, 2007 - 11 posts - ‎8 authors
On my Trailblazer I have a code P0014 . this says Camshaft Position Actuator B ... If the desired and actual cam phase angle error exceeds its ... This diagnostic procedure supports the following DTC: ... replace the camshaft actuator solenoid, change the engine oil and filter, ... 2004 Chevy TrailBlazer LT P0014 - Camshaft Position Actuator Solenoid "Relearn"
11 posts
Dec 11, 2009
cam crank sensor mismatch
11 posts
Jul 4, 2009
More results from forums.trailvoy.com

Tech Code "dtc P0014" 2003 Trailblazer - Chevy S-10/Blazer ...

www.gm-trucks.com/.../72278-tech-code-dtc-p0014-2003-trailblazer/

Dec 31, 2007 - 14 posts - ‎6 authors
Tech Code "dtc P0014" 2003 Trailblazer - posted in Chevy ... it had been serviced before for the same thing in 2003 or 2004! ... replace the camshaft actuator solenoid, change the engine oil and .... The extended war. co. prob. would not be to happy since they already fixed the sensor once or twice already.

Replace a Camshaft Position Actuator Solenoid Valve on a ...

? 8:05
https://www.youtube.com/watch?v=4Dkdd287AKg

Jan 11, 2016 | 2004 GMC Canyon

1 Answer

How do I fix a 2005 Chevy Trailblazer code PO113


Intake Air Temperature Circuit High Input

A code P0113 may mean that one or more of the following has happened:
Internally failed IAT sensor Faulty connection at IAT sensor
Open in IAT ground circuit or signal circuit
Short to voltage in IAT signal circuit or reference circuit IAT harness and/or wiring routed too close to high-voltage wiring (e.g. alternator, spark plug cables, etc.)
Faulty PCM (less likely but not impossible)

Oct 20, 2015 | Cars & Trucks

1 Answer

ATTEMPTING TO LOCATE THE TWO IAT WIRES IN THE MAF SENSOR PLUG TO INSTALL PREFORMANCE CHIP IN 2007 DODGE NITRO 3.7 ENGINE


ATTEMPTING TO LOCATE THE TWO IAT WIRES IN THE MAF SENSOR PLUG TO INSTALL PREFORMANCE CHIP IN a 2012 COLORADO 3.7 engine.

Jul 30, 2012 | 2006 Chevrolet Colorado

2 Answers

I have a 2007 Chevy Trailblazer LT. I'm having a problem with it starting, when I get in the truck to start the engine doesnt turn on everything else works just fine. Its day two a friend jump my


The first thing you need done is to have the battery load tested, you can get this done free at any Autozone parts store, others offer this free service as well

Jul 12, 2012 | 2007 Chevrolet TrailBlazer SS

1 Answer

How do i replace the intake air temperature sensor on a 2005 chevy trailblazer


The Intake Air Temperature Sensor (IAT) is located in the intake duct near the air cleaner assembly on the right side of the engine compartment. To replace it, you would simply disconnect the electrical connector and pull the sensor out of the rubber duct. The new one simply pushes in. Before going out and buying a new one, make sure that the sensor is plugged in if you are getting a code for it. These get accidentally left unplugged all the time when people remove the duct to perform air cleaner service. Also make sure the wires are not damaged. IAT Sensor failures are rare.

Apr 02, 2011 | 2005 Chevrolet TrailBlazer

3 Answers

Which 2 wires is The IAT on 2007 Silverado


The intake air temp sensor is the one that is not the mass air flow. It should be a little 2 wire sensor in the inlet tube. The mass air flow is near the air cleaner, and is inline with the air inlet tube.

Jul 22, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

2 Answers

P0172 and P0128 Error Code 2003 Trailblazer 4WD


PO172 means that an oxygen sensor in bank 1 detected a rich condition (too little oxygen in the exhaust). I would replace the thermostat first. The computer could be injecting too much fuel because it thinks it never gets to operating temperature. That may keep the light off.

Jan 28, 2009 | 2003 Chevrolet TrailBlazer

1 Answer

IAT Wire Colors


the IAT should only be a 3 wire plug not 6

Jan 20, 2009 | 2007 GMC Yukon

1 Answer

2007 gmc sierra 2500 IAT sensor


Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.

May 18, 2008 | 2004 GMC Sierra 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

273 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...