Question about 1991 Ford Explorer

1 Answer

FORD BRAKE LIGHT

CAN YOU TELL ME WHY MY BRAKE LIGHTS WONT WORK ON MY 1998 FORD EXPEDITION

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 62 Answers

Check your brake light switch,its located under the dash on the pbrake pedal assembly.

Posted on Jul 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get my 1998 ford expedition out of park


Check the brake lights, are they working? bet not. If not check the brake light switch at the brake arm to the brake pedal, use a 12 volt probing test light ($5 at part store), see is you have power to the brake light switch and when the brake pedal is pressed you have both power in and power out (test light will light up). This problem is common and can be caused by a defective brake light switch connector (available new from Ford parts) or the brake light switch is defective. If the brake light switch is defective go to youtube and search for a video of replacing it, it is a 20 minute job for even a novice.

May 21, 2016 | Ford Cars & Trucks

1 Answer

1998 Ford Expedition rear break lights not working


check fuses. if all good there i would use a test light to check power to brake light switch on pedal. should be two wires. one will be hot all the time and the other will be hot when brakes are applied. if you have power there and no lights still i would suspect multifunction switch is bad on steering column.

Sep 14, 2012 | 1998 Ford Expedition

1 Answer

Tail light is not lighting up in my 2000 ford expedition


brake and turn are the same filament in the bulb. Try a new bulb. if that doesn't work your going to chase a short/ground on that wire back to the switch. get a wiring diagram to help.

Aug 05, 2012 | 2000 Ford Expedition

1 Answer

Brake Lights wont shut off


At the brake pedal their is switch which is possible loose or out of adjustment or closd circuit,it has two wires you could disconnect 1 wire. Caution!!!' do not use your cruise control until you have it fixed. Allan

May 09, 2012 | 1998 Ford Expedition

2 Answers

I Have a 99 expedition eddie bauer. My brake lights wont come on till i push the pedal almost to the floor. Can u tell me whether i need to replace the brake light switch.


I had a similar problem when I owned a 1997 Expedition. In my case, the brake light switch, mounted to the brake pedal arm, was faulty. My guess is that you have a similar problem. Pretty easy to replace... couple of wires and a clip as I recall.

Good luck.

Mar 25, 2011 | 1999 Ford Expedition

1 Answer

Brake lights and turn signal stop working at the same time


If brake lights not working then its quite possible that the problem is .either the brake light fuse or the brake light switch.The brake light switch is causing the turn signal light to stop functioning.Check out both the brake light fuse and the brake light switch. Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

Aug 17, 2010 | 1998 Ford Expedition

1 Answer

1998 ford expedition wont start. theft like is


If you are reseting a factory alarm...lock and unlock the drivers door with the key. If you don't know the code look under the dash driver side in left corner there should be a black cover with a sticker with a code on it 6 numbers that is the factory code.

Oct 07, 2009 | 1998 Ford Expedition

1 Answer

98 expedition trailer brake and blinker lights stopped working


check you bulb and there sockets its possible that you burned out one of the two

Aug 20, 2009 | 1998 Ford Expedition

1 Answer

THE BRAKE LIGHTS AND THE TURN SIGNALS ARE NOT WORKING ON MY TRAILER. EVERYTHING WORKS ON MY TRAILER WHEN I HOOK IT UP TO ANOTHER VEHICLE. IM THINKING IT IS A FUSE ON MY 1998 FORD EXPEDITION BUT I DONT HAVE...


Did you guys ever solve the issue with your trailer wiring? I have a 2000 Expedition with only one brake light on three different trailers no other lights work. They were working fine and the work fine on other vehicles. I know it could be anything but I'm not sure if it's a known issue that the plug by the rear wheel back to the adapter gets bad or if there is a typical issue that lies elsewhere. I'm just trying to find where to start????

Apr 12, 2009 | 1998 Ford Expedition

1 Answer

FORD BRAKE LIGHT


check the connector at the brake switch located on the brake pedal lever arm if it is ok it is most likely a faulty switch

Dec 01, 2008 | 2003 Ford Expedition

Not finding what you are looking for?
1991 Ford Explorer Logo

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...