Question about Oldsmobile Cutlass

Open Question

Security light stays on 1997 olds cutlass supreme

Posted by on

  • pauldickey Oct 12, 2008

    same problem 1996 oldes cutlass

  • jarnold5019 May 10, 2009

    changed intake gasket,and now it will not start.Theft system is on and will not clear

×

5 Suggested Answers

csmock132
  • 4669 Answers

SOURCE: My security light stays on in my 1994 Oldsmobile

Replace the ignition lock cylinder or bypass the security system. The contacts are bad in the lock cylinder.

Posted on Mar 27, 2009

  • 5 Answers

SOURCE: the steeing column in my 95 Olds Cutlass

does the key have a computer chip built into it. i think it does . if this is the case that,s your problem. the key has to match the computer in the car it,s programed from the factory like this. you either have to use the original ignition lock and key or get the lock in your new column keyed to your original key by a lock smith. than your car will start. good luck.

Posted on Apr 18, 2009

co7196
  • 3433 Answers

SOURCE: 1971 Olds Cutlass Supreme. Dash brake light stays

They are unrelated. Just make sure your brake release is fully relesed. The switch turns the light on if the release isn't against it fully.

Posted on Jul 14, 2009

  • 3 Answers

SOURCE: security light staying on 1995 olds cutlass

the last solution is not correct i am a professional locksmith and the problem is that the ignition har two wires that read your key and they must if not already broken in the event of the last happening do not settle for repair ignition must be replaced along with a new set of wires that come with the new ignition if the locksmith offers a repair ask if you are getting new ignition or are they just fixing the problem if they are just fixing move on and shop somewhere else crook on site or just not very proffesional, good luck, i have work on approximately 30 cars with same problem for at least 10 years

Posted on Feb 06, 2010

roniecon
  • 6826 Answers

SOURCE: 1997 olds cutlass supreme The security light is

Open ,and shut the doors,and the hood,and the trunk,then set the anti-theft,leave it set for 5 minutes,then disarm the anti-theft,and then try and start the vehicle.

Posted on Jun 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove glove box on 1997 olds cutlass supreme


check the fusebox under your hood for the horn relay,should be a black box close to your battery that has fuses in it

Jan 31, 2013 | 1997 Oldsmobile Cutlass Supreme

1 Answer

Service engine light stays on


go to you local parts store(autozone) and have them scan your car to see what the code is. in most cases they can even erase the code

Feb 19, 2010 | 1997 Oldsmobile Cutlass Supreme

1 Answer

I have a 1997 olds cutlass supreme and have no brk lites


sounds like a bad or loose ground wire, it would be located in the trunk near the tail light assembly, the other switch is for the cruise contro, it's what cuts the cruise when you hit the brakes.

Feb 09, 2010 | 1997 Oldsmobile Cutlass Supreme

3 Answers

My 1997 Olds Cutlass Supreme won't turn over


Better have the starter, battery and chargeing system all tested. A starter can cause the problem.

Oct 30, 2009 | 1997 Oldsmobile Cutlass Supreme

1 Answer

1971 Olds Cutlass Supreme. Dash brake light stays


They are unrelated. Just make sure your brake release is fully relesed. The switch turns the light on if the release isn't against it fully.

Jul 14, 2009 | Oldsmobile Cutlass Cars & Trucks

1 Answer

I need to replace turn signal switch on 97 olds cutlass supreme.


Disconnect the battery to do any service on the steering column or front radiator areas.

Jun 30, 2009 | 1997 Oldsmobile Cutlass Supreme

1 Answer

I have a 96 Olds Cutlass Supreme that intermittently won't start


If the lights on the dash all come on but the engine wont turn over it could be a problem with the VAT security system. Your key has a little chip on it between the teeth and the handle. This is a common problem with GMs', often just replacing the key is necessary but sometimes the VAT module needs to be replaced.

Jun 18, 2009 | 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

Trouble shooting a 1997 olds cutlass supreme


BEFOR DOING THIS IL'D PUT IT BACK ON THE COMPTER JUST TO SEE WHAT IT BRINGS UP BUT IT DOES SOUND LIKE A CAM SHAFT SENSOR

Apr 14, 2009 | 1997 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

335 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...