Question about 2007 GMC Envoy SLT

1 Answer

Electric brake controller

I have a 2007 gmc envoy slt 4wd and am installing an electric brake controller but cannot find the connecting point under drivers side instrument panel. I need help on where it is and what it looks like. I have a 4 wire square plug from my brake controller. Cannot find where to plug it in.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

IT IS LOCATED UNDER THE DISH ON THE RIGHT SIDE. YOU HAVE TO REMOVE THE PLASTIC COVER. IT IS TAPED OR ZIP TIED TO THE FRAME

Posted on Jan 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2007 envoy radio and cd lights up but no sound comes out of any speaker.


Jon, Pretty sure there is a separate amplifier for radio/CD player, check for fuses and separate amp. Amp and fuses could be under rear seat or under side trim panel. You could look in your manual or try a google search.
Envoy SLT Factory Amp Location
found this helpful answer from gmc mechanic on JustAnswer com

Aug 25, 2016 | 2007 GMC Envoy

1 Answer

2007 envoy the headlights on dim are not working


Did you check the fuse's an HDM relay #46 in the under hood fuse / relay box ?
Headlamps
The headlamp driver module (HDM) is an electronic module that provides electrical power to the vehicle low beam headlamps. The HDM is controlled by a pulse width modulated (PWM) ground signal from the body control module (BCM). The BCM determines the lamp intensity using the ambient light sensor, multifunction switch and the park brake switch as inputs. In general, the HDM will operate in 1 of 3 modes:
?€¢
Reduced Intensity Mode: This mode is used by features that do not require or allow maximum low beam headlamp intensity such as daytime running lights (DRL) (nominal: 85% duty cycle).


?€¢
Full Intensity Mode: This mode is used by features that require full low beam headlamp intensity such as low beam headlamp operation in manual or auto modes (nominal: 100% duty cycle).


?€¢
Off Mode: This is the default mode of the system that will occur when none of the features described above are active. The BCM will deactivate its PWM output (0% duty cycle) during this mode.

Mar 16, 2015 | 2007 GMC Envoy SLT

2 Answers

Does a 1997 Gmc jimmy have back bums or pads


You mean drums? Depends on the vehicle options but should be rotors/pads. Easy to check - look through the wheel spokes and if pads, you should see the rotor.

Feb 24, 2015 | 1997 GMC Jimmy

1 Answer

Locate temperature sensor on 2007 gmc Envoy SLT


on top of motor in front by where radiator hose is.

Oct 07, 2014 | 2007 GMC Envoy SLT

1 Answer

GMC 2003 Envoy SLT my back break lights and tailbar lights stay on when I turn the car off. What could the problem be?


This most likely is a bad or incorrectly adjusted brake light switch. The brake light switch is located under the dash next to the brake pedal arm.

Oct 05, 2010 | 2003 GMC Envoy

1 Answer

I have a 2004 GMC Envoy XT with 4wd. I started to


sounds like you have a broken shifter cable.Go under the rig and shift the transmision manually.Put on the parking brake and on the drivers side of the trany should be the lever to move.Look for the broken part while you are there it will also help to locate the shift lever on the trany.

Jul 31, 2010 | 2004 GMC Envoy

1 Answer

I have a 2005 gmc envoy and the driver seat gets hot


There may be a stuck relay Stuck in the "On" position. A relay is a remote switch that does the heavier work of a smaller or more delicate switch. It is probably under the seat but if you have "memory" seats that move the power seats back and forth it is probably the control box causing the problem. It has relays inside it.

Jun 30, 2009 | 2002 GMC Envoy

2 Answers

No power to inside of the vehicle!


you blew a fuse or two. check all the fuses in the car and under the hood this will solve your problem.

Mar 31, 2009 | 2002 GMC Envoy

3 Answers

Fuse Box Location 2006 GMC Envoy


Under the rear seat, drivers side.
Black box you will need to remove the cover.
Lone99star
Please rate this solution.

Feb 10, 2009 | 2006 GMC Envoy

Not finding what you are looking for?
2007 GMC Envoy SLT Logo

Related Topics:

298 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...