Question about 1999 Chrysler LHS

1 Answer

The cooling fan is rubbing and the car over heats it i um plug the fan so how can i fix the fan

Posted by on

  • ewboardmembe Aug 11, 2008

    i have to replace the fan assembly on my 2003 pt cruiser, does thr radiator come off or do i have to remove the manifolds?

×

Ad

1 Answer

The fan shroud may be warped from the heat. If it is you have to replace the fan assembly. Just replaced mine today. Fan was $200 aftermarket. Job was relatively easy after removing the bolts on the long plate that runs over the radiator. Took around 2 hrs to do. -C

Posted on Jul 31, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix cooling fans that run when car is off


Replace the fan relays. The Radiator Cooling Fan Motor Relay is located: Under hood, driver side, front side of strut tower, mounted in relay panel
Application:
High speed The Radiator Cooling Fan Motor Relay is located: Under hood, driver side, front side of strut tower, mounted in relay panel
Application:
Low speed,here's a new part.
http://www.autozone.com/cooling-heating-and-climate-control/relay-radiator-cooling-fan-motor/duralast-relay-radiator-cooling-fan-motor/plymouth/voyager-2wd/1996/6-cylinders-3-3-0l-mfi/412240_0_0

Sep 22, 2015 | 1996 Plymouth Voyager

1 Answer

The car runs hot. the only way i can help the problem is by turning on the heat in the car, and this is the only way the fans kick on. i have replaced the thermostate, radiator cap, drain and refill...


Sounds like you may have a blown head gasket. Is your coolant level low and have you had to add coolant. Still sounds like you may have a cooling fan issue or maybe even a clogged radiator. what is the temperature difference from the inlet and the oulet of the radiatoe hoses? Anything less than 20 degrees and I would say the radiator is toast and you need a new one. And fix the cooling fan issue. But still dont rule out the blown head gasket especially if it over heated...

Jul 01, 2011 | 1996 Dodge Neon

1 Answer

Over heating , replased hoses radiato , thermostat, water pump a year ago. oil looks good and good year service center cold not find problem.


if you have replaced the radiator hoses.t-stat,water pump and no water in oil then you could have a cooling fan not operating(assuming it has an electric fan),or a bad head gasket or plugged radiator that is not allowing enough coolant flow.you need to check and make sure the cooling fan is operating if not then it will have to be fixed.pressure test the cooling system and check for leaks(external) and have the system checked for gases in the coolant with a head gasket test chemical.as far as the rad being plugged it will have to be removed and flow tested.

Mar 25, 2011 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

My 1994 jeep grand cherokee is running cold my gauge reads 130 so i checked it with heat gun same thing so i changed the thermostat put in a 195 degres thermostat and i have the same problem.


um try a knew cap u should have atleast 16 pounds of pressure rent a pressure checker for radiator pump 16 pounds in it an see if ya have any leaks anywhere if electric fan does it run all the time check relay or cooling temp sensor

Dec 20, 2010 | Jeep Grand Cherokee Cars & Trucks

2 Answers

I just purchased a 92 honda prelude. the car temp for the most part was fine until u step on it a little bit then she starts to over heat. i guy told me to replace the cooling fan sensor and i did. didnt...


Is the thermostat installed correctly? There is a bleed hole on the thermostat with a rivet in it. That should be up. Is the coolant level topped off? There should be a bleed screw on the manifold if I remember correctly. Honda's are very sensitive to coolant level. Check the cooling fans to see if they are running. The left one should be for cooling and the right fan for when a/c is turned on. You can jumper the plug for the coolant temp sensor ( where the lower radiator hose attaches to the block) and the fan should run when the car is running. If all else fails, you should have your cooling system pressure tested as this could be a blown head gasket.

Aug 31, 2010 | 1992 Honda Prelude

1 Answer

2000 dodge durango cooling issue: I HAVE THE 5.2L 2WD. I have replaced the water pump, thermostat 3 times, hoses, fan clutch. To begin with ive had it tested at three places no one can figure out why...


Ihave a 2000 Dodge Durango i have put a new radiator and the gaskets came back good um i replaced the coolen fan also the thermostate and tested it it it came back good when i run it its fine but when i am in line its hot when i drive it cools down........

Aug 18, 2010 | 2000 Dodge Durango

1 Answer

The car over heats when cut it off


It is possible that your cooling fan is not working. First check that the wires going to the cooling fan motor are plugged in. If you have A/C you may have two cooling fans check both. If wires are good. With the engine cold start the car. Let the car run until the engine is hot. See if the fan comes on. If the fan does not come on the motor or the relay are probably bad.

Jul 05, 2009 | 1996 Honda Civic

2 Answers

Cooling fan cuts off


The fan relay is not functioning correctly or the new sensor is defective.

Jun 02, 2009 | 1995 Ford Mustang

1 Answer

Cooling system


1)yes steam will come out of the resevoir,especially with a bad rad'cap.
2)thermostats are cheap.
does your cooling fan come on?,it may be a bad sensor or relay (for fan)
3)no heat in car!?,the water pump may be bad.or the heater core is plugged,or if you have:a bad coolant valve for cab heat.(but this wont cause motor-over heating issues!)
4)you have a plugged radiator!

--sounds like a bad waterpump to me.
even if it doesnt leak,the impellers still come loose from the shaft!!

Dec 22, 2008 | 1998 Chrysler Concorde

2 Answers

2000 Dodge Caravan air conditioner problems


heating and cooling fans are generally one and the same. changing freon doesn't always fix the problem... did you have the system pressure checked for leaks first.

Second determine if the vents are opening properly (switching from heat to cooling) basically when you change to cool it closes air access to the heater core.

Robert

Jul 06, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
1999 Chrysler LHS Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...